Page 188 of 635

Features of your vehicle
110
4
 Fading - As your car moves away from
the radio station, the signal will weaken 
and sound will begin to fade. When this
occurs, we suggest that you selectanother stronger station.
 Flutter/Static - Weak FM signals or large obstructions between the trans-
mitter and your radio can disturb the
signal causing static or fluttering nois-
es to occur. Reducing the treble level
may lessen this effect until the distur-
bance clears.  Station Swapping - As a FM signal
weakens, another more powerful sig-
nal near the same frequency may
begin to play. This is because your
radio is designed to lock onto the clear-
est signal. If this occurs, select anoth-er station with a stronger signal.
 Multi-Path Cancellation - Radio signals being received from several directions
can cause distortion or fluttering. This
can be caused by a direct and reflect-
ed signal from the same station, or by
signals from two stations with close
frequencies. If this occurs, selectanother station until the condition haspassed. Using a cellular phone or a two- 
way radio    When a cellular phone is used inside the 
vehicle, noise may be produced from the
audio equipment. This does not meanthat something is wrong with the audio
equipment. In such a case, use the cellu-
lar phone at a place as far as possiblefrom the audio equipment.
JBM004JBM005CAUTION
When using a communication sys-
tem such a cellular phone or a radio set inside the vehicle, a separateexternal antenna must be fitted.
When a cellular phone or a radio setis used with an internal antenna alone, it may interfere with the vehi-cle's electrical system and adverse-
ly affect safe operation of the vehi- cle.
WARNING
Don't use a cellular phone when 
you are driving. You must stop at a
safe place to use a cellular phone.
FDE ENG 4C (AUDIO).QXP  9/3/2010  4:48 PM  Page 110  
         
        
        
     
        
        Page 189 of 635

4 111
Features of your vehicle
Care of disc (if equipped) 
 If the temperature inside the car is toohigh, open the car windows for ventilation 
before using your car audio.
 It is illegal to copy and use MP3/WMA/AAC/WAVE files without 
permission. Use CDs that are created
only by lawful means.
 Do not apply volatile agents such as benzene and thinner, normal cleaners
and magnetic sprays made for ana-
logue disc onto CDs.
 To prevent the disc surface from get- ting damaged. Hold and carry CDs bythe edges or the edges of the center
hole only.
 Clean the disc surface with a piece of soft cloth before playback (wipe it fromthe center to the outside edge).
 Do not damage the disc surface or attach pieces of sticky tape or paperonto it.
 Make sure on undesirable matter other than CDs are inserted into the CD
player (Do not insert more than oneCD at a time).
 Keep CDs in their cases after use to protect them from scratches or dirt.  Depending on the type of CD-R/CD-
RW CDs, certain CDs may not operate
normally according to manufacturingcompanies or making and recording
methods. In such circumstances, if you
still continue to use those CDs, they
may cause the malfunction of your caraudio system.
✽✽ NOTICE - Playing an
Incompatible Copy-Protected 
Audio CD
Some copy protected CDs, which do not comply with the international audio CDstandards (Red Book), may not play on
your car audio. Please note that if you
try to play copy protected CDs and the
CD player does not perform correctlythe CDs maybe defective, not the CD
player.
FDE ENG 4C (AUDIO).QXP  9/3/2010  4:48 PM  Page 111 
         
        
        
     
        
        Page 190 of 635
Features of your vehicle
112
4
A-100FD
1. FM/AM Selection Button 
2. Power ON/OFF & VOLUME
3. AUTO STORE Button
4. Automatic Channel Selection Button
5. TUNE/AUDIO Control Button
6. Preset Button
7. CD/AUX Selection Button
RADIO, VOLUME CONTROL (SA710) (IF EQUIPPED)
FDE ENG 4C (AUDIO).QXP  9/3/2010  4:48 PM  Page 112  
         
        
        
     
        
        Page 191 of 635

4 113
Features of your vehicle
1. FM/AM Selection Button 
Turns to FM/AM mode and toggles FM1 and FM2➟AM ➟FM1··· when the button is
pressed each time. 
2. Power ON/OFF & Volume
Control Button
Turns the ON/OFF set when the IGNI- 
TION SWITCH is on ACC or ON. 
If the button is turned to the right, it 
increases the volume and left, decreases
the volume. 
3. AUTO STORE Button 
When the button is pressed, it automati- 
cally selects and saves channels with
high reception rate to PRESET but-
tons(1~6) and plays the channel saved inPRESET1. 
If no channel is saved after AST, it will 
play the previous channel. 4. Automatic Channel Selection
Button
 When the [SEEK ] button is pressed, it reduces the band frequency
by 5kHz to automatically select chan-
nel. Stops at the previous frequency if
no channel is found.
 When the [SEEK ] button is pressed, it increases the band fre-
quency by 5kHz to automatically select
channel. Stops at the previous fre-
quency if no channel is found.
5. TUNE/AUDIO Control Button 
Turn this button clockwise by one notch 
to increase frequency by 0.05MHz from
current frequency. 
Turn this button counterclockwise by one 
notch to decrease frequency by 0.05MHz
from current frequency. 
Turns to AUDIO CONTROL mode, and toggles in the order of BASS  ➟ 
MIDDLE
➟  TREBLE  ➟ FADER  ➟ BALANCE  ➟
AVC ON  ➟ P.BASS  ➟ BASS··· when the
button is pressed each time. 6. Preset Button 
Push [1]~[6]button less than 0.8 second 
to play the channel saved in each button. 
Push preset button for 0.8 second or 
longer to save current channel to the
respective button with a beep. 
7. CD/AUX Selection Button 
If there is a cd in the CDP DECK it turns 
to CD mode, and if a device is connected
to AUX then it toggles. CD
➟AUX ➟CD··· when the button is
pressed each time.(It will not turn to AUX 
if the auxiliary device is not connected.)
FDE ENG 4C (AUDIO).QXP  9/3/2010  4:48 PM  Page 113 
         
        
        
     
        
        Page 192 of 635
Features of your vehicle
114
4
A-100FD
1. CD Loading slot 
2. CD Eject Button
3. AUX Selection Button
4. SCAN Play Button
5. Automatic Track Selection Button
6. CD Indicator
7. REPEAT Button
8. RANDOM Play Button
CD (SA710) (IF EQUIPPED)
FDE ENG 4C (AUDIO).QXP  9/3/2010  4:49 PM  Page 114  
         
        
        
     
        
        Page 193 of 635

4 115
Features of your vehicle
1. CD loading slot 
Please face printed side upward and gently push in. 
When the ignition switch is on ACC or 
ON and power is OFF, power is automat-
ically turned on if the CD is loaded. 
This CDP supports both 8cm and 12cm 
CDs. But if VCD, Data CD, MP3 CD areloaded, "Disc-Err" message will appearand CD will be ejected. 
2. CD Eject Button 
Push  button to eject the CD during 
CD playback. 
This button is enabled when ignition 
switch is off. 
3. AUX Selection Button 
If the auxiliary device is connected, it 
turns to AUX MODE to play the sound
from the auxiliary player. 
If no Disc and auxiliary device is con- nected, it displays "NO Media" for 5 sec-
onds and returns to the previous mode. 4. SCAN Play Button 
Play first 10 seconds of each song in the 
DISC. 
To cancel the mode, press the key once again. 
5. Automatic Track  Selection
Button
 Push [SEEK ] button for less than 0.8 second to play from the beginning of current song.
 Push [SEEK ] button for less than 0.8 second and press again within 1
second to play the previous song.
 Push [SEEK ] button for 0.8 second or longer to initiate reverse directionhigh speed sound search of currentsong.
 Push [SEEK ] button for less than 0.8 second to play the next song.
 Push [SEEK ] button for less than 0.8 second or longer to initiate highspeed sound search of current song. 6. CD Indicator 
When car ignition switch is ACC or ON and if the CD is loaded, this indicator islighted. 
If the CD is ejected the light is turned off. 
7. REPEAT Button 
Repeats current song when the button is 
pressed for less than 0.8 second. 
Repeats the entire DISC when the button 
is pressed for 0.8 second or longer. 
8. RANDOM Play Button 
Turns ON/OFF the randomization of the 
play list of files in the currently played
DISC. 
To cancel the mode, press the key once again.
FDE ENG 4C (AUDIO).QXP  9/3/2010  4:49 PM  Page 115 
         
        
        
     
        
        Page 194 of 635
Features of your vehicle
116
4
A-200FDE
1. FM Selection Button 
2. AM Selection Button
3. TA Selection Button
4. CD/AUX Selection Button
5. Automatic Channel Selection Button
6. Power ON/OFF
7. AUTO STORE Button
8. Screen ON/ OFF Button
9. Information Display Button
10. SET UP Button
11. TUNE/ENTER Button
12. PTY(FLDR) Button
13. Preset Button
RADIO, SET UP, VOLUME CONTROL (PA710R) (IF EQUIPPED)
FDE ENG 4C (AUDIO).QXP  9/3/2010  4:49 PM  Page 116  
         
        
        
     
        
        Page 195 of 635

4 117
Features of your vehicle
1. FM Selection Button 
Turns to FM mode and toggles in the order of FM1➟FM2 ➟FMA ➟FM1··· when
the button is pressed each time. 
2. AM Selection Button 
Turns to AM mode, and toggles AM and 
AMA when the button is pressed each
time. 
3. TA Selection Button 
In FM, CD, AUX mode, turns on/off the 
reception of TA channels of RDS. 
4. CD/AUX Selection Button 
If there is a cd in the CDP DECK it turns 
to CD mode, and if a device is connected
to AUX then it toggles. CD ➟
AUX ➟CD··· when the button is
pressed each time.(It will not turn to AUX 
if the auxiliary device is not connected.) 5. Automatic Channel Selection
Button
 When the [SEEK ]button is pressed, it reduces the band frequency by 50khz to automatically select channel.
Stops at the previous frequency if no
channel is found.
 When the [SEEK ]button is pressed, it increases the band frequency by50khz to automatically select channel.
Stops at the previous frequency if no
channel is found.
6. Power ON/OFF & Volume Control Button
 Turns on/off the set when the IGNI- TION SWITCH is on ACC or ON. If the 
button is turned to the right, it increas-
es the volume and left, decreases the
volume.
 In AUX mode, the volume and tone (BASS, MID, TRE) are adjusted in a 
separate way. 
If you pull out AUX from a jack and 
insert it again, then only volume goes
back to 10-step. 7. AUTO STORE Button 
 When you press the [AST] button, the
mode changes to ‘Auto store Band’ and 
it saves the result. (FM1 or FM2 changes to FMA, AM changes to AMA.)
 When the button is pressed, it auto- matically selects and saves channels 
with high reception rate to PRESET
buttons (1~6) and plays the channel
saved in PRESET1. 
If no channel is saved after AST, it will 
play the previous channel.
8. Screen ON/ OFF Button 
Turns off/on the displayed data and light 
on LCD. 
The screen and light will be turned on by 
pressing any button except DARK button
when the screen is turned off. 
9. Information Display Button 
Displays the information of the channel 
currently played by RDS.
FDE ENG 4C (AUDIO).QXP  9/3/2010  4:49 PM  Page 117