2013 BMW ACTIVE HYBRID 7 trailer

Switching off the alarm▷Unlock the vehicle using the remote con‐
trol.▷With Comfort Access: If you are carrying
the remote control with you, pull on the
driver side or front passenger side door
handle.
Indicator lamp on the interior rearview
mirror
▷The indicator lamp flashes briefly every
2 seconds:
The system is armed.▷The indicator lamp flashes after locking:
The doors, hood or trunk lid is not closed
properly, but the rest of the vehicle is se‐
cured.
After 10 seconds, the indicator lamp
flashes continuously. Interior motion sen‐
sor and tilt alarm sensor are not active.▷The indicator lamp goes out after unlock‐
ing:
The vehicle has not been tampered with.▷The indicator lamp flashes after unlocking
until the engine ignition is switched on, but
no longer than approx. 5 minutes:
An alarm has been triggered.
Tilt alarm sensor The tilt of the vehicle is monitored.
The alarm system responds in situations such
as attempts to steal a wheel or when the car is
towed.
Interior motion sensor
The windows and glass sunroof must be
closed for the system to function properly.
Avoiding unintentional alarms
The tilt alarm sensor and interior motion sen‐
sor can be switched off together, such as in
the following situations:▷In automatic car washes.▷In duplex garages.▷During transport on car-carrying trains, at
sea or on a trailer.▷When animals are to remain in the vehicle.
Switching off the tilt alarm sensor and
interior motion sensor
Press the remote control button again
within 10 seconds as soon as the vehicle
is locked.
The indicator lamp lights up for approx. 2 sec‐
onds and then continues to flash.
The tilt alarm sensor and interior motion sen‐
sor are switched off until the vehicle is locked
again.
Power windows
General information Take the remote control with you
Take the remote control with you when
leaving the vehicle so that children, for exam‐
ple, cannot operate the power windows and in‐
jure themselves.◀
Seite 47Opening and closingControls47
Online Edition for Part no. 01 40 2 909 774 - VI/13

If objects are located both in front of and be‐
hind the vehicle, an alternating continuous sig‐
nal is sounded.
The intermittent tone is interrupted after ap‐
prox. 3 seconds:▷If the vehicle stops in front of an object that
is detected by only one of the corner sen‐
sors.▷If moving parallel to a wall.
The signal tone is switched off:
▷When the vehicle moves away from an ob‐
ject by more than approx. 4 in/10 cm.▷When transmission position P is engaged.
Volume
The volume of the PDC signal can be adjusted,
refer to user's manual for Navigation, Enter‐
tainment, Communication.
The setting is stored for the remote control
currently in use.
Visual warning
The approach of the vehicle to an object can
be shown on the Control Display. Objects that
are farther away are displayed on the Control
Display before a signal tone sounds.
A display appears as soon as Park Distance
Control (PDC) is activated.
The range of the sensors is represented in the
colors red, green and yellow.
If the rearview camera image was selected last,
it again appears on the display. To switch to
PDC:
1. "Rear view camera" Select the symbol
on the Control Display.2.Press the controller.
The setting is stored for the remote control
currently in use.
System limits
Limits of ultrasonic measurement
The detection of objects can reach the physi‐
cal limits of ultrasonic measurement, e.g.:▷With tow bars and trailer hitches.▷With thin or wedge-shaped objects.▷With low objects.▷With objects with corners and sharp edges.
Low objects already displayed, e.g., curbs, can
move into the blind area of the sensors before
or after a continuous tone sounds.
High, protruding objects such as ledges may
not be detected.
False warnings
PDC may issue a warning under the following
conditions even though there is no obstacle
within the detection range:
▷In heavy rain.▷When sensors are very dirty or covered in
ice.▷When sensors are covered in snow.▷On rough road surfaces.▷In large buildings with right angles and
smooth walls, e.g., in underground ga‐
rages.▷In heavy exhaust.▷Due to other ultrasound sources, e.g.,
sweeping machines, high pressure steam
cleaners or neon lights.
Malfunction
A Check Control message is displayed.
The range of the sensors is shown as a shaded
area on the Control Display.
PDC has failed. Have the system checked.
To ensure full operability:
▷Keep the sensors clean and free of ice.Seite 146ControlsDriving comfort146
Online Edition for Part no. 01 40 2 909 774 - VI/13

Interrupting automaticallyThe system is interrupted automatically in the
following situations:▷If the driver grasps the steering wheel or if
he takes over steering.▷If a gear is selected that does not match
the instruction on the Control Display.▷If a turn signal is activated in the opposite
direction to the desired side for parking.▷If the vehicle speed exceeds approx.
6 mph/10 km/h.▷On snow-covered or slippery road surfaces
if necessary.▷If doors are open.▷When there are obstacles that are hard to
overcome, such as curbs.▷When there are obstacles that suddenly
arise.▷If a maximum number of parking attempts
or the time taken for parking is exceeded.
A Check Control message is displayed.
Continuing
An interrupted parking procedure can be con‐
tinued if necessary.
Follow the instructions on the Control Display
to do this.
System limits
No parking assistance The parking assistant does not offer assis‐
tance in the following situations:
▷In tight curves.
Functional limitations
The system may not be fully functional in the
following situations:
▷When sensors are dirty or iced over.▷In heavy fog, rain or snowfall.▷On bumpy road surfaces such as gravel
roads.▷On slippery ground.▷On steep uphill or downhill grades.▷When leaves or snow has collected in the
parking space.
Limits of ultrasonic measurement
The detection of objects can reach the physi‐
cal limits of ultrasonic measurement, e.g., in
the following circumstances:
▷With tow bars and trailer hitches.▷With thin or wedge-shaped objects.▷With elevated, protruding objects such as
ledges or cargo.▷With objects with corners and sharp edges.▷With objects with a fine surface structure,
such as fences.
Low objects already displayed, e.g., curbs, can
move into the blind area of the sensors before
or after a continuous tone sounds.
High, protruding objects such as ledges may
not be detected.
The parking assistant may identify parking
spaces that are not suitable for parking.
Malfunction
A Check Control message is displayed.
The parking assistant failed. Have the system
checked.
Seite 156ControlsDriving comfort156
Online Edition for Part no. 01 40 2 909 774 - VI/13

Electronic displays, instru‐ment cluster 86
Electronic Stability Program ESP, refer to DSC 130
Emergency detection, remote control 35
Emergency release, door lock 39
Emergency release, fuel filler flap 196
Emergency release, parking brake 75
Emergency Request 221
Emergency service, refer to Roadside Assistance 222
Emergency start function, en‐ gine start 35
Emergency unlocking, trunk lid 43
Energy recovery, CHARGE 74
Engine, automatic off 72
Engine compartment 206
Engine compartment, work‐ ing in 206
Engine coolant 210
Engine oil 208
Engine oil, adding 209
Engine oil additives 209
Engine oil change 209
Engine oil filler neck 209
Engine oil temperature 88
Engine oil types, alterna‐ tive 209
Engine oil types, ap‐ proved 209
Engine start during malfunc‐ tion 35
Engine start, jump-start‐ ing 222
Engine temperature 88
Entering/exiting vehicle, as‐ sistance, steering wheel 64
Entering a car wash 227
Equipment, interior 167 ESP Electronic Stability Pro‐
gram, refer to DSC 130
Exchanging wheels/tires 203
Exhaust system 182
Exterior mirror, automatic dimming feature 63
Exterior mirrors 62
External start 222
External temperature dis‐ play 89
External temperature warn‐ ing 89
Eyes for securing cargo 186
F
Failure message, refer to Check Control 86
False alarm, refer to Uninten‐ tional alarm 47
Fan, refer to Air flow 160
Fault displays, refer to Check Control 86
Filler neck for engine oil 209
Fine wood, care 229
First aid kit 222
Fitting for towing, refer to Tow fitting 225
Flat tire, changing wheels 218
Flat Tire Monitor FTM 108
Flat tire, Tire Pressure Moni‐ tor TPM 110
Flat tire, warning lamp 109, 111
Flooding 183
Floor carpet, care 230
Floor mats, care 230
Folding table in the rear 172
Fold-out position, windshield wipers 80
Foot brake 183
Front airbags 105
Front fog lamps 103
Front fog lamps, bulb replace‐ ment 217 Front passenger airbags, au‐
tomatic deactivation 107
Front passenger airbags, indi‐ cator lamp 107
Front passenger seat, adjust‐ ing 53
Front turn signals, refer to Light-emitting diodes,
LEDs 216
FTM Flat Tire Monitor 108
Fuel 198
Fuel cap 196
Fuel consumption, refer to Average fuel consump‐
tion 94
Fuel filler flap 196
Fuel gauge 88
Fuel quality 198
Fuel recommendation 198
Fuel, tank capacity 236
Functions, hybrid system 30
Fuse 220
G
Garage door opener, refer to Integrated universal remote
control 167
Gasoline 198
Gasoline quality 198
Gear change, automatic transmission 82
Gear shift indicator 91
General driving notes 182
Gentleman function 53
Glass sunroof, powered 50
Glove compartment 173
Gross vehicle weight, ap‐ proved 235
Gross weight, permissible for trailer towing 235
H
Handbrake, refer to Parking brake 74 Seite 241Everything from A to ZReference241
Online Edition for Part no. 01 40 2 909 774 - VI/13