2013 FORD EXPEDITION mirror

CONVENIENCE

mykey®
MyKey allows you to program certain
driving restrictions in order to promote
good driving habits. You can program
things such as speed restrictions and
limited volume levels. For complete
information, refer to the MyKey chapter in
your Owner’s Manual.
inTegraTed keyHead TranSmiTTer
Press once to lock all doors. Press
again to confirm all doors are closed.
• Press
once to unlock the driver’s
door. Press again within three seconds
to unlock all doors.
• Press
to activate the panic alarm.
Press again or turn the ignition on
to deactivate.
• Press
twice within three seconds to
open the liftgate.
• Car finder: Press
twice within
three seconds to locate your vehicle.
The horn will chirp and the turn lamps
will flash.


Securicode™ keyLeSS
enTry SySTem
Lock or unlock the doors, or release the
liftgate glass without using a key. The
keypad can be operated with the factory-
set, 5-digit entry code; this code is located
on the owner’s wallet card in the glove
box. You can also create up to five of your
own 5-digit personal entry codes.
To lock all of the doors and liftgate:
press and hold 7•8 and 9•0 at the same
time. For complete information, refer to
the SecuriCode Keyless Entry section in
the Locks chapter of your Owner’s Manual.
rain-SenSing wiPerS*
If activated, your wipers will automatically
turn on when moisture is present on
the windshield. The wiper speed will
vary based on the amount of moisture
detected and the sensitivity setting. To
deactivate, turn your wiper controls off.
Note: Make sure that this feature is turned
off before entering a car wash.
memory fea Ture*
The memory function allows a “one
touch” recall of personalized memory
features (i.e. the positions of the driver
seat, power mirrors and power-adjustable
foot pedals). Use the memory controls
located on the side of the driver’s seat
to program and then recall
memory positions.
To program position 1, press and hold the
1 button
until you hear a chime.
Use this same procedure to set the
second position using the 2 button
.
You can now use these controls to recall
the set memory positions.
SoS PoST -craSH aLerT SySTem™
The SOS Post-Crash Alert System™
provides audible and visual alarms in
the event of a crash. The turn signals
will flash and the horn will sound. To
deactivate the system, press the hazard
flasher control, or you can press on your
remote transmitter.
COMFORT
SeaTing-To-cargo VerSa TiLiTy
Note: Before folding the second- or third-row
seats, ensure that the head restraints are fully
flipped down by pulling on the strap, and that
all items have been removed from the floor
and seats.
To foLd THe fLa T-foLding THird-row
Sea TS down:
1. Lift Lever 1 located on the outboard side of
the seat.
2. Pull Lever 2 to release the seat into the
kneel-down, floor position.
3. Move the seat forward and down.
Note: A moderate force may be required to
move the seat forward and down.

t o return them to a seating position:
1. Lift and pull the seat rearward until the latch
is fully engaged.
2. Lift up on the seat back until a click is heard.
This click signals that the seat has locked
into its upright position.
3. Lift up on the head restraint until it locks into
its original position.

Pull Strap
Lever 1
Lever 2
e-Z enTry inTo THe
THird-row Sea TS
The E-Z entry seat allows for easier
entry and exit to and from the third-
row seat.
to enter the third-row seating area:
1. Fold the head restraint forward.
2. Pull up on Lever 1.
3. Fold down the second-row seat
and release the handle.
4. Pull the handle up again until the
seat releases from the floor.
5. Push the seat upward and fold it
away from the third row.
t o return the seat to a
seating position:
1. Push the seat down and latch
to the floor.
2. Bring the seat back to an upright
position. It should lock into position.
3. Lift up on the head restraint until it
locks into its original position.

Lever 1
Pos. 2
Pos. 3
page 11 page 10* if equipped

naViga Tion SySTem*
set your destination by using your touch
screen or voice commands. t o program a
destination using the touch screen:
1. Press the dest button and “accept” when
the “t erms of Use” screen appears.
2. Select from the following:
a. Quick: allows you to cancel the route,
access emergency destinations (such as
police stations or hospitals), save your
favorite destinations to presets for quick
access, find the nearest point of interest
(POI), and recall a previous destination
or entry from your address book to set
as a current destination.
b. s tandard: allows you to set a
destination using any of the following:
i. Address Book
ii. Previous Destination
iii. Phone Number
iv. Map
v. Street Address
vi. POI
vii. Freeway Exit/Entrance or
Intersection
FUNCTION
page 15 page 14
c. edit Route: allows you to make any adjustments to
the currently selected navigation route such as:
i. Cancel
ii. Detour
iii. View Route
iv. Edit Route Preferences
v. Edit Traffic Preferences
vi. Edit Destination/Way Points
vii. Edit Turn List
Note: Periodic map updates are available at an additional cost.
Call 1-800-NAVMAPS (in Mexico, call 01–800–557–5539)
or visit www.navigation.com/ford.
Note: Visibility aids do not replace the need to watch where the vehicle is moving.
Refer to your Owner’s Manual for safety information, more detail and limitations.
* if equipped
rearView camera*
The rearview camera system is located on the liftgate
and provides a visual display of the area behind the
vehicle. The display will automatically appear on the
navigation system screen (if equipped) or in the
rearview mirror whenever the vehicle is in R (Reverse)
and uses colors (green, yellow and red) to alert you
of your proximity to objects.
forward and reVerSe SenSing SySTemS*
If your vehicle is equipped with forward and reverse sensing systems which may warn you
if there is an object in front of or behind the vehicle. The system will sound a warning tone
that increases in frequency as the object gets closer and will sound continuously when the
object is less than 10 inches away.
uniVerSaL garage door oPener*
Your driver’s side visor has a built-in wireless transmitter that replaces the common hand-
held garage door opener. This system can also be programmed to security systems, entry
gates and home or office lighting. Refer to the Universal Garage Door Opener chapter in
your Owner’s Manual for programming instructions.