2013 CITROEN C1 Automatic

04
105
USING THE TELEPHONE
A virtual keypad is displayed on the screen: choose
a 4 digit code then confi rm with OK .


A message is displayed on the screen of the
telephone: enter the same code and confi rm.
A message appears in the screen to confi rm the result of the connection.
Pairin
g can also be initiated from the telephone by searching for detected Bluetooth devices.
Accept the connection to the telephone.

I
f pairing fails, try again; the number of attempts is not limited. The director
y and the calls list can be accessed after thesynchronisation period (if the telephone is compatible).

Automatic connection must be confi gured in the telephone to allow
the connection each time the vehicle is started.

In some cases, the Bluetooth address of the telephone ma
y appear
instead of the name of the telephone.

04
109
USING THE TELEPHONE

HANG UP

In the contextual menu:

-
select "Combined mode"to
transfer the call to the telephone.

-
select "Combined mode"to
transfer the call to the vehicle.
In the contextual menu:
-
select " Micro OFF
" to switch off themicrophone.
-
select " Micro OFF
" to switch the
microphone on again.
In certain cases, the combined mode has to activated
from the
telephone.
The Bluetooth connection will be restored automaticall
y if the ignition
has been switched off, then on again (depending on the compatibility
of the telephone).



MANAGING CALLS


A long press on SRC/TELalso ends
the call. In the contextual menu, select
"Hang up"
to end the call.
SECRET - MUTE

(so that the caller cannot hear)

COMBINED MODE

(to leave the vehicle without ending the call)

11 4
FREQUENTLY ASKED QUESTIONS
QUESTIONANSWER SOLUTION
Traffi c announcement
TA is displayed. I donot receive any traffi c
information.Th
e radio station does not broadcast traffi c information. Tune to a radio station which broadcasts traffi c
information.
Th
e stored stations arenot found (no sound, 87.5 MHz is displayed...). An in
correct waveband is selected. Press the SRC/TEL button to return to thewaveband (FM1 or FM2) on which the stations arestored.
The CD is e
jected
automatically or is not played by the player. The CD is inserted upside down, is unpla
yable, does not contain any audio data or contains an audio format which the player cannot play.
The
CD is protected by an anti-pirating protection system which is not recognised by the audio equipment.
- Check that the CD is inserted in the pla
yer the
right way up.

-
Check the condition of the CD: the CD cannot
be played if it is too damaged.

-
Check the content in the case of a recordedCD: consult the advice in the "Audio" section.

- The audio equipment's CD pla
yer does not
play DVDs.

- Due to their qualit
y level, certain writeableCDs will not be played by the audio system.
The CD pla
yer sound ispoor.The CD used is scratched or of poor quality. Insert good quality CDs and store them in suitable conditions.
The audio settin
gs (bass, treble, ambience) are unsuitable. Set the treble or bass level to 0, without selectingan ambience.
Th
e Bluetooth connection
is cut. The battery of the peripheral may not be suffi ciently charged. Recharge the battery of the peripheral device.
The messa
ge "USB
device error" is displayedon the screen.The USB memor
y stick is not recognised.
The memor
y stick may be corrupt. Reformat the memor
y stick in FAT 16 or FAT 32.

115
FREQUENTLY ASKED QUESTIONS
QUESTIONANSWER SOLUTION
A telephone connects
automatically,
disconnecting another
telephone. A
utomatic connection overrides manual connection. Modify the telephone settings to remove automatic connection.

An iPod is not recognised
when connecting to the
USB port.The iPod is of a
generation that is not compatible with the USB.

The hard disk or deviceis not recognised whenconnecting to the USBport. Some hard disks and devices need a power suppl
y greater than is
provided by the audio system. Connect the device to the 230 V socket, the 12 V socket or an external power supply.
Caution
:
ensure that the device does not transmit
a voltage greater than 5 V (risk of destruction of
the system).
When streamin
g, the sound cuts momentarily. Some telephones prioritise connection of the "hands-free" profi le. Delete the "hands-free" connection profi le to
improve streaming.

In "Random all" play,not all of the tracks areplayed.In "Random all" pla
y, the system can only take into account up to 999
tracks.
With the en
gine off, the
audio system switches off after a few minutes of use. When the en
gine is switched off, the audio system operating time
depends on the battery charge.
The switch-off is normal: the audio s
ystem switches to economy mode and switches off to prevent discharging the vehicle's battery.
Start the vehicle's engine to increase the batterycharge.

The message "the audio system is overheated"
appears on the display. In order to protect the installation i
f the surrounding temperature is too
high, the audio system switches to an automatic thermal protection mode
leading to a reduction of the volume or stopping of the playing of the CD.
Switch the audio system off for a few minutes to
allow the system to cool.

01
118
FIRST STEPS
With the ignition key in the accessories position or with the ignition on, press this button to switch the
audio equipment on or off.

You exit
from this mode automatically after a fewseconds without any action.










GENERAL FUNCTIONS

When the parameter is displayed, change thesetting using these two buttons.
Pr
ess this button several times in succession togain access to the bass (BASS)
, treble (TREB)
,
front / rear balance (FA D)and left / right balance(BAL) settings.
After the en
gine has been switched off, the audio equipmentcan only operate for approximately 30 minutes, to preventdischarging of the battery.
AUDIO SETTINGS
ON / OFF

Press the upper part o
f this button several times
in succession to increase the volume of theaudio system or the lower part of this button todecrease it.
VOLUME ADJUSTMENT

The audio s
ystem controls enable you to adjust the volume and the
audio settings.
T
o exit from the AUX
source, press AM/FM.
When using an MP3 player:
increase the volume of the radio signifi cantly (between 30 and 60) to obtain a satisfactory playing
volume.

In order to listen to it, connect
your equipment then press this button.
An auxiliary socket "AUX"
is provided for the connection of portable equipment (MP3 player, etc.).
AUXILIARY SOCKET

02
119
RADIO

Automatic search for a higher frequency: double press / Successive tuning in to the stations
Selection of the AM / FM (FM1, FM2, FM3)
wavebands

Manual search for a hi
gher / lower frequency
Selection of the stored station /Storing of a station: press for
more than 2 seconds
AF function on
/off: alternative frequencies
Autostore: automatic storing of 6 stations on AM and FM3

TA function on/off: traffi c
information priority

Selection of the type of radio programme: News, Sports,
Talk, Pop, Classics

02
120
RADIO






STATIONS

When the radio receives a station broadcasting in stereo it
automatically plays in stereo and the screen displays "ST". If thereception conditions deteriorate, the radio changes to mono and "ST"is no longer displayed. STEREO RECEPTION

Pr
ess this button. SELECTION OF THE RADIO SOURCE

Press the button successivel
y to select thewavebands FM1, FM2, FM3 and AM. SELECTION OF A WAVEBAND
Pr
ess this button twice to select the next station.
Press this button briefl
y to listen to each stationavailable on the FM waveband for three seconds.To stop the station scan, press this button again.
AUTOMATIC STATION SEARCH

I
f the traffi c information programme TAis selected, only stationswhich broadcast this type of programme are selected.

Press one of these two buttons briefl
y to increase or
decrease the frequency displayed respectively.
I
f you maintain the pressure on the button in thechosen direction, the frequency will be scannedcontinuously.
The scan stops when
you release the button. MANUAL STATION SEARCH

02
121
Select the required station.
Pr
ess one of the buttons "1"
to "6"for more than 2 seconds.

An audible signal confi rms that the station has been preset. MANUAL STATION PRESETTING

Press this button.

Your audio equipment automatically presets the six strongest stations received on AMand FM
in your current location. These stations are stored on the
AMand FM3wavebands. The end of the search is signalled by two audible signals.
AUTOMATIC PRESETTING OF FM STATIONS(AUTOSTORE)

RADIO


If it was not possible to fi nd six stations the remaining memories remain empty: three dashes are displayed on the audio system screen for each empty memory.
RECALLING PRESET STATIONS
On each waveband, a brief press on one of the buttons "1"
to "6"
recalls the corresponding preset station.

RADIO RECEPTION
Your audio system will be subjected to phenomena which do not
affect domestic radio sets. Both MW/LW and FM reception are
subject to various forms of interference. This is no refl ection on the quality of the system but is due to the nature of the signals and the
way in which they are transmitted.
On MW/LW, interference may be noticed when passing under high
voltage power lines or bridges, or in tunnels.
On FM, interference may be the result of increasing distance from
the transmitter, defl ection of the signal by obstacles (mountains,
hills, buildings, etc) or of being in an area which is not covered by a
transmitter.