2013 INFINITI G CONVERTIBLE lock

2
essential information
Loose Fuel Cap
A LOOSE FUEL CAP
warning message will appear in



the dot
matrix liquid crystal display
01 when the
fuel-filler cap is not tightened correctly.
T o tighten, turn the cap clockwise until a single click



is h
eard.
The warning message will disappear when the vehicle



detects the fuel-filler cap is properly tightened and the




reset button 02 is pressed for about 1 second.
If the cap is not properly tightened, the Malfunction




Indicator Light may illuminate.
For more information, refer to the “Instruments and controls (section 2)” and
the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
Tire Pressure Monitoring System (TPMS)
A
Ch
EC k t I r E P r ESSU r E warning message will



ap
pear in the dot matrix liquid crystal display
01
and the lo
w tire pressure warning light 02 will

i
lluminate when one or more tires are low on



pr

essure and air is needed.
• The

tire

pressures


should

be

checked

when the




tir

es are cold. The tires are considered cold after



the

vehicle has been parked for 3 hours or more or



driv

en less than 1 mile (1.6km) at moderate speeds.
Af ter tire pressures are adjusted, drive the vehicle



at
speeds above 16 MPH (25km/h). The C h EC k



t I r E P r ESSU r E warning message and low tire



pr
essure warning light will disappear.
When the lo w tire pressure warning light flashes for 1 minute and then remains on, the TPMS



i
s not functioning properly. Have the system checked by an INFINITI retailer.
Tir e pressure rises and falls depending on the heat caused by the vehicle’s operation and the



outs
ide temperature. Low outside temperature can lower the temperature of the air inside the



tir
e, which can cause a lower tire inflation pressure. This may cause the low tire pressure



w
arning light to illuminate. If the warning light illuminates in low ambient temperature, check



the tir
e pressure in your tires.
• Check


the tire pressure (including the spare tire) often and always

prior to long distance trips.
The Tire and Loading Information label contains valuable information. Please refer to section 9,



“T
echnical and consumer information”, in your Owner’s Manual for the location of the Tire and



L
oading Information label.
For more information, refer to the “Instruments and controls (section 2)”, the “Starting and driving (section 5)” and the
“Maintenance and do-it-yourself (section 8)” of your Owner’s Manual.
01
02
02
01

4
first drive features
INFINITI Intelligent Key™ System
The INFINITI Intelligent Key™ system allows you to lock or
unlock the vehicle, open the trunk and start the engine.
NOTE: It is important to make sure the Intelligent Key is
with you (that is, in your pocket or purse).
The oper ating range of the Intelligent Key is within



31.5 in (80 c
m) from each request switch.
To lock the vehicle, push either door handle request
s

witch
01 once or press the
button
02 on
the k
eyfob.
T o unlock the vehicle, perform one of the following procedures:
• Push
either door handle request

switch
01 once; the
c
orresponding door will unlock. Push the door handle



r

equest switch
01 again within 1 minute; all other
door
s will unlock, or
• Press


the
button
03 on the keyfob to unlock the driver’s

s
ide door. Press the
button again; all other doors will unlock.
T
o release the trunk lid, press the button
04 for more than
1 sec
ond. Lift the trunk lid to access the trunk.
T o retract your hard top (Convertible models), push and hold the door handle request switch
01
u
ntil the hard top is fully open.
The Int elligent Key can also be used to activate the panic alarm by pressing and holding the

b
utton 05 for more than 1 second. Once activated, the panic alarm and headlights will stay
on f
or 25 seconds.
INFINITI INTELLIGENT KEy™ BATTERy DISCHARGE
If the battery in the Intelligent Key is almost discharged,



the guide light 06 of the Intelligent Key port blinks and
the Int
elligent Key battery discharge indicator 07 is
di
splayed in the dot matrix liquid crystal display.
T o start the engine under these circumstances, insert



the Int
elligent Key into the key port with the buttons



f
acing upward and the key ring end toward you until



it
latches into place. Then push the ignition switch to



s
tart the engine.
To remove the Intelligent Key from the port, push the



ignition sw
itch to turn the engine off and then pull the



Int
elligent Key out of the port.
The Int elligent Key port does not charge the Intelligent Key battery. If you see the low battery
indic

ator
07 , replace the battery in the Intelligent Key.
For more information, refer to the “Pre-driving checks and adjustments (section 3)”, the “Starting and driving (section 5)” and the
“Maintenance and do-it yourself (section 8)” of your Owner’s Manual.
01
07
06
02
03
04
05

6
first drive features
Seat Belt Guide (Convertible models)
Un
snap the seat belt guide
01 to allow rear seat p
assengers easier access.
B efore fastening the seat belt, ensure the seat belt is



in
serted into the seat belt guide and the snaps are



sec
urely fastened.
When u sing the seat belt guide, do not allow the seat



belt
to twist so that it will retract correctly.
For more information, refer to the “Safety –– Seats, seat belts and supplemental restraint system (section 1)” of your Owner’s Manual.
Automatic Drive Positioner (if so equipped)
Two positions for the driver’s seat, steering column



and outside mirrors can be stored in the automatic




drive positioner memory.
F ollow these procedures to set the memory positions:
• Confirm
the shift

lever is

in the P (PA rk ) position



(aut
omatic transmissions) or the parking brake is applied (manual transmissions).
• Push
the ignition switch to the ON position.
• Adjust


the driver’s

seat, steering column and outside mirrors

to the desired positions

using



the a
djusting switches for each feature.
• Push
the SE
t sw
itch and within 5 seconds, push the memory switch (1 or 2) for at least 1 second.
• The
indicator light

on the memory

switch
y
ou select

will

illuminate for approximately

5 seconds.



• The driver’s

seat, steering column and outside mirror positions

are now set

to
y
our preference.
These memorized positions can also be linked to your INFINITI Intelligent Key™.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.
Passenger Rear Seat Entry/Exit
F
or ease in entering and exiting the rear passenger



ar
eas of the vehicle, perform the following steps:



1.

R
elease the front seatbelt guide and seat belt.



(C
onvertible models)



2.

P
ull the seatback lever
01 upward to fold the

fr
ont seatback forward. Make sure that the front



se

atback is completely folded.



3.


T

o slide the front seat forward, firmly push the



se

atback button
02 . The front seat will move forward.
NO

TE: To stop the front seat from sliding, press the
se

atback button
02 again.

T
o return the front seat to its original position:



1.

P
ush or pull the seatback backward until it locks in place.



2.

Pr
ess the seatback button
02 to slide the front seat backward.
For more information, refer to the “Safety –– Seats, seat belts and supplemental restraint system (section 1)” of your Owner’s Manual.
Coupe
Convertible
01
01
02
02
01

14
first drive features
Opening/Closing the Hard Top (Convertible models)
Before opening or closing the retractable hard top, refer to
your Owner ’s Manual for detailed warnings and cautions
regarding hard top operation.
NO
t
E:
t
he trunk area must be absolutely empty or it may
result in damage to the hard top.
Preparing to Lower the
h ard
top
1.


The
vehicle must be on a level surface when



oper
ating the hard top.
2.


M
ake sure that the trunk area is absolutely empty.
3.


P
ull up on the strap to open the trunk room partition.
4.


Sec
ure the partition hooks into holders until they latch.



If
the trunk room partition hooks are not latched in the



ho
lders, the hard top cannot be operated and
the C

h EC k
S
EPA r A
tO
r indicator will illuminate



on the dot
matrix liquid crystal display located



betw
een the tachometer and speedometer.
5.


Sec
urely close the trunk before operating the hard top.
h

ard t
op
Operation


1.
Mo
ve the shift lever to the P (P
A
rk) position



(aut
omatic transmission) or move the shift lever to
the N (N

EU tr AL ) position (manual transmission)



and ap
ply the parking brake.
2.


St
art the engine.
3.


Pr
ess the hard top operating switch, located on the



c
enter console, to OPEN or CLOSE and hold until the



t
op is fully positioned.
4.

The
r
OOF OPEN or r OOF CLOSED indicator will display when the hard top is fully positioned.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.

Fuel-Filler Door
The fuel-filler door is located on the passenger’s side of
the vehicle.
Unlock the fuel-filler door using one of the following



oper
ations, then push and release the left side of



the door t
o open.
•

Push the door handle request

switch while carrying




the INF
INITI Intelligent Key
™ with you.
•

Press


the

UNLOC
k
button on the Intelligent Key.
•

Push

the

power

door

lock


switch to the UNLOCK

position.
For more information, refer to the “Pre-driving checks and adjustments (section 3)” of your Owner’s Manual.