2013 CITROEN C1 Seat

.
.
Contents
Horn 48
Hazard warning lamps 48
Parking brake 48
Emergency braking assistance 49
ABS, EBFD, CSC systems 49
ASR and ESP systems 50
Seat belts 51
Airbags 54
Safety
Rev counter 19
Instrument panel 19
Warning lamps 20
Distance recorder 23
Indicators 23
Setting the time 25
Monitoring Familiarisation
Keys / Remote control 26
Doors 28
Electric windows 28
Rear windows 29
Boot 29
Fuel tank 30
Access
Ventilation 33
Heating 34
Air conditioning 35
Mirrors 37
Steering wheel adjustment 37
Front seats 38
Rear seats 39
Comfort Eco-driving
Interior fi ttings 40
Boot fi ttings 41
Fittings
Electronic gearbox 42
Driving
Lighting control stalk 44
LED daytime running lamps 45
Headlamp adjustment 46
Courtesy lamp 46
Windscreen wiper stalk 47
Visibility

.
.
Contents
Child seats 57
ISOFIX mountings 62
Child safety
Changing a wheel 65
Changing a bulb 67
Changing a fuse 71
Battery 76
Mat 79
Fitting audio equipment/speakers 79
To w i ng the vehicle 80
Fitting roof bars 81
Accessories 82
Practical information
Audio system / Bluetooth 93
Audio system 116
Audio
Alphabetical indexVisual search
Opening the bonnet 84
Engine 85
Checking levels 86
Checks 88
Checks
Engine 89
Weights 90
Dimensions 91
Identifi cation markings 92
Technical data

.Familiarisation
9
1. Forwards-backwards adjustment.2.
Seat back angle adjustment.3.Access to rear seats (3-door).

Sitting comfortably


Front seats
38

.Familiarisation
15
Your vehicle has been approved in accordancewith the new ISOFIX regulation.
The rear seats are fitted with regulation ISOFIX
mountings.
These are three rings for each seat:
- two lower rings A , located between the
vehicle's seat back and cushion,- an upper ring B
, referred to as the TOP TETHER, located at the rear of the seat back at the bottom.
The ISOFIX child seats
are fitted with two
latches and/or a strap which are secured easily on these rings, indicated by labels or a mark on
the rear seat back panel.


Passenger's airbag deactivated
If the passenger's airbag is deactivated,
this warning lamp remains on until thepassenger's airbag is reactivated.

Front seat belt(s) not fastened /
unfastened warning lamp
1.
Inser t the key. 2.Select the "OFF"
position .3.Remove the key in the OFF position.
When the ignition is switched on, the
warning lamp flashes if the driver and/or front passenger has not fastened their seat belt.
The warning lamp flashes when the driver
and/or front passenger unfastens their seat belt
with the engine running.
Safety


Passenger's airbag
deactivation"ISOFIX" mountin
gs
556
2
52

18
Limit the causes of excess
consumption
Spread loads throughout the vehicle; placethe heaviest items in the bottom of the boot,as close as possible to the rear seats.Limit the loads carried in the vehicle andreduce wind resistance (roof bars, roof rack, bicycle carrier, ...). Use a roof box inpreference.Remove roof bars and roof racks after use.

At the end of winter, remove snow tyres and refit your summer tyres.


Observe the recommendations
on maintenance

Check the tyre pressures regularly, when cold, referring to the label in the door aper ture, driver's side.
Carry out this check in par ticular:


- before a long journey,

- at each change of season,

- after a long period out of use.
Don't forget the spare wheel.


Have your vehicle ser viced regularly (engine oil, oil filter, air filter...) and obser ve the schedule of operations recommended by themanufacturer.


When refuelling, do not continue after the 3rd
cut-off of the nozzle to avoid any overflow.

At the wheel of your new vehicle, it is onlyafter the first 1 800 miles (3 000 kilometres) that you will see the fuel consumption settle down to a consistent average.

P/S
Monitoring
22



Deactivating
the passenger's airbag
fixed. The passen
ger's airbag control
is set to the OFF
position.
The passen
ger's front airbag is deactivated.
In this case you can install a
"rear facing" child seat.
Set the control to the ON
position to activate the passenger's
front airbag. In this case, do not fit a child seat in the rear-facing position.



Battery charge

fixed. The battery charging circuit has
a fault (dirty or loose terminals, slack or cut alternator belt, ...). The warnin
g lamp should go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a qualified workshop.

Electric power steering
fixed. The electric power steering has a fault. Drive carefull
y at reduced speed.
Have it checked by a CITROËN dealer or qualified workshop.



Front seat beltnot fastened /
unfastened(depending on version)

flashing, then above
12 mph (20 km/h),
accompanied b
y an
audible signal.
The driver and/or front
passenger has not fastened or has unfastened their seat belt. Pull the strap then inser t the tongue in the buckle.



Emissioncontrolsystem fixed. The emission control system has a fault. This lamp should
go off when the engine is started.
If it does not go off, contact a CITROËN dealer or a qualified workshop without delay.

Electronicgearbox
fixed. The electronic gearbox has a
fault. Contact a CITROËN dealer or a qualified workshop without
delay.
Warning lampis onCauseAction/Observations

38Comfort








Front seats

Push control A rear wards while adjusting the
angle of the seat back.
Raise the control and slide the seat forwards or backwards.
Position the seat belt along the door pillar.
Push control A
rearwards to fold the seat back and move the seat forwards.
To put the seat back in place, push the seat
back until the seat locks.
Reset the for wards-backwards adjustment of
the seat and the seat back angle.
No person or object must prevent the seat from returning to the required
position.
1. Forwards-backwardsadjustment

2. Seat back angle adjustment 3. Access to the rear seats (3-door)

3
39 Comfort











Rear seats
it on mounting B . Take care not to trap the seat belts, inpar ticular between the seat back and themounting B.Check that the backrest has engaged correctly.
The rear head restraints can be removed andhave two positions:


- high, position for use.

- low, storage position.
Th
e seat backrest is folded from the rear of the
vehicle, with the boot open:


- check that the seat belt is positioned
correctly on the side of the seat back toavoid damaging it,

- place the head restraints in the low position(see "rear head restraints"),

- while folding the seat backrest, pull thestrap(s) A
, located behind the seat back.
Rear head restraints *


To raise the head restraint, pull it upwards.
To lower it, press lug Athen the head restraint.
To remove it:


- tilt the seat back slightly,

- move the head restraint to the highposition,

- press lug A
pulling the head restraint
upwards at the same time.


T
o refit it:


- tilt the seat back slightly,

- engage the rods of the head restraint in the
openings.

*
Dependin
g on version.
To reach the low position, press lug A.


Folding the backrest of the
bench seat
Returning the backrest of the
bench seat to its initial position