2013 CHRYSLER 300 oil type

remote control ESP inoperative adding oil air filter air suspension gas type

Page 26 of 132

CHRYSLER 300 2013 2.G User Guide ENGINE BREAK-IN RECOMMENDATIONS
• A long break-in period is not required for the engine and drivetrain (transmission and axle) inyour vehicle.
• Drive moderately during the first 300 miles (500 km

ENGINE BREAK-IN RECOMMENDATIONS
• A long break-in period is not required for the engine and drivetrain (transmission and axle) inyour vehicle.
• Drive moderately during the first 300 miles (500 km). After the initial 60 miles (100 km), speeds up to 50 or 55 mph (80 or 90 km/h) are desirable.
• While cruising, brief full-throttle acceleration within the limits of local traffic laws contributes to a good break-in. Wide-open throttle acceleration in low gear can be detrimental and should
be avoided.
• The engine oil installed in the engine at the factory is a high-quality energy conserving type lubricant. Oil changes should be consistent with anticipated climate conditions under which
vehicle operations will occur. For the recommended viscosity and quality grades, refer to
“Maintaining Your Vehicle”.
NOTE:
A new engine may consume some oil during its first few thousand miles (kilometers) of opera-
tion. This should be considered a normal part of the break-in and not interpreted as an indica-
tion to an engine problem or malfunction.
CAUTION!
Never use Non-Detergent Oil or Straight Mineral Oil in the engine or damage may result.
Engine Break-In Recommendation — SRT8 Version
• A long break-in period is not required for the drivetrain (engine, transmission, and rear axle) in your new vehicle.
• Drive moderately during the first 500 miles (800 km). After the initial 60 miles (100 km), speeds up to 50 or 55 mph (80 or 90 km/h) are desirable.
• While cruising, brief full-throttle acceleration within the limits of local traffic laws contributes to a good break-in. However, wide-open throttle acceleration in low gear can be detrimental
and should be avoided.
• The engine oil is a high performance synthetic lubricant, the transmission fluid, and axle lubricant installed at the factory is high-quality and energy-conserving. Oil, fluid, and lubricant
changes should be consistent with anticipated climate and conditions under which vehicle
operations will occur. For the recommended viscosity and quality grades, refer to “Maintaining
Your Vehicle”.
NOTE:
A new engine may consume some oil during its first few thousand miles (kilometers) of operation.
This should be considered a normal part of the break-in and not interpreted as an indication of
difficulty.
CAUTION!
Never use Non-Detergent Oil or Straight Mineral Oil in the engine or damage may result.
OPERATING YOUR VEHICLE
24

Page 74 of 132

CHRYSLER 300 2013 2.G User Guide • Please note that the TPMS is not a substitute for proper tire maintenance, and it is the driver’sresponsibility to maintain correct tire pressure, even if under-inflation has not reached the lev

• Please note that the TPMS is not a substitute for proper tire maintenance, and it is the driver’sresponsibility to maintain correct tire pressure, even if under-inflation has not reached the level
to trigger illumination of the TPMS low tire pressure telltale.
• Your vehicle has also been equipped with a TPMS malfunction indicator to indicate when the system is not operating properly. The TPMS malfunction indicator is combined with the low
tire pressure telltale. When the system detects a malfunction, the telltale will flash for
approximately one minute and then remain continuously illuminated. This sequence will
continue each time the vehicle is restarted as long as the malfunction exists.
• When the malfunction indicator is illuminated, the system may not be able to detect or signal low tire pressure as intended. TPMS malfunctions may occur for a variety of reasons, including
the installation of replacement or alternate tires or wheels on the vehicle that prevent the
TPMS from functioning properly. Always check the TPMS malfunction telltale after replacing
one or more tires or wheels on your vehicle, to ensure that the replacement or alternate tires
and wheels allow the TPMS to continue to function properly.
NOTE:
Tire pressures change by approximately 1 psi (7 kPa) per 12° F (7° C) of air temperature change.
Keep this in mind when checking tire pressure inside a garage, especially in the Winter. Example:
If garage temperature is 68°F (20°C) and the outside temperature is 32°F (0°C), then the cold
tire inflation pressure should be increased by 3 psi (21 kPa), which equals 1 psi (7 kPa) for every
12°F (7°C) for this outside temperature condition.
CAUTION!
The TPMS has been optimized for the original equipment tires and wheels. TPMS pressures
and warning have been established for the tire size equipped on your vehicle. Undesirable
system operation or sensor damage may result when using replacement equipment that is not
of the same size, type, and/or style. Aftermarket wheels can cause sensor damage. Do not use
tire sealant from a can, or balance beads if your vehicle is equipped with a TPMS, as damage
to the sensors may result.
- Engine Temperature Warning Light
• This light warns of an overheated engine condition.
• If the light turns on or flashes continuously while driving, safely pull over and stop the vehicle. If the A/C system is on, turn it off. Also, shift the transmission into NEUTRAL and idle the
vehicle. If the temperature reading does not return to normal, turn the engine off immediately.
• We recommend that you do not operate the vehicle or engine damage will occur. Have the vehicle serviced immediately.
WARNING!
A hot engine cooling system is dangerous. You or others could be badly burned by steam or
boiling coolant. You may want to call an authorized dealer for service if your vehicle overheats.
WHAT TO DO IN EMERGENCIES
72

Page 104 of 132

CHRYSLER 300 2013 2.G User Guide SRT8
ComponentFluid, Lubricant, or
Genuine Part Capacities
Engine Coolant – 6.4L Engine We recommend you use
MOPAR® Antifreeze/Coolant Ten Year/150,000 Mile
Formula OAT (Organic Additive Technology

Page 121 of 132

CHRYSLER 300 2013 2.G User Guide Adaptive Cruise Control (ACC)(Cruise Control) ............27
Adjustable Pedals .............22
Airbag...................13
Arming Theft System (Security Alarm) . . .12
Automatic Headlights ...........

Adaptive Cruise Control (ACC)(Cruise Control) ............27
Adjustable Pedals .............22
Airbag...................13
Arming Theft System (Security Alarm) . . .12
Automatic Headlights ...........26
Automatic Temperature Control (ATC). . .34
Automatic Transmission Autostick ...............66
Fluid Type ..............100
Autostick .................66
Axle Fluid ............... .100
Belts, Seat .................13
Blind Spot Monitoring ...........35
Brake Fluid ............... .100
Break-In Recommendations, New Vehicle ..............24
Bulb Replacement .............115
Calibration, Compass ...........59
Change Oil Indicator ...........74
ChangingAFlatTire ...........76
Child Restraint ...............14
Child Restraint Tether Anchors .......15
Clock...................45
Compass Calibration ...........59
Cooling System Coolant Capacity ..........100
Cruise Control (Speed Control) ......27
Cruise Light ................27
Cupholders
Heated/Cooled (Beverage Holder). . .21
Customer Assistance ...........116
Customer Programmable Features . . .60, 69
Defects, Reporting ............117
Dimmer Control ..............26
Dimmer Switch, Headlight .........26
Disarming, Theft System ..........12
ECO....................59
Electronics Your Vehicle's Sound System .....38Electronic Speed Control
(Cruise Control) ............27
Electronic Vehicle Information Center (EVIC)...............59, 60
Emergency, In Case of Brake Warning Light ..........73
Jacking ................76
Overheating ..............75
Emergency Key ...............8
Engine Break-In Recommendations ......24
Compartment .............97
Oil Selection .............100
Overheating ..............75
Starting ................11
Stopping ................11
EventDataRecorder ...........94
Exterior Lights .............. .115
Flat Tire Changing .............76
Fluid Capacities .............100
Fluids .................. .100
Fog Lights .................26
Folding Rear Seat .............19
Freeing A Stuck Vehicle ..........93
Front Heated Seats ............20
Fuel Filler Door Emergency Release ....96
Filler Door (Gas Cap) .........95
Specifications ............100
Fuse .................. .110
Fuses .................. .110
Garage Door Opener (HomeLink®) ....61
Headlights Automatic ...............26
Dimmer Switch ............26
HighBeam ..............26
Heated Mirrors ...............35
Heated Seats ...............20
High Beam/Low Beam Select (Dimmer) Switch ............26
HomeLink® (Garage Door Opener) ....61
Hood Release ...............95
INDEX
119

Page 124 of 132

CHRYSLER 300 2013 2.G User Guide FREQUENTLY ASKED QUESTIONS
GETTING STARTED
• How do I install my LATCH Equipped Child Seat? pg. 15
• How do I program my Front Seat Memory? pg. 17
ELECTRONICS
• How do I know which radio I have?

airbag off heater height window brakes rear entertainment