2013 FORD FIESTA display

INStrumENt PaNEl5
1. Media Steering
Wheel ControlS*

(Volume): Press to increase (+)
or decrease (-) volume levels.
Press to access voice recognition.
Press to answer an
incoming call.

Press to exit phone mode or
end a call.
Press OK to confirm messages
and selections.
2. tilt/teleSC ope
Steering Colu Mn
Unlock the steering wheel by
pulling the lever down. Adjust the wheel to the desired position. Push the lever back up to lock the steering wheel in place.
3. ServiCe engine Soon light
Illuminates briefly when
the ignition is turned on. If it remains on or is blinking after the engine is started, the on-board diagnostics system (OBD-II) has detected a malfunction. Drive in a
moderate fashion and contact your
authorized dealer as soon as possible.
4. inforMation diSplayS
Provides information about various
systems on your vehicle. Use the trip
computer lever, on the left-hand side of
the steering wheel to scroll through and
choose trip computer functions. Refer to
the Information Displays chapter of your
Owner’s Manual for more information.
5. CruiSe Control*
To set your cruise control speed:
1. Press the ON control and release.
2. Accelerate to the desired speed.
3. Press the SET + control and
release, then take your foot off
the accelerator.
After your speed has been set, you
can press SET +/ SET - to adjust your
cruise speed. To disable, press the
OFF control.
6. Wiper ControlS
Pull the stalk down for a single wipe.
Raise the stalk upward for intermittent
wipe mode. Adjust the intermittent

wipe intervals by using the rotary
control on the stalk. To spray and wash
the windshield, press the end of the
wiper stalk in, the wipers will operate for
a short time after. To operate the rear
wipers pull the stalk toward you.
7. puSh Button Start*
Allows you to start your vehicle by
pressing the ENGINE START/STOP
button while fully pressing down on the
brake pedal. Press the button again to
turn the engine off.
NOTE: Your intelligent access key*
must be inside the vehicle for keyless
starting to work.
8. infotainMent Center
Use your center stack controls to
interact with SYNC* as well as your
audio and vehicle settings. SYNC and
entertainment messages as well as your
settings will appear in the infotainment
screen. Press OK to confirm messages.
9. l oCk/unloCk Button
Lights up when all doors and trunk are
locked. When the button remains unlit,
one or more doors are unlocked.
* if equipped
1
2
3
5
6
8
9
7
4

SYNC®
7SYNC®*
pairing your phone With SynC
In order to use many of the features of
SYNC, such as making a phone call,
receiving a text or using SYNC services,
you must first connect or pair your phone
with SYNC.

TO PAIR y OuR PhONE
FOR ThE FIRST TImE:
1. Make sure that your vehicle is in (P)
park and your ignition and
radio are turned on.
2. Press the phone button, when the
display indicates No Phone Found
press OK.
3. When Add Bluetooth Device?
appears in the display press OK.
4. When Find SYNC appears in the
display press OK. When prompted
on your phones display, enter the PIN
provided by SYNC into your phone.
5. The display will indicate when the
pairing is successful.getting Started
With your SynC® SySteM
SYNC is a hands-free, voice recognition system used
for entertainment, information and communication.
SYNC….Say the word.

BEFORE y Ou GET STARTEd:
1. Set up your owner account at syncmyride.com. Register by
following the on-screen instructions. After registering you can see
what complimentary services you are eligible for.
2. SYNC uses a wireless connection called Bluetooth
®to
communicate with your phone. Turn Bluetooth mode on in your
phone’s menu options. This lets your phone find SYNC. If you
need more details on setting up your phone with SYNC, visit
syncmyride.com, or your phone manufacturer’s website.
*If equipped.
NOTE: The system may prompt you to:
• set your phone as the primary/favorite
(the primary phone will receive
messages and voice mails).
• download your phone book
(this is recommended to use
voice commands).
• turn on 911 Assist
®.

TIPS:
• To pair subsequent phones, please
refer to Pairing Subsequent Phones
in the SYNC chapter of your
Owner’s Manual.
• If you are experiencing pairing
problems, try performing a clean
pairing by deleting your services
from SYNC and deleting the SYNC
connection from your phone, and then
repeat the process.
• Make sure that there are no security
features active on your phone
preventing you from connecting
to SYNC.


CoMMonly uSed
voiCe CoMMandS–
SynC Say the Word
Every time you want to give SYNC a voice
command you must first press the voice
button
and when prompted, speak
your voice command. For a list of voice
commands say What can I say?

TIPS:
• Make sure the interior of the vehicle is
as quiet as possible.
• After pressing the voice button,
wait until after the tone sounds and
Listening appears in your vehicle’s
display before saying a command.
Any command spoken prior to this
does not register with the system.
• Speak naturally, without long pauses
between words.
• At any time, you can interrupt the
system while it is speaking by pressing
the voice button.

hElP!
At any time, you can give the voice
command Help. The system will provide
an audible list of voice commands
available in your current mode.
uSing My phone With SynC
NOTE: You must download your phone
book to make phone calls with voice
commands by name. Contacts listed in
all caps will require you to spell them
(i.e. JAKE, will be J-A-K-E).
mAKING A PhONE c All:
Use SYNC to make a phone call to
anyone in your phone book by pressing
the voice button
and when
prompted, say any of the following voice
commands:
Call
Call at work
Call on mobile or cell
Call at home
For example, you could say Call Mom at
home. SYNC repeats the command back
to you and dials the number.

NOTE: You can also make phone calls
by giving the voice command Dial, then
verbally say the phone number.

SYNC®*
9
ANSwERING INc OmING cAllS:
Whenever you have an incoming call, you
will be able to see the name and number
of the person calling in your display.
Press the phone button
to answer
an incoming call. You can hang up at any
time by pressing and holding the phone
button
.

dO NOT dISTuRB mOdE:
This feature blocks incoming calls and
text messages and saves them for later.
You still have access to outgoing calls
when this feature is active. Say the voice
command, Do not disturb on to enable
and Do not disturb off to disable.


uSing SynC to
aCCeSS digital Media
SYNC has a media hub with multiple
inputs allowing you to access personal
media from your digital devices.
uSING v OIcE cOmmANd S
TO PlA y muSIc:
1. Plug your media player into your
USB port.
2. Press the voice button
. When
prompted say USB , then follow-up
saying one of the following voice
commands:
Play all
Play next song
Play song
Play album
3. You will hear the command
repeated back to you and the
selected item will play.
do More
After creating your account at
syncmyride.com, use SYNC Services
to get the most out of your SYNC
experience. This includes; voice activated
turn-by-turn directions, the latest traffic
reports, business searches, sports scores,
stock market reports and more.
You can access your available services by
pressing the voice button
and when
prompted, say Services. The portal will
guide you, but you can say any of the
following voice commands:
Tr a ffi c
Sports
Directions
Weather
News
Business search
* Say What can I say? to hear a list of
more voice commands available in
this mode.
Your SYNC system also offers
advanced features such as internet
connectivity, SYNC AppLink™ and
vehicle health report all available at
syncmyride.com.
SYNC® a ppl ink
NOTE: You can choose from a privacy
mode (can listen and talk only by
phone) or open mode (listen/talk
by the vehicle) via the display.
SYNC applink: Voice Access to your Mobile Apps
The available SYNC AppLink allows you voice
access to select mobile applications that you
already have or can download to your Android
TM
BlackBerry® or iPhone®.
Current apps available include Pandora
® Internet
Radio, Stitcher Smart RadioTM, OpenBeak
(BlackBerry-exclusive), IHeartRadio, Slacker,
NPR News and SYNC Destinations with even
more releases on the way. See SyncMyRide.com
for more details.
using SYNC applink
1. Make sure that you have an active account
created online for the app you want and make
sure you have it set up the way you like it. Some
apps just work automatically with no set-up. 2.
Download or update to the latest mobile
app through your smartphone’s marketplace.
3. Turn on your ignition.
4. Pair the phone to your vehicle. If your phone
is already paired to the vehicle, it connects
automatically when you enter.
5. If you’re an iPhone owner, you must also
connect the Apple-provided USB cable and
start the application you want to use on your
iPhone to access the apps through SYNC.
Android and BlackBerry connect wirelessly
using SYNC AppLink.
6. Now you’re ready to voice-access the app by
pressing the voice button and saying “mobile
apps” and then the name of the app you want.