Page 350 of 497

Removing the jack and tools
1. Open the liftgate, then locate the
access panel on the floor behind the
3rd row seat. Unlatch and remove
the panel.
2. Remove the jack and tools assembly tray from the compartment by
turning the wing-nut counterclockwise to relieve tension against the jack
assembly tray. Remove the bag from the jack and tool assembly tray by
loosening the strap.
Note:Pay close attention to the orientation of the bag, because it will
have to be reinstalled after changing the tire.
3. Unsnap the wheel lug nut wrench, jack extension and handle from the
plastic tray.
4. Remove the jack from the tray assembly.
Removing the spare tire
1. Remove the jack handle and
winch extension from the tray and
assemble them.
2. Open the spare tire winch access
plug in the bottom of the
compartment for the jack and tools
tray.
3. Insert the winch extension tool
assembly through the access hole in
the floor and engage the winch.
350Wheels and Tires
2013 Expedition(exd)
Owners Guide gf, 1st Printing
USA(fus)
Page 351 of 497

4. To remove the spare tire, turn the handle counterclockwise until the
tire is lowered to the ground and the cable is slightly slack.
5. Slide the retainer through the center of the spare tire wheel.
6. Block the wheels (both front or
both rear) on the opposite end of
the vehicle from the wheel being
changed. If on a grade, block both
wheels on the downward side of the
hill.
7. Turn off the air suspension system (if equipped). Also, turn off the
deployable running boards (if equipped). See theDriving Aidschapter.
8. Obtain the spare tire and jack tools from their storage locations.
9. Use the tip of the jack handle to remove any wheel trim.
10. Loosen each wheel lug nut one-half turn counterclockwise but do not
remove them until the wheel is raised off the ground.
11. Position the jack according to
the jack locator arrows found on the
frame and turn the jack handle and
extension tool assembly clockwise.
Note:Use the frame rail as the
jacking location point, NOT the
control arm.
Wheels and Tires351
2013 Expedition(exd)
Owners Guide gf, 1st Printing
USA(fus)
Page 352 of 497
12. Raise the vehicle to provide sufficient ground clearance when
installing the spare tire; approximately 1/4 inch (6 mm).
•Front
•Rear
•Jack at the specified locations to avoid damage to the vehicle.
13. Remove the lug nuts with the lug wrench.
14. Replace the flat tire with the spare tire, making sure the valve stem
is facing outward.
15. Reinstall the lug nuts until the wheel is snug against the hub. Do not
fully tighten the lug nuts until the wheel has been lowered.
16. Lower the wheel by turning the jack handle counterclockwise.
17. Remove the jack and fully
tighten the lug nuts in the order
shown and reinstall the wheel cover.
SeeWheel Lug Nut Torque
Specificationslater in this chapter
for the proper lug nut torque
specification.
1
3
54
6
2
352Wheels and Tires
2013 Expedition(exd)
Owners Guide gf, 1st Printing
USA(fus)
Page 353 of 497

18. Unblock the wheels.
19. Put flat tire, jack, lug wrench and tools away. Make sure the jack bag
is properly reinstalled around the jack and tools assembly tray with the
strap securely fastened. Be sure to tighten the wing nut sufficiently so it
does not rattle when you drive.
20. Turn on the air suspension system.
Stowing the Spare Tire
1. Lay the tire on the ground, near the rear of the vehicle, with the valve
stem side facing up.
2. Slide the wheel partially under
the vehicle and install the retainer
through the wheel center. If
equipped, you may have to remove
the wheel center cap prior to
pushing the retainer through the
center of the wheel. To remove the
center cap, press it off with the jack
tool from the inner side of the
wheel. Pull on the cable to align the
components at the end of the cable.
3. Assemble the jack handle and winch extension (as shown in
illustration), then insert the winch extension through the access hole
behind the 3rd row seat and engage the winch.
4. Turn the jack handle clockwise until the tire is raised to its stowed
position underneath the vehicle. The wrench will become harder to turn
and the spare tire winch will ratchet or slip when the tire is raised to
maximum tightness. A clicking sound will be heard from the winch
indicating that the tire is properly stowed.
5. Disassemble the jack tool and winch extension and snap them back
into the tool tray.
6. Reinstall the jack bag properly around the jack and tool assembly tray,
making sure the strap is securely fastened.
7. Close the access hole with the rubber plug.
8. Reinstall the tray into the vehicle and secure it with the wing nut
(turn clockwise until tight).
Wheels and Tires353
2013 Expedition(exd)
Owners Guide gf, 1st Printing
USA(fus)
Page 496 of 497

Side-curtain airbags system .......48
SIRIUSsatellite radio .....448, 464
SIRIUS satellite radio voice
commands .................................450
SIRIUS Travel Link ...................460
Snowplowing ...............................15
SOS Post Crash Alert .................45
Spark plugs,
specifications .....................355, 360
Special notice
ambulance conversions ............15
Specification chart,
lubricants ...................................356
Stability system .........................229
Starting a flex fuel vehicle .......196
Starting your vehicle ........195–196
jump starting ..........................270
Status bars ................................434
Steering wheel ............................77
controls ......................................77
tilting .........................................77
Supplemental Restraint System
(SRS) (see airbags) ....................45
SYNCAppLink™ ....................411
SYNCcustomer support .........386
SYNCServices .........................409
System overview .......................431
T
Temperature control
(see Climate control) ..............146,
148, 150, 152
Text messaging .........................397Text messaging (sending,
downloading, deleting) .....397, 399
Third-row power fold seat .......177
Tilt steering wheel ......................77
Tires ...........................326–327, 346
alignment ................................340
care ..........................................326
changing ..........................346, 348
checking the pressure ............336
inflating ...................................334
label .........................................333
replacing ..................................338
rotating ....................................340
safety practices .......................339
sidewall information ...............329
snow tires and chains ............341
spare tire .................................346
terminology .............................327
tire grades ...............................327
treadwear ........................326, 336
Towing .......................251, 262–263
recreational towing .................263
Trailer Brake
Controller-Integrated ..............256
trailer towing ..........................251
wrecker ....................................262
Traction control ........................227
Traffic, Directions and
Information ................................409
Trailer Brake
Controller-Integrated ................256
Trailer sway control ..................251
Transmission
brake-shift interlock
(BSI) ................................213–214
fluid, checking and adding
(automatic) .............................298
fluid, refill capacities ..............356
lubricant specifications ..........356
496Index
2013 Expedition(exd)
Owners Guide gf, 1st Printing
USA(fus)
Page:
< prev 1-8 9-16 17-24