2013 CHRYSLER 200 CONVERTIBLE instrument cluster

monitor tire pressure levels. Sensors, mounted to each
wheel as part of the valve stem, transmit tire pressure
readings to the Receiver Module.
NOTE:It is particularly important for you to check the
tire pressure in all of the tires on your vehicle monthly
and to maintain the proper pressure.
The TPMS consists of the following components:
•Receiver Module
•Four Tire Pressure Monitoring Sensors
•Three Trigger Modules (mounted in three of the four
wheel-wells)
•Various Tire Pressure Monitoring System Messages,
which display in the Electronic Vehicle Information
Center (EVIC)
•Tire Pressure Monitoring Telltale LightTire Pressure Monitoring Low Pressure Warnings
The “Tire Pressure Monitoring Telltale Light” will
illuminate in the instrument cluster and a chime
will sound when tire pressure is low in one or more of the
four active road tires. In addition, the Electronic Vehicle
Information Center (EVIC) will display a graphic show-
ing the pressure values of each tire with the low tire
pressure values flashing.
Should this occur, you should stop as soon as possible,
and inflate all tires with low pressure (those flashing in
the EVIC graphic) to the vehicle’s recommended cold
placard pressure value. Once the system receives the
updated tire pressures, the system will automatically
update, the graphic display in the EVIC will stop flash-
ing, and the “Tire Pressure Monitoring Telltale Light”
5
STARTING AND OPERATING 367

WARNING!
•Never have any smoking materials lit in or near the
vehicle when the gas cap is removed or the tank is
being filled.
•Never add fuel when the engine is running. This is
in violation of most state and federal fire regula-
tions and doing so may cause the MIL to turn on.
•A fire may result if gasoline is pumped into a
portable container that is inside of a vehicle. You
could be burned. Always place gas containers on
the ground while filling.NOTE:
•Tighten the gas cap until you hear a “clicking” sound.
This is an indication that the gas cap is tightened
properly. The MIL in the instrument cluster may turn
on if the gas cap is not secured properly. Make sure
that the gas cap is tightened each time the vehicle is
refueled.
•When the fuel nozzle “clicks” or shuts off, the fuel tank
is full.
Loose Filler Cap Message
If the vehicles diagnostic system determines that the fuel
filler cap in loose, improperly installed, or damaged, a
“gASCAP” message will be displayed in the instrument
cluster. Tighten the gas cap until a “clicking” sound is
heard. This is an indication that the gas cap is properly
tightened. Press the trip odometer reset button to turn off
the message. If the problem persists, the message will
5
STARTING AND OPERATING 381

CAUTION!
Driving with a hot cooling system could damage
your vehicle. If the pointer rises to the H (red) mark,
the instrument cluster will sound a chime. When
safe, pull over and stop the vehicle with the engine at
idle. Turn off the air conditioning and wait until the
pointer drops back into the normal range. If the
pointer remains on the H (red) mark for more than a
minute, turn the engine off immediately and call for
service.
WARNING!
You or others can be badly burned by hot engine
coolant (antifreeze) or steam from your radiator. If
you see or hear steam coming from under the hood,
do not open the hood until the radiator has had time
(Continued)
WARNING! (Continued)
to cool. Never try to open a cooling system pressure
cap when the radiator or coolant bottle is hot.
Engine Oil Overheating — 2.4L Engine Only (If
Equipped)
During sustained high-speed driving or trailer tow up
long grades on hot day, the engine oil temperature may
become too hot. If this happens, the “HOTOIL” message
flashes, the vehicle speed will be reduced to 53 mph
(85 km/h) until the engine oil temperature is reduced.
NOTE:Engine speed is reduced to 53 mph (85 km/h) at
the maximum. You may of course, reduce your speed
further if needed.
6
WHAT TO DO IN EMERGENCIES 399

ONBOARD DIAGNOSTIC SYSTEM — OBD II
Your vehicle is equipped with a sophisticated onboard
diagnostic system called OBD II. This system monitors
the performance of the emissions, engine, and automatic
transmission control systems. When these systems are
operating properly, your vehicle will provide excellent
performance and fuel economy, as well as engine emis-
sions well within current government regulations.
If any of these systems require service, the OBD II system
will turn on the “Malfunction Indicator Light” (MIL). It
will also store diagnostic codes and other information to
assist your service technician in making repairs. Al-
though your vehicle will usually be drivable and not
need towing, see your authorized dealer for service as
soon as possible.
CAUTION!
•Prolonged driving with the MIL on could cause
further damage to the emission control system. It
could also affect fuel economy and drivability. The
vehicle must be serviced before any emissions tests
can be performed.
•If the MIL is flashing while the engine is running,
severe catalytic converter damage and power loss
will soon occur. Immediate service is required.
Loose Fuel Filler Cap Message
After fuel is added, the vehicle diagnostic system can
determine if the fuel filler cap is possibly loose or
improperly installed. A “GASCAP” message will be
displayed in the instrument cluster. Tighten the gas cap
until aclickingsound is heard. This is an indication that
the gas cap is properly tightened. Press the trip odometer
“Reset” button to turn off the message. If the problem7
MAINTAINING YOUR VEHICLE 425

Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in this vehicle are
molded in clear plastic. When cleaning the lenses, care
must be taken to avoid scratching the plastic.
1. Clean with a wet soft rag. A mild soap solution may be
used, but do not use high alcohol content or abrasive
cleaners. If soap is used, wipe clean with a clean damp
rag.
2. Dry with a soft cloth.
Seat Belt Maintenance
Do not bleach, dye, or clean the belts with chemical
solvents or abrasive cleaners. This will weaken the fabric.
Sun damage can also weaken the fabric.
If the belts need cleaning, use MOPARTotal Clean or
equivalent, a mild soap solution, or lukewarm water. Do
not remove the belts from the vehicle to wash them. Dry
with a soft cloth.Replace the belts if they appear frayed or worn or if the
buckles do not work properly.
Cleaning Center Console Cupholders
Removal
Grab the rubber portion of the cupholder and lift up-
ward.
Cleaning
Soak the rubber cupholder liner in a mixture of medium
hot tap water and one teaspoon of mild liquid dish soap.
Let soak for approximately one hour. After one hour pull
the liner from the water and dip it back into the water
about six times. This will loosen any remaining debris.
Rinse the liner thoroughly under warm running water.
Shake the excess water from the liner and dry the outer
surfaces with a clean soft cloth.
7
MAINTAINING YOUR VEHICLE 459

High Beam...........................234
High Beam/Low Beam Select Switch.........180
On With Wipers........................179
Passing..............................181
Replacing............................470
Switch..............................178
Head Restraints..........................171
Heated Mirrors...........................128
Heated Seats.............................168
Heater.................................285
Heater, Engine Block.......................304
High Beam/Low Beam Select (Dimmer) Switch. . . .180
Hitches
Trailer Towing.........................386
HomeLink(Garage Door Opener) Transmitter. . . .192
Hood Prop..............................176
Hood Release............................175
Ignition.................................12Key .................................12
Lock.................................12
Ignition Key Removal.......................12
Illuminated Entry..........................21
Immobilizer (Sentry Key)....................15
Infant Restraint...........................69
Information Center, Vehicle..................236
Inside Rearview Mirror.....................125
Instrument Cluster........................219
Instrument Panel and Controls................218
Instrument Panel Cover.....................457
Instrument Panel Lens Cleaning...............459
Integrated Power Module (Fuses)..............462
Interior Appearance Care....................457
Interior Lighting..........................183
Intermittent Wipers (Delay Wipers).............185
Introduction..............................4
Jacking Instructions........................402
10
INDEX 505

Headlight Switch.......................178
High Beam...........................180
High Beam Indicator....................234
High Beam/Low Beam Select..............180
Illuminated Entry.......................21
Instrument Cluster......................178
Interior..............................183
License..............................474
Lights On Reminder.....................179
Low Fuel............................221
Malfunction Indicator (Check Engine)........233
Map Reading..........................183
Oil Pressure..........................222
Passing..............................181
Seat Belt Reminder......................222
Security Alarm (Theft Alarm)...............19
Service..............................470
Theft Alarm (Security Alarm)..............229
Tire Pressure Monitoring (TPMS)............231Traction Control........................338
Turn Signal............................95
Voltage..............................221
Warning (Instrument Cluster Description).....220
Loading Vehicle..........................382
Capacities............................383
Tires ................................345
Locks..................................31
Automatic Door........................33
Auto Unlock...........................33
Door................................31
Power Door...........................32
Low Tire Pressure System...................362
Lubrication, Body.........................437
Lumbar Support..........................170
Maintenance Free Battery....................433
Maintenance Procedures....................428
Maintenance Schedule.....................
.48010
INDEX 507

Vehicle Loading..........................346
Vehicle Modifications/Alterations...............7
Vehicle Storage...........................296
Vehicle Theft Alarm (Security Alarm)............18
Viscosity, Engine Oil.......................431
Voice Recognition System (VR)................160
Warning Lights (Instrument Cluster Description) . . .220
Warnings and Cautions.......................6
Warranty Information......................492
Washer
Adding Fluid.........................438
Washers, Windshield.......................184
Washing Vehicle..........................454
Water
Driving Through.......................324
Wheel and Wheel Trim.....................456
Wheel and Wheel Trim Care.................456
Wind Buffeting............................38Window Fogging.........................297
Windows................................34
Power...............................34
Windshield Defroster.......................93
Windshield Washers.......................184
Fluid...............................438
Windshield Wiper Blades....................438
Windshield Wipers........................184
Windstop...............................111
Folding..............................111
Wiper Blade Replacement...................438
Wipers, Intermittent.......................185
10
INDEX 515