2013 DODGE VIPER ECU

3. Lift the hood upward to the full forward position.
NOTE:The recommended lift point is to place the lifting
hand forward of one of the wiper arms and pull up. The
assist props will help raise and hold the hood to a normal
usage position.CAUTION!
• Do not leave the hood open in areas where strong
gust of wind are likely. Such a place might be by
the side of the road where large trucks pass by.
Strong gusts of wind may damage the hood. Al-
ways close the hood in such situations.
• To prevent possible damage, do not slam the hood
to close it. Simply lower the hood until it is open
approximately 6 in (15 cm) and then drop it. This
should secure both latches. Never drive the vehicle
unless the hood is fully closed with both latches
engaged.
Opened Hood
114 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

Turning ParkViewOn Or Off — With Touch
Screen Radio
1. Turn the Radio on.
2. Press the “More” soft-key.
3. Press the “Settings” soft-key.
4. Press the “Safety & Driving Assistance” soft-key.
5. Press the check box soft key next to “Parkview 
Backup Camera” to enable/disable.
GARAGE DOOR OPENER — IF EQUIPPED
HomeLink replaces up to three hand-held transmitters
that operate devices such as garage door openers, motor-
ized gates, lighting or home security systems. The
HomeLink unit is powered by your vehicles 12 Volt
battery. The HomeLink
buttons, located on the sunvisor, desig-
nate the three different HomeLink channels. The
HomeLink indicator is located above the center button.
NOTE: HomeLink is disabled when the Vehicle Secu-
rity Alarm is active.
HomeLink Buttons Sunvisor
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 133

If you unplugged the garage door opener/device for
programming, plug it back in at this time.
Reprogramming A Single HomeLinkButton
To reprogram a channel that has been previously trained,
follow these steps:
1. Cycle the ignition to the ON/RUN position.
2. Press and hold the desired HomeLink button until
the indicator light begins to flash after 20 seconds. Do
not release the button.
3. Without releasing the button proceed with
“Canadian/Gate Operator Programming” Step 2 and
follow all remaining steps.
Using HomeLink
To operate, press and release the programmed
HomeLink button. Activation will now occur for the
programmed device (i.e., garage door opener, gate opera-
tor, security system, entry door lock, home/office light-
ing, etc.,). The hand-held transmitter of the device may
also be used at any time.
Security
It is advised to erase all channels before you sell or turn
in your vehicle.
To do this, press and hold the two outside buttons for 20
seconds until the red indicator flashes. Note that all
channels will be erased. Individual channels cannot be
erased.
The HomeLink Universal Transceiver is disabled when
the Vehicle Security Alarm is active.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 139

Operation of the Brake Warning Light can be checked by
cycling the ignition from the OFF position to the ON/
RUN position. The light should illuminate for approxi-
mately two seconds. The light should then turn off unless
the parking brake is applied or a brake fault is detected.
If the light does not illuminate, have the light inspected
by an authorized dealer.
The light also will turn on when the parking brake is
applied with the ignition in the ON/RUN position.
NOTE:This light shows only that the parking brake is
applied. It does not show the degree of brake application.
8. Tachometer
This gauge measures engine revolutions-per-minute
(RPM x 1000) 9. Oil Pressure Warning Light
This light indicates low engine oil pressure. The
light should turn on momentarily when the engine is
started. If the light turns on while driving, stop the
vehicle and shut off the engine as soon as possible. A
chime will sound when this light turns on.
Do not operate the vehicle until the cause is corrected.
This light does not indicate how much oil is in the engine.
The engine oil level must be checked under the hood.
10. Vehicle Security Light — If Equipped
This light will flash at a fast rate for approxi-
mately 15 seconds, when the vehicle security
alarm is arming, and then will flash slowly
until the vehicle is disarmed.
11. Fuel Gauge
The pointer shows the level of fuel in the fuel tank when
the ignition is in the ON/RUN position.
156 UNDERSTANDING YOUR INSTRUMENT PANEL

NOTE:
•You must disarm the security system in order to start
the engine. Refer to “Security Alarm System” in
“Things To Know Before Starting Your Vehicle” for
further information.
• Normal starting of either a cold or a warm engine does
not require pumping or pressing the accelerator pedal.
However, if the engine has not started within three
seconds, slightly press the accelerator pedal while
continuing to crank. If the engine fails to start within
15 seconds, wait five seconds, then repeat the “Normal
Starting” procedure.
To Start The Engine:
1. Fully apply the parking brake.
2. Press the clutch pedal to the floor.
NOTE: The engine will not start unless the clutch pedal
is pressed to the floor. 3. Place the shift lever in NEUTRAL.
4. Press the red ENGINE START/STOP button located
on the instrument panel. Release the button when the
engine starts.
Engine START/STOP Button
5
STARTING AND OPERATING 203

WARNING!(Continued)
•To avoid contamination from foreign matter or
moisture, use only new brake fluid or fluid that has
been in a tightly closed container. Keep the master
cylinder reservoir cap secured at all times. Brake
fluid in a open container absorbs moisture from the
air resulting in a lower boiling point. This may
cause it to boil unexpectedly during hard or pro-
longed braking, resulting in sudden brake failure.
This could result in a accident.
• Overfilling the brake fluid reservoir can result in
spilling brake fluid on hot engine parts, causing
the brake fluid to catch fire. Brake fluid can also
damage painted and vinyl surfaces, care should be
taken to avoid its contact with these surfaces.
(Continued)
WARNING! (Continued)
•Do not allow petroleum based fluid to contaminate
the brake fluid. Brake seal components could be
damaged, causing partial or complete brake failure.
This could result in an accident.
Change Brake Fluid
Brake fluid will tend to absorb moisture from the atmo-
sphere over time. If the fluid becomes contaminated with
water, brake performance will deteriorate. Therefore, the
brake fluid must be changed at the intervals specified in
the “Maintenance Schedule.” Refer to “Maintenance
Schedule” for further information. See your authorized
dealer for service.
300 MAINTAINING YOUR VEHICLE

About Your Brakes....................... .218
ABS (Anti-Lock Brake System) ................219
Adding Engine Coolant (Antifreeze) ............294
Adding Fuel ............................ .252
Adding Washer Fluid ..................... .289
Additives, Fuel .......................... .250
Adjustable Pedals ........................ .125
Airbag ..................................39
Airbag Deployment ........................44
Airbag Light .............................45
Airbag Maintenance ........................51
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . .283
Air Conditioner Maintenance .................287
Air Conditioning, Operating Tips ..............198
Air Conditioning Refrigerant .................287
Air Conditioning System ....................287
Air Pressure, Tires ........................ .238
Alarm Light ............................ .156
Alarm System (Security Alarm) ................14Alterations/Modifications, Vehicle
...............7
Antenna ............................... .190
Antifreeze (Engine Coolant) ..................293
Capacities ........................... .321
Disposal ............................ .296
Anti-Lock Brake System (ABS) ................219
Anti-Lock Warning Light ....................163
Anti-Theft Security Alarm (Theft Alarm) ..........14
Appearance Care ........................ .302
Assistance Towing .........................85
Auto Down Power Windows ..................25
Automatic Door Locks ......................23
Automatic Headlights ......................116
Auto Unlock, Doors ........................23
Auto Up Power Windows ....................25
Auxiliary Electrical Outlet (Power Outlet) ........141
Auxiliary Power Outlet .....................141
354 INDEX

Bulb Replacement..................... .318
Cruise .............................. .159
Daytime Running .......................117
Dimmer Switch, Headlight ................118
Exterior ..............................63
Hazard Warning Flasher ..................258
Headlights ...........................115
Headlights On Reminder .................117
Headlights On With Wipers ...............116
Headlight Switch .......................115
High Beam ...........................119
High Beam Indicator ....................154
High Beam/Low Beam Select ..............119
Illuminated Entry .......................16
Instrument Cluster ......................115
Intensity Control .......................119
Interior ..............................119
Lights On Reminder .....................117
Malfunction Indicator (Check Engine) ........158Oil Pressure
......................... .156
Parade Mode (Daytime Brightness) ..........121
Passing ..............................119
Seat Belt Reminder ..................... .153
Security Alarm (Theft Alarm) ..............156
Service ............................. .318
Service Engine Soon (Malfunction Indicator) . . . .158
Theft Alarm (Security Alarm) ..............156
Tire Pressure Monitoring (TPMS) ............157
Turn Signal ............................63
Vanity Mirror ..........................70
Warning (Instrument Cluster Description) .....153
Loading Vehicle Tires ............................... .232
Locks ..................................21
Automatic Door ........................23
Auto Unlock ...........................23
Door ................................21
Power Door ...........................22
10
INDEX 361