High Beam...........................234
High Beam/Low Beam Select Switch.........180
On With Wipers........................179
Passing..............................181
Replacing............................470
Switch..............................178
Head Restraints..........................171
Heated Mirrors...........................128
Heated Seats.............................168
Heater.................................285
Heater, Engine Block.......................304
High Beam/Low Beam Select (Dimmer) Switch. . . .180
Hitches
Trailer Towing.........................386
HomeLink(Garage Door Opener) Transmitter. . . .192
Hood Prop..............................176
Hood Release............................175
Ignition.................................12Key .................................12
Lock.................................12
Ignition Key Removal.......................12
Illuminated Entry..........................21
Immobilizer (Sentry Key)....................15
Infant Restraint...........................69
Information Center, Vehicle..................236
Inside Rearview Mirror.....................125
Instrument Cluster........................219
Instrument Panel and Controls................218
Instrument Panel Cover.....................457
Instrument Panel Lens Cleaning...............459
Integrated Power Module (Fuses)..............462
Interior Appearance Care....................457
Interior Lighting..........................183
Intermittent Wipers (Delay Wipers).............185
Introduction..............................4
Jacking Instructions........................402
10
INDEX 505
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this vehicle’s
electronic system to provide immunity to radio frequency signals.
Mobile two-way radios and telephone equipment must be installed
properly by trained personnel. The following must be observed
during installation.
The positive power connection should be made directly to the
battery and fused as close to the battery as possible. The negative
power connection should be made to body sheet metal adjacent to
the negative battery connection. This connection should not be
fused.
Antennas for two-way radios should be mounted on the roof or the
rear area of the vehicle. Care should be used in mounting antennas
with magnet bases. Magnets may affect the accuracy or operation
of the compass on vehicles so equipped.The antenna cable should be as short as practical and routed away
from the vehicle wiring when possible. Use only fully shielded
coaxial cable.
Carefully match the antenna and cable to the radio to ensure a low
Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than normal
may require special precautions.
All installations should be checked for possible interference be-
tween the communications equipment and the vehicle’s electronic
systems.
