Sealing A Tire With TIREFIT
(A) Whenever You Stop To Use TIREFIT:
1. Pull over to a safe location and turn on the vehicle’s Hazard Warning flashers.
2. Verify that the valve stem (on the wheel with the deflated tire) is in a position that
is near to the ground. This will allow the TIREFIT Hoses (6) and (7) to reach the
valve stem and keep the TIREFIT kit flat on the ground. This will provide the best
positioning of the kit when injecting the sealant into the deflated tire and running
the air pump. Move the vehicle as necessary to place the valve stem in this posi-
tion before proceeding.
3. Place the transmission in PARK (auto transmission) or in Gear (manual transmis-
sion) and cycle the ignition to the OFF position.
4. Set the parking brake.
(B) Setting Up To Use TIREFIT:
1. Turn the Mode Select Knob (5) to the Sealant Mode position.
2. Uncoil the Sealant Hose (6) and then remove the cap from the fitting at the end
of the hose.
3. Place the TIREFIT kit flat on the ground next to the deflated tire.
4. Remove the cap from the valve stem and then screw the fitting at the end of the
Sealant Hose (6) onto the valve stem.
5. Uncoil the Power Plug (8) and insert the plug into the vehicle’s 12 Volt power
outlet.
6. Do not remove foreign objects (e.g., screws or nails) from the tire.
(C) Injecting TIREFIT Sealant Into The Deflated Tire:
• Always start the engine before turning ON the TIREFIT kit.
NOTE:Manual transmission vehicles must have the parking brake engaged and the shift lever inNEUTRAL.
• After pressing the Power Button (4), the sealant (white fluid) will flow from the
Sealant Bottle (1) through the Sealant Hose (6) and into the tire.
NOTE:Sealant may leak out through the puncture in the tire.
•If the sealant (white fluid) does not flow within 0 – 10seconds
through the Sealant Hose (6):
1.Press the Power Button (4) to turn Off the TIREFIT kit. Disconnect the Sealant Hose
(6) from the valve stem. Make sure the valve stem is free of debris. Reconnect the
Sealant Hose (6) to the valve stem. Check that the Mode Select Knob (5) is in the
Sealant Mode position and not Air Mode. Press the Power Button (4) to turn On the
TIREFIT kit.
WHAT TO DO IN EMERGENCIES
51
(E) After Driving:
• Pull over to a safe location. Refer to “Whenever You Stop to Use TIREFIT” before
continuing.
1. Turn the Mode Select Knob (5) to the Air Mode position.
2. Uncoil the Air Pump Hose (7) (black in color) and screw the fitting at the end of
hose (7) onto the valve stem.
3. Uncoil the power plug and insert the plug into the vehicles 12 Volt power outlet.
4. Check the pressure in the tire by reading the Pressure Gauge (3).
•If tire pressure is less than 19 psi (1.3 kPa), the tire is too badly dam-
aged. Do not attempt to drive the vehicle further. Call for assistance.
If the tire pressure is 19 psi (1.3 kPa) or higher:
1.Press the Power Button (4) to turn on TIREFIT and inflate the tire to the pressure
indicated on the tire and loading information label on the driver-side door opening.
2. Disconnect the TIREFIT kit from the valve stem, reinstall the cap on the valve
stem and unplug from 12 Volt outlet.
3. Place the TIREFIT kit in its proper storage area in the vehicle.
4. Have the tire inspected and repaired or replaced at the earliest opportunity at an
authorized studio or tire service center.
5. Replace the Sealant Bottle (1) and Sealant Hose (6) assembly at your authorized
studio as soon as possible. Refer to “(F) Sealant Bottle and Hose Replacement.”
NOTE:
• If the tire becomes over-inflated, press the Deflation Button to reduce the tire
pressure to the recommended inflation pressure before continuing.
• When having the tire serviced, advise the authorized studio or service center that
the tire has been sealed using the TIREFIT service kit.
(F) Sealant Bottle And Hose Replacement:
1. Uncoil the Sealant Hose (6) (clear in color).
2. Locate the round Sealant Bottle release button in the recessed area under the
sealant bottle.
3. Press the Sealant Bottle release button. The Sealant Bottle (1) will pop up. Re-
move the bottle and dispose of it accordingly.
4. Clean any remaining sealant from the TIREFIT housing.
5. Position the new Sealant Bottle (1) in the housing so that the Sealant Hose (6)
aligns with the hose slot in the front of the housing. Press the bottle into the
housing. An audible click will be heard indicating the bottle is locked into place.
WHAT TO DO IN EMERGENCIES
53
MAINTENANCE SCHEDULE
Your vehicle is equipped with an automatic oil change indicator system. The oil
change indicator system will remind you that it is time to take your vehicle in for
scheduled maintenance.
Based on engine operation conditions, the oil change indicator message will illumi-
nate. This means that service is required for your vehicle. Operating conditions such
as frequent short-trips, trailer tow, extremely hot or cold ambient temperatures, and
E85 fuel usage will influence when the “Change Oil” message is displayed. Severe
Operating Conditions can cause the change oil message to illuminate as early as
3,500 miles (5,600 km) since last reset. Have your vehicle serviced as soon as pos-
sible, within the next 500 miles (805 km).
NOTE:Under no circumstances should oil change intervals exceed 10,000 miles (16,000 km) ortwelve months, whichever comes first.
Once A Month Or Before A Long Trip:
• Check engine oil level
• Check windshield washer fluid level
• Check the tire inflation pressures and look for unusual wear or damage
• Check the fluid levels of the coolant reservoir, brake master cylinder, and trans-
mission as needed
• Check function of all interior and exterior lights
Required Maintenance Intervals.
Refer to the Maintenance Schedules on the following pages for required mainte-
nance.
At Every Oil Change Interval As Indicated By Oil Change Indicator System:
•Change oil and filter.
• Rotate the tires. Rotate at the first sign of irregular wear, even if it occurs before theoil indicator system turns on.
•Inspect battery and clean and tighten terminals as required.
•Inspect brake pads, shoes, rotors, drums, hoses and park brake.
•Inspect engine cooling system protection and hoses.
•Inspect exhaust system.
•Inspect engine air cleaner if using in dusty or off-road conditions.
MAINTAINING YOUR VEHICLE
64
Alarm (Security Alarm). . . . . . . . . . .9
Arming Theft System (Security Alarm) . . .9
Automatic Temperature Control (ATC) . .24
Automatic Transmission
Fluid Type. . . . . . . . . . . . . . .63
Belts, Seat. . . . . . . . . . . . . . . . .10
BLUE&ME™ Hands-Free
Communication. . . . . . . . . . . .34
Brake Fluid. . . . . . . . . . . . . . . . .63Break-In Recommendations, NewVehicle. . . . . . . . . . . . . . . . .17Bulb Replacement. . . . . . . . . . . . .72
Child Restraint. . . . . . . . . . . . . . .12Child Restraint Tether Anchors. . . . . .12Clock Setting. . . . . . . . . . . . . . . .33Cooling SystemCoolant Capacity. . . . . . . . . . .63Cruise Control (Speed Control). . . . . .21Cruise Light. . . . . . . . . . . . . . . .21Customer Assistance. . . . . . . . . . .73
Defects, Reporting. . . . . . . . . . . .74Disarming, Theft System. . . . . . . . . .9Driver Cockpit. . . . . . . . . . . . . . . .4
ElectronicsYour Vehicle's Sound System. . . .30Electronic Speed Control(Cruise Control). . . . . . . . . . . . .21Electronic Throttle Control WarningLight. . . . . . . . . . . . . . . . . . .45Electronic Vehicle InformationCenter (EVIC). . . . . . . . . . . . . .40Emergency, In Case ofBrake Warning Light . .. . . . . . .47Towing. . . . . . . . . . . . . . . . .57EngineBreak-In Recommendations. . . . .17Compartment. . . . . . . . . . . . .62Oil Selection. . . . . . . . . . . . . .63Overheating. . . . . . . . . . . . . .48Enhanced Accident ResponseFeature. . . . . . . . . . . . . . . . .57Event Data Recorder. . . . . . . . . . .60Exterior Lights. . . . . . . . . . . . . . .72
Flash-To-Pass .. . . . . . . . . . . . . .18Fluid Capacities . . . . . . .. . . . . . .63Fluids . . . . . .. . . . . . . . . . . . . .63Folding Rear Seat. . . . . . . . . . . . .15Freeing A Stuck Vehicle . . .. . . . . . .59FuelSpecifications. . . . . . . . . . . . .63Fuse. . . . . . . . . . . . . . . . . . . .68Fuses. . . . . . . . . . . . . . . . . . . .68
Hands-Free Communication —BLUE&ME™. . . . . . . . . . . . . .34Hood Release .. . . . . . . . . . . . . .61
Instrument Cluster Warning Lights . .6, 44Introduction. . . . . . . . . . . . . . . . .2iPod®/USB/MP3 Control. . . . . . . . .39
Key Fob . . . . . . . . . . . . . . . . . . .8
Lane Change Assist. . . . . . . . . . . .18Lap/Shoulder Belts . . . . .. . . . . . .10LATCH (Lower Anchors and Tether forCHildren) . . .. . . . . . . . . . . . .12LightsTurn Signal. . . . . . . . . . . . . .18Warning (Instrument ClusterDescription) . . .. . . . . . . . . . . .6
Maintenance Record. . . . . . . . . . .67Maintenance Schedule . . .. . . . . . .64Malfunction Indicator Light(Check Engine) . . . . . . . . . . . . .47Manual Transmission . . . .. . . . . . .25MOPAR® Accessories . .. . . . . . . .75
New Vehicle Break-In Period. . . . . . .17
Oil, EngineCapacity. . . . . . . . . . . . . . . .63OutletPower .. . . . . . . . . . . . . . . .42Overheating, Engine. . . . . . . . . . . .48
Placard, Tire and Loading Information . .70PowerOutlet (Auxiliary Electrical Outlet) . .42Programmable Electronic Features . . .40
INDEX
77