2013 INFINITI M HYBRID battery

6
essential information
Direct Response Hybrid™ System Warning Light
this light will illuminate when the ignition switch is in
the ON position and will turn off when the hybrid
system is started.

the light will also illuminate when a malfunction
occurs in the electric motor or hybrid system.

when this light illuminates while driving, immediately
stop the vehicle in a safe location and contact an I nFI nIt I retailer.

If the hybrid system warning light blinks while driving, it may indicate that the Li-ion battery
charge is low and you cannot continue to drive.

do not allow the vehicle to coast when the Li-ion battery is low or when the hybrid system
warning light blinks while driving. the engine will not automatically start to charge the Li-ion
battery while the vehicle is coasting.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
Hybrid Awareness

your vehicle is virtually silent in the electric mode. If you exit your vehicle while it is ON, but the
engine is not running, the engine will automatically start, informing you that the car is still ON.

do not store your InFInItI Intelligent k ey™ within detection range of the vehicle. this may
cause welcome lights and other functions to activate creating unwanted battery drain.

the hybrid system is designed for optimum efficiency and performance. the electric mode
may vary with driving conditions and driver input. A full battery display does not indicate the
vehicle should be in the electric mode.
For more information, refer to the “Hybrid System Overview” section of your Owner’s Manual.
Loose Fuel Cap

A LOOSE FUEL CAP warning message will appear in the
dot matrix liquid crystal display

01 when the fuel-
filler cap is not tightened correctly.

to tighten, turn the cap clockwise until a single click
is heard.

the warning message will disappear when the vehicle
detects the fuel-filler cap is properly tightened and the
reset button

02 is pressed for more than 1 second.

If the cap is not properly tightened, the Malfunction
Indicator Light

may illuminate.
For more information, refer to the “Instruments and controls (section 2)” and
the
“Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
01
02

9
first drive features
INFINITI Intelligent Key™ System
the InFInItI Intelligent k ey™ system allows you to
lock or unlock your vehicle, open your trunk and start
the engine.
nO te: It is important to make sure the Intelligent k ey is
with you (that is, in your pocket or purse).

the operating range of the Intelligent k ey is within
31.5 in (80 cm) from each request switch.

to lock the vehicle, push either door handle request
switch

01 once or press the
button
02 on the keyfob.

to unlock the vehicle, perform one of the following procedures:
• Push either door handle request switch

01 once;
the corresponding
door will unlock. p ush the door handle request switch
01 again within
1 minute; all other doors will unlock, or
• Press the

button
03 on the keyfob to unlock the driver’s side door.
press the
button again; all other doors will unlock.

to open the trunk, press the button
04 for more than 1 second.

the Intelligent k ey can also be used to activate the panic alarm by pressing
and holding the

button
05 for more than 1 second. Once activated, the
panic alarm and headlights will stay on for 25 seconds.
InteLLIGent key BAtteRy dIScHARGe

If the battery of the Intelligent k ey is discharged, or
environmental conditions interfere with the Intelligent
k ey operation, start the engine according to the
following procedure:
1. Move the shift lever to the P (P ARk) position.
2. Firmly apply the foot brake.
3. touch the ignition switch with the Intelligent k ey and a chime will sound.
4. w ithin 10 seconds after the chime sounds, push the ignition switch while depressing the
brake pedal and the engine will start.
For more information, refer to the “Pre-driving checks and adjustments (section 3)”, “Starting and driving (section 5)” and
the “Maintenance and do-it yourself (section 8)” of your Owner’s Manual.
01
02
03
04
05

12
first drive features
Assist Charge Gauge
this meter displays the condition of the electric motor.

when the needle is between the center and PWR
01 ,


this indicates that the electric motor is providing
power to the drive wheels and the Li-ion battery is
discharging.

when the needle is between the center and CHG
02 ,
this indicates that the electric motor is generating
power to recharge the Li-ion battery.
For more information, refer to the “Hybrid System Overview” section and the “Instruments and controls (section 2)” of your
Owner’s Manual.
Starting/Stopping the Hybrid System

depress the brake pedal.

press the ignition switch S tAR t/S tOP button to start
the hybrid system.

the ready to drive indicator light
01 will illuminate
in the meter and you may begin driving the vehicle.
nOte: It is important to make sure the InFInItI Intelligent
key
™ is with you (that is, in your pocket or purse).
TURNING THE HYBRID SYSTEM OFF

Move the shift lever to the P (PARk) position and
apply the parking brake.

press the ignition switch S tAR t/S tOP button to
turn the hybrid system off.
eMeRGency enGIne SHut OFF
t o shut off the engine in an emergency situation while driving, perform one of the following procedures:

Rapidly push the push-button ignition switch 3 consecutive times, or

push and hold the push-button ignition switch for more than 2 seconds.
For more information, refer to the “Starting and driving (section 5)” of your Owner’s Manual.
01
02
01