2013 FIAT 500E heater

HEATED SEATS
Front Heated Seats
•The controls for the front heated seats
are located on the center instrument
panel area.
• Press the switch once to turn on the
heated seat. Press the switch a second
time to turn off the heated seat.
WARNING!
• Persons who are unable to feel pain to the skin because of advanced age, chronic
illness, diabetes, spinal cord injury, medication, alcohol use, exhaustion or other physi-
cal conditions must exercise care when using the seat heater .It may cause burns
even at low temperatures, especially if used for long periods of time .
• Do not place anything on the seat that insulates against heat, such as a blanket or
cushion. This may cause the seat heater to overheat. Sitting in a seat that has been
overheated could cause serious burns due to the increased surface temperature of
the seat.
GETTING STARTED
27

JUMP-STARTING PROCEDURE — 12 VOLT BATTERY
•If your vehicle has a discharged 12 Volt battery, it can be jump-started using a set of
jumper cables and a battery in another vehicle or by using a portable battery booster
pack .Jump-starting can be dangerous if done improperly so please follow the procedures
in this section carefully .
NOTE:
When using a portable battery booster pack, follow the manufacturer’s operating
instructions and precautions.
Preparations For Jump-Start
• The battery in your vehicle is located in the underhood compartment under the beauty
cover .
1. Set the parking brake, place the transmission into PARK and turn the ignition to
OFF/LOCK.
2. Turn off the heater, radio, and all unnecessary electrical accessories.
3. If using another vehicle to jump-start the battery, park the vehicle within the jumper
cables reach, set the parking brake and make sure the ignition is OFF .
Jump-Starting Procedure
1.Connect the positive (+)end of the jumper cable to the positive (+)post of the dis-
charged vehicle .
2. Connect the opposite end of the positive (+)jumper cable to the positive (+)post of
the booster battery .
3. Connect the negative end (-)of the jumper cable to the negative (-)post of the booster
battery .
4. Connect the opposite end of the negative (-)jumper cable to a good ground (exposed
metal part of the discharged vehicle) away from the battery and the high voltage cables.
5. Start the engine in the vehicle that has the booster battery, let the engine idle a few
minutes, and then start the the vehicle with the discharged battery .
• Once the vehicle has started, remove the jumper cables in the reverse sequence:
1. Disconnect the negative (-)jumper cable from the ground (-)of the vehicle with the
discharged battery .
2. Disconnect the negative end (-)of the jumper cable from the negative (-)post of the
booster battery .
WHAT TO DO IN EMERGENCIES
60

Power Distribution Center #1
•The Power Distribution Center #1 is located on the right side of the underhood
compartment. To access the fuses, remove locking screw and slide cover off.
• The ID number of the electrical component corresponding to each fuse can be found on
thebackofthecover .
Cavity Maxi Fuse Mini Fuse Description
F01 60 Amp BlueBody Control Module (BCM)
F02 20 Amp Yellow HiFi Amplifier
F03 20 Amp Yellow Ignition Switch
F04 40 Amp Orange Brake System Module Pump
F05 70 Amp Tan Electric Power Steering (EPS)
F06 60 Amp Blue Radiator Fan
F07 40 Amp Orange Regen Brake Module
F08 40 Amp Orange HVAC
F09 5 Amp TanAir Electric Heater
Charge Indicator
F10 10 Amp Red Horn
F11 10 Amp Red
Electronic Vehicle Control Unit (EVCU)
F145 Amp Tan High beam (Shutter)
F15 15 Amp Blue Cigar Lighter
F16 10 Amp RedHumidity Sensor
VPAM
AC Compressor
F18 5 Amp Tan
Electronic Vehicle Control Unit (EVCU)
F1910 Amp Red HVAC
F20 15 Amp Blue Heated Seats – If Equipped
F23 25 Amp Clear Anti-Lock Brake Valves
F24 7.5 Amp BrownEPS
YAW Sensor
F30 15 Amp Blue Fog Lamps
F81 30 Amp Green Electronic Shifter (ESM)
F82 30 Amp Green Sunroof
F84 25 Amp Clear Regen Brake Module
F85
30 Amp GreenRear Window Heater
F87 5 Amp Tan Electronic Shifter (ESM)
F90 5 Amp Tan Heated Mirrors
MAINTAINING YOUR VEHICLE
72