2013 DODGE CHALLENGER SRT trunk

[x] Cancel search: trunk

Page 402 of 520

DODGE CHALLENGER SRT 2013 3.G Owners Manual CAUTION!
Do not use a portable battery booster pack or any
other booster source with a system voltage greater
than 12 Volts or damage to the battery, starter motor,
alternator or electrical system may

Page 423 of 520

DODGE CHALLENGER SRT 2013 3.G Owners Manual WARNING!(Continued)
for repair or maintenance. Make sure that no one is
near the engine compartment before starting the
vehicle with the air induction system (air cleaner,
hoses, etc.) removed. Failur

Page 445 of 520

DODGE CHALLENGER SRT 2013 3.G Owners Manual •If insects, tar, or other similar deposits have accumu-
lated on your vehicle, use MOPAR® Super Kleen Bug
and Tar Remover to remove.
• Use a high quality cleaner wax, such as MOPAR®
Cleaner Wax

Page 453 of 520

DODGE CHALLENGER SRT 2013 3.G Owners Manual Rear Power Distribution Center
There is also a power distribution center located in the
trunk under the spare tire access panel. This center
contains fuses and relays.
CAUTION!
•When installing the

Page 459 of 520

DODGE CHALLENGER SRT 2013 3.G Owners Manual Interior Bulbs
Bulb Number
Rear Courtesy/Reading
Lamps W5W
Rear Compartment
(Trunk) Lamp 562
Overhead Console Read-
ing Lamps 578
Visor Vanity Lamps A6220
Glove Box Lamp – If
Equipped 194
Door Court

Page 461 of 520

DODGE CHALLENGER SRT 2013 3.G Owners Manual Front/Rear Side Marker Lamp
1. Remove the front/rear side marker. Use a fiber stick orsimilar tool to gently pry the lamp on the outboard
side to disengage the clip.
NOTE: •If a screwdriver is used,

Page 462 of 520

DODGE CHALLENGER SRT 2013 3.G Owners Manual 4. Pull back the trunk liner.
5. Remove the remaining fasteners from the back of thetail lamp assembly.
6. Pull the tail lamp assembly clear from the vehicle to access the bulbs. 7. Push the electrica

Page 463 of 520

DODGE CHALLENGER SRT 2013 3.G Owners Manual 11. Reinstall the bulb and socket assembly into the taillamp assembly, and then turn it clockwise.
12. Reinstall the tail lamp assembly, fasteners, electrical connector, and trunk liner.
13. Reinstall
Page:   < prev 1-8 9-16 17-24 25-32 next >