2013 AUDI Q5 wiper blades

while driving. You can switch this function off by moving the lever to position ® within 10
seconds of the afterwipe operation. The after­
wipe function is reactivated the next time the ignit ion is switched on.
The rear wiper automatically switches on
when the reverse gear is engaged and the
front w indshield wipers are on and in opera ­
tion .
C lea ning the headlights *. The headlight wash ­
er system * operates on ly when the headlights
are on. If you move the lever to pos ition ®,
the headlights are washed in interva ls .
® -Wipe the rear window. The rear wiper
moves about every 4 seconds .
0-Clean the rear window. The number of
wiping operations depends on how long the l ever is held in positio n 7.
A WARNING
-The ra in sensor is only intended to assist
the driver. The driver is still responsible
for man ually sw itching the w ipers on ac­
cording to the v is ibility conditions.
- The windshie ld may not be treated w ith
water-repe lling windshie ld coat ing
agents. Unfavorable conditions, such as
wetness, darkness, low sun, can res ult in
increased glare. W iper b lade chatter is
also possible .
- Proper ly functioning w indshie ld w iper
blade s are required fo r a clear view and
sa fe dr iv ing .
(D Note
-In the case of frost, check whether the
windsh ield wiper b lades a re fro zen to
t h e windshie ld. Swit ching on the wind ­
s h ield wipers can d amage t he wipe r
blades!
- Prior to using a car w ash, the windshield
wipe r system m ust be swit ched off (lever
i n position 0) . This helps to prevent unin­
tentiona l switching on and damage to
the windshie ld w iper system.
Clear v is ion 5 5
(D Tips
- The windshie ld w ipers are switched off
when the ign it ion is tu rned off . Act ivate
the windsh ield wipers after the ignition
is switc hed back on by moving t he wind­
shield wipe r lever to any position .
- Worn or d irty windshield wiper blades
result in streaking. This ca n affect the
rai n sensor function. Check your wind­
shield w iper blades regularly.
- The washer fluid nozz les of the wind­
shield washe r system a re heated at low
tempe rat ures whe n the ignition is on .
- When stopping temporarily, e .g. at a
t raffic light, the set spe ed of the wind­
shield wiper s is automatically reduced by
one speed.
Service position
The windshield wiper blades ore replaced in
the service position.
"' If the w iper blades are no t frozen to t he
w indshield, br ing the w indshie ld w iper lever
to the basic position @¢
page 54, fig . 53 .
"' Sele ct: !CAR !func tion butt on> Windshield
wipers
> Service position . Or
"' Sele ct: I CAR I func tion b utton > Car sy s­
tem s*
contro l butto n > Servicing & checks >
Wiper service position . Or
"' Switch the ignit ion off and move the wind­
shield w iper lever to position ©¢
page 54,
fig . 53.
- On -changing the windshield wiper b lades
can only be done if you b ring the wiper arms
to the service position . You will also avoid
pai nt damage to the hood when working on
the wipe rs in th is posit ion .
-Off -the w indshield w ipers are moved to
their in itia l position again .
(D Note
Neve r mane uver yo ur vehicle with t he
front windshie ld w iper arms raised s ince
they wi ll automatically be moved back to

56 Clear vis ion
their basic position above a speed of 3
mph (6 km/h) and can scratch the hood .
(D Tips
-You can also use the service pos ition, for
example , if you want to protect the
windsh ield from icing by using a cover .
- The service position automatically
switches to
Off when you operate the
winds hield wiper lever , or speed exceeds
3 mph (6 km/h).
Replacing windshield wiper blades
Wiper blades in good condit ion help keep the
windshield cl ear .
Fig. 55 Remov ing t he w iper blade
Removing the wiper blade
""' Bring the wind shield wipers to the service
pos it ion
¢ page 55.
""' Fo ld the windshield wiper arm away from
the windshie ld .
""' Press the lo cking knob @¢
fig. 55 on the
wiper blade . Hold t he w iper blade fi rm ly.
""' Remove the w iper blade in the direc tion of
the arrow .
Attaching th e wiper blade
""' Insert the new wipe r blade into the mount
on the w iper arm @until you hear it latch
i n to place .
""' Place the wiper arm back on the windshie ld .
A WARNING
- Clean yo ur wipe r blades regular ly wit h a
w indshield washer solution to prevent
streaking . If the wiper blades are very
dirty, for example with insects, carefu lly clean the wiper blades with a sponge or a
soft brush.
- For your safety, yo u should replace the
wiper blades once or twice a year. See
your authori zed Audi dealer for replace­
ment b lades.
(D Note
- The windshie ld wi per blades must only
be replaced when in the service pos ition
¢
page 55! Otherwise, you risk damag­
ing the paint on the hood or the wind­
shield wipe r moto r.
- To help prevent damage to the w iper sys­
tem, always loosen blades wh ich are fro­
zen to the windshield before operating
w ipers .
- To help prevent damage to wiper blades,
do not use gasoline, kerosene, paint
thinner, or other solvents on o r near the
w iper blades.
- To help prevent damage to the w ip er
arms o r other compo nents, do not at­
t empt to move the wipe rs by hand .
(D Tips
Comme rc ial hot waxes applied by auto­
matic car washes affect t he how easily the
glass surfa ce ca n be cleaned.
Replacing the rear wiper blade
Fig . 56 Rea r w ipe r: Re mov ing t he w ipe r bl ade
Removing the wiper blade
""' Fold the windshie ld w iper arm away from
the wi ndshield .
""' Pull the w iper blade and holder out of the
g
q er a, II)
mou nt. .,.

Attaching the wiper bl ade
• Press the w iper blade holder in the arrow d i­
rect ion
c::> fig. 56 into the mount.
• Fold the windshield wiper arm back onto
the windshie ld .
A WARNING
- To prevent streaking, clean the wiper
blades regularly w ith a glass cleaner. In
the case of significant contamination,
e.g. from insect rema ins, the wiper
blades can be cleaned with a sponge or
cl oth.
- For safety reasons, the windsh ield wiper
blades sho uld be replaced once or twice
each year.
Mirrors
Adjusting the exterior mirrors
-
Fi g. 57 Forward section of dr iver 's armrest: power mir ·
ror co ntro ls
Adju sting e xterior m irrors
• Rotate the knob to the© position (driver's
exterior mirror) or to the® pos ition (pas·
senger's exterior mirror)
c::> fig. 57.
• Rotate the knob and the mirror so that you
have a clear view to the rear.
Heated mi rrors
• Rotate the knob to posit ion ® ·
Folding both e xterior mirrors*
• Turn the knob to pos it io n @ .
Depending on the outside temperature, the
m irror surfaces are heated unt il the ignition is
Clear vi sion 5 7
switched off -even if the knob is no longer in
position @.
You are we ll-advised to fold the exter ior mir·
rors in when maneuver ing in tight spaces o r
when leaving the car parked close to other
vehicles.
Memory for exterior mirrors*
On vehicles with memory for the drive r's seat,
the cur rent setting for the exter ior mirro rs is
automat ica lly stored a long w ith the sea t posi·
tion
c::> page 63.
Tilt function f or the passenger 's mirror*
(only with memory for e xterior mirrors )
When the reverse gear is engaged, the mirror
surface tilts downward slightly if the setting
is for the passenger's mirror (knob in position
®
c::> fig. 57) . This all ows you to see the curb
during parallel parking.
The mirror returns to its initial position as
soon as reverse gear is disengaged and vehicle
speed is above about 9 mph
(15 km/h). The
mirror also returns to its initial position if the
switch is moved to the dr iver's exterior mirror
© or the ignition is switched off .
If the position of the mirror surface is
changed on a tilted mirror, this new position
will be automatically assigned to the remote
key when the vehicle is taken out of reverse
gear .
(D Note
-Curved mirror surfaces (convex or spheri·
cal*) increase you r field of v iew . Remem­
ber that vehicles or other objects will ap­
pear smalle r and farther away than when
seen in a flat m irror.
If you use this mir ­
ror to estimate distances of following
vehicles when changing lanes, you could
estimate incorrectly and cause an acci·
dent.
- If the m irror housing is moved uninten­
tionally (for examp le, while pa rking your .,..

312 Index
Cruise control . . . . . . . . . . . . . . . . . . . . . . 17
Electromechanica l parking brake .. .. .. 18
Electronic power control ..... .. .... .. 15
Electronic Stabili zation Control (ESC) ... 15
High beam ................ .. .... .. 17
Malfunction Indicator Lamp (MIL) . .... 16
Safety belt .... .... ...... .. .. .. .. .. 16
Tire pressure monitoring system .. .. .. 16
Trailer turn signal assembly .... .. .... 16
Turn signals ............. .. .. .... .. 16
Warning lights ............. ... .. .. .. 14
Warranty coverages ............ .... . 295
Washer reservoir .......... .. .. .... . 247
Washing ...... ........... .. .. .... . 216
Automatic car wash ....... .. .. .. .. . 217
By hand .. .. ................ ... ... 217
General information ....... ..... .. . 216
Matte finish paint . ....... .. .. .. .. . 219
with a power washer ...... .. .. .... . 218
Waxing . .. .... ........... ........ . 220
Wear indicator .. ........ .. .. .. .... . 258
Weights ... .. ................ ... ... 290
What happens if you wear your safety belt
too loo se? ... ............. .. .. .. ... 153
What happens to unbelted occupants? .. 150
What impairs driving safety? ... .. .. .. . 140
What should I do after changing a
wheel? .. .. .. .. . .......... .. .. .... .
255
What should I do after replacing wheels? 255
Wheel bolts
Torque . .. .. ................ ... .. .
265
Wheels ... .. ..................... . 248
Cast alloy ............... .. .. .... . 222
Check ing tire pressure . .... .. .. .. .. . 254
Cold t ire inflation pressure ..... .. ... 252
General notes ... ...... .... ... .. .. . 248
Glossary of tire and load ing te rmin olo-
gy .. .. .. .... ........... .. .. .. .. .
249
New tires and wheels ...... .. .. .. .. . 259
Tires and vehicle load limits . ....... . 256
When must a safety belt be rep laced? .. 152
When must the airbag system be inspect-
ed? ... .. .. .. .. . .......... .. .. .... .
168
When should I adjust the tire pressures? 255
When should I check the tire pressures? . 255
Where are lower anchorages located? . .. 192 Where
can I find the tire pressures for my
car? ..... .. .... .. .. ... ........ .. ..
254
Why safety belts? . . . . . . . . . . . . . . 149, 150
Window regulators
Malfunctions .. .. .. .. ...... ... .. .. .
47
Power locks . . . . . . . . . . . . . . . . . . . . . . . 4 7
Windows Cleaning .. .... .. ............. .... 221
Defrost ing . . . . . . . . . . . . . . . . . . . . . . . .
81
Windshield
Defrosting .... .. .. ......... .. .. .. .
81
Windsh ie ld washer fluid
Low leve l .. .. .. . .............. .. .. .
33
Windsh ie ld wipers .. .............. .. . 54
Faulty ........ .. .. ........ ...... .. 35
Installing new wiper blades . . . . . . . . . . 56
Replac ing the rear wiper blade ........ 56
Service position . . . . . . . . . . . . . . . . . . . . 55
Washer reservoir . ............. .. .. 247
Winter operation
Battery . . . . . . . . . . . . . . . . . . . . . . . . . .
243
Coolant system .. ................ . 240
Defrosting windows ............ .. .. . 81
Seat heating . .. .. ............. .. ... 81
T ires . .... .... ................... 202
Windows ..... .. .. ... ... ..... .. .. 221
Winter tires ..... .. .. ........ ...... .
263
All-wheel drive ... ... .......... .. .. 263
Wiper b lades
Installing new wiper b lades . . . . . . . . . .
56
X
Xenon-L ights . . . . . . . . . . . . . . . . . . . 51, 283
y
Ye llow symbo ls . . . . . . . . . . . . . . . . . . . . . . 31