Page 318 of 423
3. Turn the jack screw to the left until the jack can be
placed under the jacking location. Once the jack is
positioned, turn the jack screw to the right until the
jack head is properly engaged with the lift area closest
to the wheel to be changed.
WARNING!
Raising the vehicle higher than necessary can make
the vehicle less stable. It could slip off the jack and
hurt someone near it. Raise the vehicle only enough
to remove the tire.
4. Using the swivel wrench, raise the vehicle by turning
the jack screw to the right. Raise the vehicle only until
the tire just clears the surface and enough clearance is
obtained to install the spare tire. Minimum tire lift
provides maximum stability.
Jack Location
316 WHAT TO DO IN EMERGENCIES
Page 319 of 423
NOTE:Before using the swivel wrench to remove the
wheel bolts be sure to remove the center cap of the wheel
by inserting the angled tab end of the swivel wrench into
the notched part of the center cap.
5. Remove the wheel bolts and pull the wheel off the
hub. For vehicles equipped with aluminum wheels,
the center caps must be removed to remove the wheel
bolts.
WARNING!
To avoid the risk of forcing the vehicle off the jack,
do not fully tighten the wheel bolts until the vehicle
has been lowered. Failure to follow this warning may
result in personal injury.
CAUTION!
Be sure to mount the spare tire with the valve stem
facing outward. The vehicle could be damaged if the
spare tire is mounted incorrectly.
Center Cap Removal
6
WHAT TO DO IN EMERGENCIES 317
Page 320 of 423

WARNING!
To avoid possible personal injury, handle the wheel
covers with care to avoid contact with any sharp
edges.
NOTE:The wheel cover is held on the wheel by the
wheel bolts. When reinstalling the original wheel, prop-
erly align the wheel cover to the valve stem, place the
wheel cover onto the wheel, then install the wheel bolts.
6. Install the spare wheel and wheel bolts with the cone
shaped end of the bolts toward the wheel. Lightly
tighten the bolts. To avoid the risk of forcing the
vehicle off the jack, do not tighten the bolts fully until
the vehicle has been lowered.
7. Lower the vehicle by turning the jack screw to the left.
8. Finish tightening the bolts. Push down on the wrench
while tightening the wheel bolts. Alternate bolts until
each bolt has been tightened twice. The correct wheel
bolt torque is 63 ft lbs (85 N·m) for steel wheels and
75 ft lbs (100 N·m) for aluminum wheels. If you doubt
that you have tightened the bolts correctly, have them
checked with a torque wrench by your authorized
studio or service station.
9. Disassemble the jack and tools and place them in the
bag. Stow it under the driver’s seat and secure the bag
to the floor with the straps attached to the floor of the
vehicle.
318 WHAT TO DO IN EMERGENCIES
Page 410 of 423

Cleaning
Wheels...............................369
Windshield Wiper Blades..................350
Climate Control..........................207
Clutch.................................362
Clutch Fluid.............................362
Compact Disc (CD) Maintenance..............206
Compact Spare Tire........................273
Connector
UCI . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..204
Universal Consumer Interface (UCI)..........204
Contract, Service..........................398
Convertible Top Maintenance.................373
Coolant (Antifreeze).......................385
Cooling System...........................356
Adding Coolant (Antifreeze)...............358
Coolant Level..........................356
Disposal of Used Coolant.................360
Drain, Flush, and Refill...................356
Inspection............................360
Points to Remember.....................359
Pressure Cap..........................359
Selection of Coolant (Antifreeze).............357
Corrosion Protection.......................367
Cruise Light.............................150
Cupholders.............................137
Customer Assistance.......................396
Data Recorder, Event.......................58
Daytime Running Lights....................114
Defroster, Windshield.......................81
Diagnostic System, Onboard.................337
Dipsticks
Automatic Transmission..................366
Disposal
Antifreeze (Engine Coolant)................360
Door Locks..............................23
Door Locks, Automatic......................26
408 INDEX
Page 419 of 423

Spark Plugs.............................386
Speed Control (Cruise Control)................122
Speedometer.............................159
Sport Mode.............................246
Starting................................223
Automatic Transmission..................223
Cold Weather..........................224
Engine Fails to Start.....................224
Manual Transmission....................223
Steering
Power...............................242
Tilt Column...........................121
Wheel, Tilt............................121
Steering Wheel Audio Controls...............205
Steering Wheel Mounted Sound System Controls . . .205
Storage................................380
Storage, Vehicle...........................217
Storing Your Vehicle.......................380
Stuck, Freeing............................324
Studio Service............................339
Sun Roof...............................131
Supplemental Restraint System - Airbag..........42
Synthetic Engine Oil.......................343
Tachometer..............................159
Temperature Control, Automatic (ATC)..........210
Temperature Gauge, Engine Coolant............157
Tilt Steering Column.......................121
Tire and Loading Information Placard...........263
TIREFIT................................298
Tire Markings............................257
Ti re s . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 3
Aging (Life of Tires).....................275
Air Pressure...........................268
Chains...............................277
Changing.............................308
Compact Spare.........................273
General Information.....................268
10
INDEX 417