2013 CHEVROLET TAHOE auxiliary battery

Black plate (1,1)Chevrolet Tahoe Police and Special Service Packages - 2013 - CRC - 3/30/12
Special Equipment Options 15-1
Special Equipment
Options
SEO Standard Options
SEO Standard Options -Police Package and Special
Service Package . . . . . . . . . . . 15-2
Wiring Provisions for 12-Volt Battery Power Supply . . . . . . 15-3
Auxiliary Battery Power Junction Blocks . . . . . . . . . . . . 15-9
Equipment Grounding Studs - Rear Compartment . . . . . . 15-10
Radio Suppression Grounding Straps . . . . . . . . . 15-10
SEO Available Options
Dual Battery System -SEO 6A6 . . . . . . . . . . . . . . . . . . 15-10
Exterior Lamp Emergency Flashing System -
SEO 6J7 . . . . . . . . . . . . . . . . . . 15-11
Inactive Rear Door Handles - SEO 6B2 . . . . . . . . . . . . . . . . . . 15-14
Inactive Rear Door Locks - SEO 6N6 . . . . . . . . . . . . . . . . . 15-14
Inactive Rear Door Windows - SEO 6N5 . . . . . . . . . . . . . . . . 15-14
Spotlamp - SEO 7X6 . . . . . . . 15-14
Spotlamps - SEO 7X7 . . . . . . 15-14
Wiring Provisions for Emergency Vehicle Roof
Light - SEO TRW . . . . . . . . . 15-15 Wiring Provisions for Horn/
Siren Circuit - SEO 6J4 . . . 15-20
Wiring Provisions for Vehicle Grille Lamps and Speaker/
Siren - SEO 6J3 . . . . . . . . . . 15-22
Wiring Provisions Front Speakers - SEO WX7 . . . . . 15-24

Black plate (9,1)Chevrolet Tahoe Police and Special Service Packages - 2013 - CRC - 3/30/12
Special Equipment Options 15-9
relay, or equivalent. Replace a
50 amp circuit breaker with a GM
Part No. 15319848 circuit breaker,
or equivalent.
Reinstall the storage tray into the
compartment by lifting it into the
instrument panel.
Auxiliary Battery Power
Junction Blocks
Two auxiliary power junction blocks
are located within the driver side
rear cargo area jack stowage
compartment. Each junction block is
powered directly from the battery
through a 50 amp circuit breaker for
connection to customer‐furnished
equipment. The two circuit breakers
are located in the breaker/relay
panel forward of the instrument
panel glove box. A maximum load of
50 amps (600 watts) can be
connected to each junction block.
The wiring diagram for this circuit is
shown as part of the diagram for
“Wiring Provisions–12 Volt Battery
Power”. The two junction blocks are
connected to coiled 1.5 m (5 ft)
branches of the rear body harness
and fastened near the jack.
Mounting of the junction blocks can
be at customer‐selected rear cargo
area locations permitted by the
branch harness length and using
customer‐furnished mounting
hardware.
The junction blocks should not be
attached to the interior trim plastic
components without appropriate
backing hardware to the mounting
bolts.
To connect the customer-furnished
equipment at the junction blocks,
use the following steps:
1. Disconnect the negative (−)
battery cable.
2. Connect the customer-furnished equipment positive leads to the
junction block terminals and
tighten to 15 N·m (11 lb ft).
The ignition must be turned off
and the vehicle vacated prior to
connecting the negative (−)
battery cable to the battery.
3. Reconnect the negative (−) battery cable to the battery.
Torque the bolt to 5 Y
(3.6 lb ft).
4. Set the time on the clock and radio pushbuttons as needed.
See “Introduction” in the
Infotainment section of the
owner manual for more
information.

Black plate (17,1)Chevrolet Tahoe Police and Special Service Packages - 2013 - CRC - 3/30/12
Special Equipment Options 15-17
10. Reinstall the overhead consoleaccess panel/lamp lenses.
Restoring Power
The auxiliary lamp switch is located
on the overhead console.
This switch includes wiring
provisions for a dealer or a qualified
service center to install an auxiliary
roof lamp. When the wiring is
connected to an auxiliary roof
mounted lamp, pressing the bottom
of the switch will activate the lamp
and illuminate an indicator light at
the bottom of the switch. Pressing the top of the switch again
will turn off the roof mounted lamp
and indicator.
1. Be sure that the auxiliary lamp
switch is off.
2. Vacate the vehicle and reconnect the battery cable.
3. Turn the auxiliary lamp switch on. The accessory should now
be working. If it is not working,
check the connections.
4. After ensuring that the accessory is working properly,
install the grommet in the hole.
Seal with silicone sealer to
prevent water leakage.
Notice: Overloading the vehicle's
electrical system may damage
your vehicle's accessories.
Do not overload the vehicle's
system by having unnecessary
accessories on at the same time.
Option B
A. Black Wire
B. Orange Wire
C. To Roof Mounted Lamp
D. Harness Assembly
E. Grommet (Roof)
F. Foam Insulator (Adhesive‐ Backed)
G. Harness Connector, Secondary Lock and Terminal
H. Dark Green and Black Wires
I. Vehicle Outer Roof Panel

Black plate (24,1)Chevrolet Tahoe Police and Special Service Packages - 2013 - CRC - 3/30/12
15-24 Special Equipment Options
Wiring Provisions Front
Speakers - SEO WX7
About 165 cm (65 in) of auxiliary
speaker wire is run from the
instrument panel radio connector
and is coiled under the center of the
instrument panel. The wiring permits
the connection of front speakers to
customer-installed communication
equipment.Radio outputs from the front
speakers are sent to the rear
speakers to maintain the required
open door/key in the ignition
reminder chime
Electrical Connections
1. Disconnect the negative (−)
battery cable at the battery.
2. Remove the tape from the wire coiled under the instrument
panel to uncoil it.
3. Using proper electrical connectors, connect the
wires for the left front audio
output of the customer-installed
communication device. The left
front positive wire is tan and the
left front negative wire is gray.
4. Using proper electrical connectors, connect the
wires for the right front audio
output of the customer-installed
communication device. The right
front positive wire is light green
and the right front negative wire is dark green. The electrical
impedance of each speaker
installed is 10 ohms.
Notice: Overloading the vehicle's
electrical system may damage
your vehicle's accessories.
Do not overload the vehicle's
system by having unnecessary
accessories on at the same time.
5. The ignition must be turned off and the vehicle must be vacated
prior to attaching the cable to the
battery. Connect the negative (−)
battery cable to the battery and
tighten the bolt to 5 N·m
(3.7 lb ft).
6. Set the time on the clock and radio pushbuttons as needed.
See “Introduction” in the
Infotainment section of the
owner manual for more
information.

Black plate (1,1)Chevrolet Tahoe Police and Special Service Packages - 2013 - CRC - 3/30/12
INDEX i-1
A
AirbagsDeployment Diagrams . . . . . . . . . 3-4
Questions and AnswersAbout Airbags and
Specialty Law
Enforcement Vehicles . . . . . . . . 3-1
Auxiliary Available Option . . . . . . . . . . . . . . 15-9
Auxiliary Battery Power Junction Blocks, Available
Option . . . . . . . . . . . . . . . . . . . . . . . . 15-9
B
Battery
Dual System - SEO 6Y6 . . . . 15-10
Power Junction Blocks . . . . . . . 15-9
Wiring Provisions for12-Volt Power Supply . . . . . . . 15-3
C
Canadian Vehicle Owners . . . . . . . . . ii
Capacities andSpecifications . . . . . . . . . . . . . . . . 12-2
Circuit Wiring Provisions for
Horn/Siren - SEO 6J4 . . . . . 15-20
Cluster, Instrument . . . . . . . . . . . . . 5-2
Customer-installed Equipment, Notices . . . . . . . . . . . 3-3
D
Deployment Diagrams . . . . . . . . . . 3-4
Door LocksInactive Rear - SEO 6N6 . . . 15-14
Driver Information Center (DIC) . . . . . . . . . . . . . . . . . . 5-3
Driving
Vehicle Load Limits . . . . . . . . . . . . 9-1
Dual Battery System - SEO 6Y6 . . . . . . . . . . . . . . . . . . . . 15-10
E
Equipment GroundingStuds - Rear
Compartment . . . . . . . . . . . . . . . 15-10
Equipment Grounding Studs, Rear
Compartment . . . . . . . . . . . . . . . 15-10
Exterior Lamp Controls . . . . . . . . . 6-1
Exterior Lamp Emergency Flashing System -
SEO 6J7 . . . . . . . . . . . . . . . . . . . . 15-11