2013 FORD SUPER DUTY mirror

1514*iF eQuiPPeD
*iF eQuiPPeD
Mykey ®
MyKey allows you to program certain driving restrictions in order to promote good
driving habits. You can program things such as speed restrictions, limited volume
levels. For complete information, refer to the MyKey chapter in your Owner’s Manual.
MeMORy FeA tuRe *
The memory function allows a “one touch” recall of personalized memory features
(i.e., the positions of the driver seat, power mirrors and power-adjustable foot
pedals). Use the memory controls, located on the side of the driver’s seat
,
to program and then recall memory positions.
To program position 1, press and hold the 1 button
until you hear a chime. Use
this same procedure to set the second position using the 2 button . You can now
use these controls to recall the set memory positions.
ReMO te entR y S yS teM WitH ReMO te StAR t*
PrESS oNCE
to unlock the driver’s door.
PrESS
twiCE
to unlock the passenger
and rear doors.
PrESS
oNCE
to lock all the doors.
PrESS
twiCE
to confirm all the doors are
closed and locked.
PrESS

to activate the panic alarm.
PrESS
AgA iN or
turn the ignition on to
deactivate the panic alarm.
C Ar fiNdEr:
PrESS
twiCE within three seconds. The horn will chirp and the turn lamps will
flash. It is recommended to use this method to locate your vehicle, rather than
using the panic alarm.
rEMotE St Art:
PrESS
to lock all the doors.
PrESS
twiCE. The exterior lamps will flash twice. The horn will chirp if the
system fails to start.
MOOnROOF*
Your moonroof is equipped
with a one-touch, express
opening and closing feature.
To open, press and release
the SLIDE control, the
sunscreen will open. To
fully open the moonroof,
press and release the SLIDE
control again. To close,
pull and release the SLIDE
control. Press and release
the TILT control to vent the
moonroof. Pull and hold
the TILT control to close the
moonroof. The sliding shade
can be manually opened or
closed when the moonroof
is closed. Pull the shade
toward the front of the vehicle to close it.
HeA teD ReAR SeA tS*
The rear seat heat controls are located on the rear
door armrest. To operate the heated seats, push the
indicated side of the control for maximum or minimum
heat. Push again to deactivate.






ADJuS tABLe HeAD ReS tRAintS
The front head restraints
can be adjusted to suit
your needs. Simply pull
up to raise the head
restraint. To lower, press
the head restraint down
while pressing and holding
the guide sleeve adjust/
release button. You may
also be able to tilt the
head restraint forward or
backward for additional
comfort. Pivot the head
restraint forward to the
desired location. After the
head restraint reaches the
forward-most tilt position,
pivot it forward again to
return it to the standard position.
CenteR COnSOLe*
Your vehicle may be equipped with a variety of console features. These include:
• Locking storage compartment with hanging file folder supports and room for
a laptop computer, binder or book; removable false bottom tray for accessing
hidden storage compartment; and storage on the passenger side of the
console bin.
• One 12-volt power point inside the storage compartment and one on the rear of the
console; and a 110-volt AC power point outlet on the rear of the console.
comfort & convenience

*if equipped*iF eQuiPPeD18
ADVAnCetRAC®
WitH ROLL
StABiLity
COntROL™ (RSC®)
S tABiLity
enHAnCeMent
S yS teM*
The AdvanceTrac® stability
system helps you to maintain
stability and steer-ability of
your vehicle during a variety
of road conditions. If your
vehicle becomes stuck in
the snow, mud or sand,
try turning off the AdvanceTrac
® system to allow wheel spin and help increase
momentum to dig the vehicle out. Press the control to turn the system off. Refer to
your Stability Control chapter in your Owner’s Manual for more details.
eLeCtROniC LOCkinG DiFFeRentiAL (eLD)*With the ELD engaged, the rear axle temporarily locks, allowing both rear
wheels to turn at the same speed. The function helps to provide additional
traction as needed.
tO ACtiVA te:
• In 4x4 vehicles, pull the 4WD control knob toward you.
• In 4x2 vehicles and vehicles equipped with a manual shift 4WD system,
turn the ELD control knob from OFF to ON.
• The indicator light
will be continuously displayed in the cluster when
the ELD is active.
Note: ELD should not be used on dry surfaces.
ReAR VieW
C AMeRA SySteM*
Located under the Ford oval badge on
the tailgate, this camera provides a
visual display of the area behind the
vehicle. The display will automatically
appear in the navigation system
screen* or in the auto dimming
rearview mirror whenever the vehicle is
in R (Reverse) and uses colors (green,
yellow and red) to alert you of your
proximity to objects. If equipped with
the navigation system, you can also
press Zoom to zoom in or out.
Note: Visibility aids do not replace
the need to watch where the vehicle is
moving. Refer to your Owner’s Manual
for safety information, more detail and limitations.
One- tOuCH uP OR DOWn (FROnt WinDOWS )
This feature automatically opens or closes the window. Press or lift the switch
completely and release. The window will fully open or close. Press or lift it again to
stop the window.
Note: The window may be disabled for up to five minutes if it is cycled up and down
repeatedly. This helps prevent damage to the motor. Normal operation will resume
once the motor cools.
function
ReVeRSe SenSinG Sy SteM*
The sensing system, only active when the transmission is in R
(Reverse), warns the driver of obstacles within a certain range of
the rear bumper area. It sounds a warning tone if there is an object
behind the vehicle. The tone will sound continuously when the
object is less than 12 inches (30 centimeters) away. The system is
not effective when the vehicle is traveling above 3 mph (5 km/h)
and may not detect angular or moving objects.
Note: Visibility aids do not replace the need to watch where
the vehicle is moving. Refer to your Owner’s Manual for safety
information, more detail and limitations.
19*iF e QuiPPeD