2013 CHRYSLER 200 CONVERTIBLE roof

CONVERTIBLE TOP OPERATION
CAUTION!
Failure to follow these cautions may cause interior
water damage, stains or mildew on the top material:
•Avoid high-pressure car washes, as they can dam-
age the top material. Also, increased water pressure
may force water past the weather strips.
•Remove any standing water from the top and dry
the surface before opening it. Operating the top,
opening a door or lowering a window while the top
is wet may allow water to drip into the vehicles
interior.
•Use care when washing the vehicle, water pressure
directed at the weather strip seals may cause water
to leak into the vehicles interior.
WARNING!
The convertible top does not provide the structural
protection that a reinforced metal roof does and the
fabric top cannot be expected to prevent the ejection
of the occupants in a collision. Therefore, it is impor-
tant that all occupants wear their seat belts at all
times. Death or serious injuries could occur if you are
ejected from the vehicle during a collision.
You can lower or raise the power convertible top from
inside the vehicle or lower the top remotely using the
Remote Keyless Entry (RKE) transmitter. Either operation
takes approximately 30 seconds. The entire process, in-
cluding unlatching or latching the top at the windshield
header is automatic.
The top does take up some space in the trunk when
retracted. However, the trunk will still hold a significant
amount of cargo.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 101

Satellite Antenna
To ensure optimum reception, do not place items on the
roof around the rooftop antenna location. Metal objects
placed within the line of sight of the antenna will cause
decreased performance. Larger luggage items such as
bikes should be placed as far rearward as possible, within
the loading design of the rack. Do not place items directly
on or above the antenna.
Reception Quality
Satellite reception may be interrupted due to one of the
following reasons:
•The vehicle is parked in an underground parking
structure or under a physical obstacle.
•Dense tree coverage may interrupt reception in the
form of short audio mutes.
•Driving under wide bridges or along tall buildings can
cause intermittent reception.•Placing objects over or too close to the antenna can
cause signal blockage.
Operating Instructions - Uconnect™ Multimedia
(Satellite) Mode
NOTE:The ignition switch must be in the ON/RUN or
ACC position to operate the radio.
SEEK Buttons
Press and release the SEEK buttons to search for the next
channel in Satellite mode. Press the right switch to seek
up and the left switch to seek down. The radio will
remain tuned to the new channel until you make another
selection. Holding either button will bypass channels
without stopping until you release it.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 273

CavityCar-
tridge
FuseMini
FuseDescription
7 — 30 Amp
GreenIgnition Off Draw
(IOD) Sense 1
8 — 30 Amp
GreenIgnition Off Draw
(IOD) Sense 2
9 40 Amp
GreenBattery Feed –
Power Seats – If
Equipped
10 — 20 Amp
YellowInstrument Panel/
Power Locks/
Interior Lights
11 — 15 Amp
Lt BlueSelectable Power
Outlet (Inside Cen-
ter Arm Rest)CavityCar-
tridge
FuseMini
FuseDescription
12 — 20 Amp
Yellow—
13 — 20 Amp
YellowIgnition/Cigar
Lighter
14 — 10 Amp
RedInstrument Panel
15 40 Amp
Green— Radiator Fan Relay
16 — 15 Amp
Lt. BlueSunroof – If
Equipped
464 MAINTAINING YOUR VEHICLE

CavityCar-
tridge
FuseMini
FuseDescription
17 — 10 Amp
RedWireless Control
Module (WCM)/
Clock/Steering
Control Module
(SCM)
18 40 Amp
Green— Auto Shutdown
(ASD) Relay
19 — 20 Amp
YellowAudio Amplifier –
If Equipped
20 — 15 Amp
Lt. BlueRadio
21 — 10 Amp
RedSiren – If EquippedCavityCar-
tridge
FuseMini
FuseDescription
22 — 10 Amp
RedIgnition Run – Cli-
mate Controls/Hot
Cupholder – If
Equipped
23 — 15 Amp
Lt. BlueAuto Shutdown
(ASD) Relay 3
24 — 25 Amp
NaturalSunroof – If
Equipped
25 — 10 Amp
RedIgnition Run —
Heated Mirrors - If
Equipped
26 — 15 Amp
Lt. BlueAuto Shutdown
(ASD) Relay 2
7
MAINTAINING YOUR VEHICLE 465

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this vehicle’s
electronic system to provide immunity to radio frequency signals.
Mobile two-way radios and telephone equipment must be installed
properly by trained personnel. The following must be observed
during installation.
The positive power connection should be made directly to the
battery and fused as close to the battery as possible. The negative
power connection should be made to body sheet metal adjacent to
the negative battery connection. This connection should not be
fused.
Antennas for two-way radios should be mounted on the roof or the
rear area of the vehicle. Care should be used in mounting antennas
with magnet bases. Magnets may affect the accuracy or operation
of the compass on vehicles so equipped.The antenna cable should be as short as practical and routed away
from the vehicle wiring when possible. Use only fully shielded
coaxial cable.
Carefully match the antenna and cable to the radio to ensure a low
Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than normal
may require special precautions.
All installations should be checked for possible interference be-
tween the communications equipment and the vehicle’s electronic
systems.