2013 Citroen C3 RHD check oil

22
Limit the causes of excess consumption
Spread loads throughout the vehicle; place the heaviest items in the bottom of the boot, as close as possible to the rear seats.Limit the loads carried in the vehicle and reduce wind resistance (roof bars, roof rack, bicycle carrier, trailer...). Use a roof box in preference.Remove roof bars and roof racks after use.


At the end of winter, remove snow tyres and refit your summer tyres.


Observe the recommendations on maintenance


Check the tyre pressures regularly, when cold, referring to the label in the door aperture, driver's side. Carry out this check in par ticular:



- before a long journey,

- at each change of season,

- after a long period out of use.
Don't forget the spare wheel and the tyres on any trailer or caravan.


Have your vehicle ser viced regularly (engine oil, oil filter, air filter...) andobser ve the schedule of operations recommended by the manufacturer.


When refuelling, do not continue after the third cut-off of the nozzle toavoid any over flow.


At the wheel of your new vehicle, it is only after the first 1 800 miles(3 000 kilometres) that you will see the fuel consumption settle down toa consistent average.

Monitoring
30
reading the associated message in the multifunction screen. If you encounter any problems, do not hesitate to contact a CITROËN dealer or a qualified workshop.
Warning lamps
When the engine is running or the vehicle is
being driven, the illumination of one of the following warning lamps indicates a fault whichrequires action on the par t of the driver.
Warning lampis onCauseAction / Observations
STOPfixed, alone or
associated withanother warning lamp,accompanied by anaudible signal anda message on the screen. Illumination of the warnin
g lamp is
associated with a serious braking system or engine coolant temperature problem. Stop as soon as it is safe to do so as the en
gine may
cut out when driving.
Park, switch off the ignition and call a CITROËN
dealer or a qualified workshop.
Servicetemporarily. Minor problems have occurred for
which there is no specific warninglamp.Identi
fy the problem by reading the message shown in
the screen, such as, for example:
- the engine oil level,
- the screenwash level,
- the remote control batter
y,
- saturation of the par ticle emission filter on Diesel
vehicles
(see the "Checks - Particle emissions
filter" section).
For any other faults, contact a CITROËN dealer or a
qualified workshop.
fixed.Major problems have occurred for
which there is no specific warninglamp.Identi
fy the problem by reading the message shown
in the screen and contact a CITROËN dealer or a
qualified workshop.

1
Monitoring
37
Engine oil level indicator

This information is displayed for a few seconds
when the ignition is switched on, after theservice information.
Oil level correct
This is indicated by the flashing of "OIL", linked with the ser vice warning lamp, accompanied
by an audible signal and a message in the
multifunction screen.
If the low oil level is confirmed by a check using
the dipstick, the level must be topped up to prevent damage to the engine.
Oil level low

This is indicated by the flashing of "OIL--" . Contact a CITROËN dealer or a qualified
workshop.

Oil level indicator fault

Dipstick


There are 2 marks on the
dipstick:


- A= max; never exceed this
level (risk of damage to the engine), -B= min; top up the level via
the oil filler cap, using thegrade of oil suited to your engine. R
efer to the "Checks" section to locate the
dipstick and the oil filler cap on your engine.

The level shown will only be correctif the vehicle is on level ground and
the engine has been off for more than 30 minutes.

10
Checks
141














Petrol engines
1.
Screenwash fluid reservoir. 2.Coolant header tank.3.Air filter.4.
Brake fluid reservoir.
5. Battery.
6.Fusebox.7. Engine oil dipstick.8.Engine oil filler cap.

Checks
142













Diesel engines

Screenwash fluid reservoir.2.
Coolant header tank.3.Air filter.4.
Brake fluid reservoir.5.
Battery.
6.Fusebox.7. Engine oil dipstick. 8.Engine oil filler cap.
9.
Priming pump (on fuel filter).

10
Checks
143






Checking levels
Oil level


The check is carried out either when
the ignition is switched on using theoil level indicator in the instrument
panel, or using the dipstick.
Engine oil change
Refer to the MAINTENANCE AND WARR ANT Y GUIDE for details of the inter val
for this operation.
In order to maintain the reliabilit
y of the engine and emission control system, the use of additives in the engine oil is prohibited.

It is normal to top up the oil levelbetween two ser vices (or oil changes).CITROËN recommends that you check
the level, and top up if necessary, every3 000 miles (5 000 kms). After topping up the oil, the check when switching on the ignition with the oil level indicator in the instrument panel is not valid during the 30 minutes after topping up. It will onl
y be correct if the vehicle is on level ground and the engine has been off for more
than 30 minutes.
Check all of these levels re
gularly, in line with the MAINTENANCE AND WARR ANT Y GUIDE. Top them up if necessary, unless other wise indicated.
If a level drops significantly, have the corresponding system checked by a CITROËN dealer or a qualified workshop.


Take care when working under the bonnet, as certain areas of the engine may be extremely hot (risk of burns) and the cooling fan could star t atany time (even with the ignition off).

Oil specifi cation
The oil must be the correct grade for your
engine and conform to the manufacturer'srecommendations.
Th
e brake fluid level should be close
to the "MA X" mark. If it is not, check
the brake pad wear.
Brake fluid level

Changing the fl uid

Refer to the MAINTENANCE AND
WARR ANT Y GUIDE for details of the intervalfor this operation.


Fluid specifi cation

The brake fluid must conform to themanufacturer's recommendations and meet
the DOT3 or DOT4 standard.

Checks
144
Additive level (Diesel with
particle emissions filter)
According to your version of instrument panel,
the additive reser voir low level is indicated by:

To p p i ng up

The reser voir must be topped up without delay by a CITROËN dealer or a qualified workshop.








Used products
- fixed illumination of the particle emissions filter warning lamp,accompanied by an audible signal, or

- fix
ed illumination of the servicewarning lamp, accompanied byan audible signal and a message
that the par ticle emissions filter additive level is too low.
Do not discard used oil or fluids into sewers or onto the ground.
Take used oil to a CITROËN dealer or a qualified workshop (France) or to anauthorised waste disposal site.

Avoid prolonged contact of used oil or fluids with the skin.

Most of these fluids are harmful tohealth or indeed very corrosive.
Coolant level

The coolant level should be close
to the "MA X" mark but should never exceed it.
When the en
gine is warm, the temperature of
the coolant is regulated by the fan.
Changing the coolant
The coolant does not have to be changed.
Fluid specifi cation
The coolant must conform to themanufacturer's recommendations.
Top up the level when necessary.
The cooling fan may star t after switching off the engine: take care with ar ticles and clothing that mightbecome caught by the fan blades.
In addition, as the cooling system is pressurised,
wait at least one hour after switching off theengine before carrying out any work.
To avoid any risk of scalding, unscrew the cap
by two turns to allow the pressure to drop. When
the pressure has dropped, remove the cap and
top up t
he level.
Screenwash fluid level

Fluid specifi cation

For optimum cleaning and to avoid freezing,
this
fluid must not be topped up or replaced
with plain water.

10
Checks
145
According to your version of instrument panel, the start of
saturation of the par ticle emissions filter is indicated by: - fixed illumination of the par ticle emissions filter warning lamp,
accompanied by an audible signal, or
- temporary illumination of
the ser vice warning lamp,

As soon as the traffic conditions permit, regenerate
the filter by driving at a speed of at least 40 mph (60 km/h) until the warning lamp goes off.
If the warning lamp stays on, refer to the "Additivelevel" section.







Checks
12 V battery
The battery does not require anymaintenance.
However, check that the terminals are clean and correctly tightened,particularly in summer and winter.
The presence o
f this label, in particular with
the Stop & Star t system, indicates the use of
a specific 12 V lead-acid batter
y with special
technology and specification. The involvement
of a CITROËN dealer or a qualified workshop is essential when replacing or disconnecting thebattery. When carr
ying out work on the battery, refer
to the "12 V battery" section for details of theprecautions to be taken before disconnecting
the battery and following its reconnection.
Unless other wise indicated, check these components in accordance with the MAINTENANCE AND WARR ANT Y GUIDE and accordin
g to your engine.
Other wise, have them checked by a CITROËN dealer or a qualified workshop.
On a new vehicle, the first operations of regeneration of the par ticle emissionsfilter may be accompanied by the smell of "burning", w hic h is per fec t ly normal.
Following prolonged operation of thevehicle at very low speed or at idle, you may, in exceptional circumstances, notice the emission of water vapour atthe exhaust on acceleration. This does not affect the behaviour of the vehicle or the environment.
Par ticle emission filter (Diesel)
accompanied by an audible signal and amessage that there is a risk of blockage of
the par ticle emissions filter.
Air filter and passenger compartment filter

Refer to the MAINTENANCE AND
WARR ANT Y GUIDE for details of
the replacement intervals for thesecomponents.
Depending on the environment (e.g. dustyatmosphere) and the use of the vehicle (e.g. city
driving), replace them twice as often if necessar y.y A clogged passenger compar tment filter may have
an adverse effect on the performance of the air conditioning system and generate undesirableodours.


Replace the oil filter each time the
engine oil is changed.
Refer to the MAINTENANCE AND
WARR ANT Y GUIDE for details of
the replacement inter val for this component.
Oil filter