45
INST\fU\bENT PANEL INDICATO\fS\friefly appear with each engine start. Red and amber indicators are most critical. \flue
and green indicators are used for general information. See your Owner’s Manual for
more information.
\balfunction IndicatorsIf an indicator remains on, there may be a problem; see your dealer
On/Off Indicators
Condition IndicatorsAction is needed by driver
PASSENGER AIR\fAG \f\b\b(located on center panel)
SIDE AIR\fAG \f\b\b
CRUISE CONTROL on
ECOFuel economy on
Fog lights on*
Headlights on
Turn signals/hazards on
High beams on
*if eq\bipped
Charging system
Low brake fluid, \frake system
Low oil pressure
A\fS (anti lock brake system)
VTM \b (\bWD only)
Malfunction lamp (check engine light)
VSA®(vehicle stability assist)SRS (supplemental restraint system)
DRL(daytime running lights)
Power tailgate* TPMS
(tire pressure monitoring system)
Parking brake on:
Release
Door/Tailgate open:
Close door(s) / tailg\Pate
Seat belt reminder:
\basten seat belt(s) Maintenance Minder:
Make dealer appointment
A/T temperature (\bWD only):
Pull over and let engine id\Ple
Starter system: Hold ignition
switch in START (III) for
up to 15 seconds
Low fuel:
Refill
Low tire pressure:
Add air Immobilizer
(blinks):
Use correct key
CRUISE MAIN on VSA \f\b\b
13 Pilot TRG_LE EX E\AXL EXLRES_ATG_NEW S\ATYLE 8/8/2012 3\f11\A PM Page 4
9\b
H O M E L I N K® ( i f e q u i p p e d )
Program your vehicle to operate up to three remote controlled devices around your
home, such as garage doors, lighting, or home security systems.
Press and hold the button on the
remote and the HomeLink button at the same time. Th en, while
continuing to hold the HomeLink button, press and release the button
on the remote every 2 seconds.
Does the LED blink at a faster rate within 20
seconds?
Press and hold
the HomeLink
button again. Training
complete
YES
NO
HomeLink indicator
flashes for 2 seconds,
then remains on. HomeLink LED
remains on.YES
NO YES
NO
Position the remote transmitter you
wish to link 1–3 inches from the
HomeLink button you want to program.1
Press and hold the desired
HomeLink button and the button on
the remote transmitter.
Does the HomeLink indicator (LED) blink at a
faster rate after about 10 seconds?
2
a
The remote has a rolling code.
Press the “learn” button on the
remote-controlled device (e.g.,
garage door opener).
Press the programmed HomeLink
button again; the remote-controlled
device should operate. Within 30 seconds, press and
hold the programmed HomeLink
button for 2 seconds.a
Press and hold the programmed
HomeLink button for about a
second.
Does the device (garage door opener) work?
3
b
4
5
Training a Button
If you have any problems programming HomeLink, see the owner’s manual included
with the device you are trying to program, call HomeLink at (800) \f55 \f5\415, or
visit www.homelink.com.
How It Works
Press and hold RETURN for
about \f seconds.
R E A R V I E W C A M E R A
For added convenience, the area behind your vehicle is displayed to help you navigate
while backing up.
Turning the Guide Lines On or Off
• When you shift into Reverse (R), a real
time image of the area behind your vehicle
is shown in the center display.
• Yellow parking guide lines also appear to help you judge distance.
• The rearview display turns off when you shift out of Reverse.
13 Pilot TRG_LE EX E\AXL EXLRES_ATG_NEW S\ATYLE 8/1/2012 3\f5\A7 PM Page \b
