2013 Citroen C3 RHD bulb

.
.
Contents
Direction indicators 108
Hazard warning lamps 108
Horn 109
Emergency or assistance call 109
Braking assistance systems 110
Tr ajectory control systems 111
Front seat belts 112
Airbags 114
Safety
Parking brake 118
6-speed manual gearbox 118
Gear effi ciency indicator 119
Electronic gearbox 120
Automatic gearbox 124
Stop & Start 127
Hill star t assist 130
Speed limiter 131
Cruise control 133
Rear parking sensors 135
Reversing camera 137
Driving
Emergency or assistance 199
eMyWay 201
Audio system 255
Audio and telematics
Alphabetical index
Bonnet 139
Running out of fuel (Diesel) 140
Petrol engines 141
Diesel engines 142
Checking levels 143
Checks 145
Checks
Te m p o r a ry puncture repair kit 147
Changing a wheel 152
Snow chains 159
Changing a bulb 160
Changing a fuse 167
Battery 174
Energy economy mode 177
Changing a wiper blade 178
To w i ng the vehicle 179
To w i ng a trailer 181
Audio pre-equipment 183
Accessories 185
Practical informationTechnical data
Petrol engines 187
Petrol weights 188
LPG engines 190
LPG weights 191
Diesel engines 192
Diesel weights 194
Dimensions
196
Identifi cation markings 197
Visual search

6
Fittings
97





Rear parcel shelf


To remove the shelf: )unhook the two cords, )raise the shelf slightly, then unclip it on each side.







Hooks
The hooks can be used to hold shopping bags.






Storage box
)
Raise the boot carpet by pulling the strap
upwards to gain access to the storage box.
This has areas for storing a temporary puncture
repair kit, a box of spare bulbs, a first aid kit,
two warn
ing triangles, ...
) refit the boot floor carpet by folding itslightly in the middle.

Practical information
160











Changing a bulb
1.Direction indicators (PY21W amber).2.Sidelamps (W5W).3. Main beam headlamps (H1- 55W).4.Dipped beam headlamps (H7-55W).5.LED daytime running lamps.6.Front foglamps (PSX24W).


Front lamps
The headlamps are fitted withpolycarbonate glass with a protectivecoating:)do not clean them using a dryor abrasive cloth, nor with adetergent or solvent product,)use a sponge and soapy water or apH neutral product,)when using a high pressure washer on persistent marks, do not keepthe lance directed towards thelamps or their edges for too long,so as not to damage their protectivecoating and seals.
Changing a bulb should only be doneafter the headlamp has been switched off for a few minutes (risk of seriousburns).- do not touch the bulb directly with your fingers, use a lint-free cloth.It is imperative to use only anti-ultraviolet (UV) type bulbs to avoid damaging the headlamp.
Always replace a failed bulb with anew bulb with the same type and specification.

11
Practical information
161


Changing direction indicator bulbs
)Turn the bulb holder a quar ter of a turn andextract it. )Pull out the bulb and change it.
To r e f i t , c a r ry out these operations in reverseorder.
Changing dipped beam headlamp bulbs
)
Remove the protective cover by pulling the
tab.) Disconnect the bulb connector.)
Spread the springs to release the bulb.)
Pull the bulb out and change it.
To r e f i t , c a r ry out these operations in reverseorder.


Rapid flashing of the direction indicator warning lamp (right or left) indicates the failure of a bulb on that side.
When refitting, close the protective cover carefully to preser ve the sealing
of the headlamp.

Amber coloured bulbs, such as thedirection indicators, must be replacedwith bulbs of identical specificationsand colour.

Practical information
162
bulbs
)Remove the protective cover by pulling on
the tab.)Disconnect the bulb connector. )Spread the springs to release the bulb.)Remove the bulb and change it.
To r e f i t , c a r ry out these operations in reverse order.

Changing sidelamp bulbs
)
Remove the protective cover by pulling on
the tab. ) Pull the bulb holder pressing on the tabs on both sides. )
Pull the bulb and change it.
To r efit, carry out these operations in reverseorder.

11
Practical information
163

Changing integrated directionindicator side repeaters
)Insert a screwdriver towards the centre of
the repeater between the repeater and the base of the door mirror.)Tilt the screwdriver to extract the repeater and remove it.)Disconnect the repeater connector.)Replace the module.
To r efit, carry out these operations in reverseorder.

Contact a CITROËN dealer or a qualified workshop to obtain areplacement side repeater module.
Changing front foglamp bulbs
)
Access to the front foglamp is through the
aperture below the bumper.) Disconnect the black bulb holder connector, by pressing on the tab at the
top.) Remove the bulb-holder by pressing on the
2 clips (at the top and the bottom). ) Replace the module.
To r e f i t , c a r ry out these operations in reverse order.
To obtain a replacement module, contact your CITROËN dealer or a qualified workshop.
If you experience any difficulty in replacing bulbs, contact your CITROËN dealer or a qualified workshop.

Practical information
164
Rear lamps
1.Brake / sidelamps (P21/5W).2.Direction indicators (PY21W amber)3. Foglamp, right-hand side (PR21W red)Reversing lamp, left-hand side (P21W).
Changing bulbs
These four bulbs are changed from inside the boot: )spread the four tabs and remove the bulbholder,
)turn the bulb a quar ter of a turn and change it.
To r efit, carry out these operations in reverse order.
Take care to engage the lamp unit in its guides,
while keeping it in line with the vehicle.
) open the boot,)
remove the access flap from the
corresponding side trim panel,)
unscrew the butterfly nut securing the lamp unit, )
unclip the lamp unit connector, )
extract the lamp unit carefully pulling in its
middle towards the outside,
Amber or red bulbs, such as thosefor the direction indicators and rear foglamp, must be replaced by bulbs of the same rating and colour. The lamps on the tailgate are dummy units. They are there for aesthetic purposes only.

11
Practical information
165

Changing the number plate lamp
bulbs (W5W)
)Insert a thin screwdriver into one of theouter holes of the lens. )Push it outwards to unclip.
)Remove the lens. )Pull the bulb out and change it.
Third brake lamp (4 W5W bulbs)
) Open the boot. )
Remove the plugs A
on the inner panel.)
Push on the centre of the lamp using
tw
o screwdrivers to lever it outwards.) Disconnect the connector and if necessary
the screenwash pipe from the lamp.) Turn the bulb holder for the faulty bulb aquar ter of a turn. )
Pull out the bulb and change it.
To r e f i t , c a r ry out these operations in reverseorder.