2013 Alfa Romeo 4C oil

PERIODIC CHECKSEvery 1,000 km or before long
journeys, check and, if necessary, top
up the following:
❒engine coolant level;
❒ brake fluid;
❒ screen washer fluid;
❒ tyre inflation pressure and condition;
❒ operation of lighting system
(headlamps, direction indicators,
hazard warning lights, etc.);
❒ operation of screen washing/wiping
system and positioning/wear of
wiper blade.
Every 3,000 km, check and top up if
required: engine oil level.
HEAVY-DUTY USE OF
THE CARIf the car is used mainly under one of
the following conditions:
❒ if the car is used under demanding
conditions, e.g. on track;
❒ dusty roads;
❒ short, repeated journeys (less than
7–8 km) at sub-zero outside
temperatures;
❒ engine often idling or driving long
distances at low speeds or long
periods of inactivity;
the following checks must be carried
out more often than indicated in the
Scheduled Servicing Plan:
❒ check of front and rear disc brake
pad condition and wear;
❒ check cleanliness of tailgate locks,
cleanliness and lubrication of linkage;
❒ visually inspect conditions of: engine,
gearbox, transmission, pipes and
hoses (exhaust - fuel system -
brakes) and rubber elements (boots -
sleeves - bushes - etc.);
❒ check battery charge and battery
fluid level (electrolyte);
❒ visually inspect condition of the
accessory drive belts; ❒
check and, if necessary, change
engine oil and replace oil filter;
❒ check and, if necessary, replace air
cleaner.
Using the car on track should be
regarded as an exception. The car has
been designed and produced for road
use.
138
SERVICING AND MAINTENANCE
24-9-2013 11:50 Pagina 138

CHECKING LEVELS.The topping-up plug B and the dipstick A for checking the engine oil level and the reservoir C for the engine coolant can be
accessed by lifting the tailgate (see the procedure in the "Bonnet/Luggage Compartment" paragraph in the "Knowing your car"
chapter).
19)113) 114) 115)110
A0L0152
139
24-9-2013 11:50 Pagina 139

ENGINE OIL
Check that the oil level is between the
MIN and MAX marks on the dipstick
A fig. 110.
For this check, take out the dipstick
from its seat, clean it with a lint-free
cloth, reinsert the dipstick; take it out
again and check the oil level.
116)
If the oil level is near or under the MIN
mark, add oil through the filler B fig.
110 until it reaches the MAX mark.
20)
Take out the engine oil dipstick A, clean
it with a lint-free cloth and reinsert it.
Extract the engine oil dipstick again and
check that the level is between the
MIN and MAX marks on the dipstick.
116)
The range between the MIN and MAX
levels corresponds to approximately
1 litre of oil.
Engine oil consumption
21)
3)
The maximum engine oil consumption
is usually 400 grams every 1,000 km.
When the car is new, the engine needs
to run in, therefore the engine oil
consumption can only be considered
stabilised after the first 5,000 - 6,000
km.IMPORTANT After adding or changing
the oil, let the engine run for a few
seconds and wait a few minutes after
stopping it before you check the level.
ENGINE COOLANT
22)
117)
The coolant level must be checked
when the engine is cold and must
range between the MIN and MAX
marks on the reservoir.
If the level is too low, unscrew reservoir
plug C fig. 110 and add the fluid
described in the "Fluids and lubricants"
paragraph of the "Technical
Specifications" chapter.
WINDSCREEN WASHER
FLUID
118) 119)
To check the windscreen washer fluid
level, proceed as follows:
❒
to avoid any interference during the
procedure, lift the windscreen wiper
blade according to the "Windscreen
wiper" paragraph in the
"Maintenance and care" chapter;
❒ loosen the 4 self-tapping screws A
fig. 112 using the supplied
screwdriver. Remove the bonnet
grille;
❒ release the plug from the opening; ❒
leaving the plug close to the opening,
put a finger on the central hole B fig.
113 in the plug and remove it: the
level can be seen on the control pipe
C fig. 114 due to capillarity;
❒ after the check, reinsert the plug B
with the control pipe C in the initial
position;
❒ reposition the bonnet grille and
tighten the 4 self-tapping screws A.
WARNING Re-close the plug holding it
horizontally (not directed towards the
bonnet) to prevent the opening tang
from remaining locked in a position
difficult to reach.
It is recommended to check the
windscreen washer fluid regularly, in
particular in driving conditions needing
a heavier use of the windscreen washer.
112
A0L0130
141
24-9-2013 11:50 Pagina 141

❒loosen the reservoir plug and
introduce the funnel F fig. 117 with
the extension pipe in the reservoir
inlet;
❒ after topping up, remove the funnel F
with the extension pipe;
❒ tighten the reservoir plug;
❒ reposition the protection panel and
tighten the 2 self-tapping screws E.
WARNING Be very careful while
removing the plug from the opening to
prevent the plug from falling inside
the vehicle body.
IMPORTANT
19) Be careful not to confuse the various types of fluids while
topping up: they are not
compatible with each other!
Topping up with an unsuitable
fluid could severely damage your
vehicle.
20) The oil level should never exceed the MAX mark.
21) Do not add oil with specifications other than those of the oil already
in the engine. 22) PARAFLU
UP
anti-freeze fluid is
used in the engine cooling
system; use the same fluid type as
that already in the cooling system
when topping up. PARAFLU
UP
may not be mixed with other types
of anti-freeze fluids. If topping up
with an unsuitable product, under
no circumstances start the engine
and contact a dedicated Alfa
Romeo Dealership.
23) Avoid allowing brake fluid, which is extremely corrosive, to come
into contact with painted areas.
Should it happen, immediately
wash with water.
24) Be very careful while topping up the brake fluid, as it could drip
from the extension pipe inside the
vehicle under-bonnet and on
parts of the body and windscreen,
corroding and damaging them.
Adopt suitable protection (e.g
absorbing paper) to reduce this
risk as much as possible.
116
A0L0149
117
A0L0160
143
24-9-2013 11:50 Pagina 143

WARNING
113) The Alfa Romeo 4C is designedand produced for road use, in
compliance with the current
regulations. Vehicle use in the
track must be considered as
occasional and in any case under
the responsibility of the user.
The vehicle CANNOT be modified
or tampered with for any reason,
this would alter the Manufacturer
homologation and/or safety
requirements. Using a modified or
tampered product relieves the
Manufacturer from any
responsibility on it and may
expose people to serious risks.
114) Never smoke when performing operations in the engine
compartment. Flammable gases
and fumes may be present, with
the risk of fire.
115) Be very careful when working in the engine compartment if the
engine is hot: risk of burns. 116) If the engine oil is being topped
up, wait for the engine to cool
down before loosening the filler
plug, particularly for cars with
aluminium plug (for versions/
markets, where provided).
WARNING: risk of burns!
117) The cooling system is pressurised. If necessary, only
replace the plug with another
original one or the operation of
the system may be adversely
affected. Do not remove the
reservoir plug when the engine is
hot: risk of burns.
118) Do not travel with the windscreen washer reservoir
empty: the windscreen washer is
essential for improving visibility.
Repeated operation of the system
without fluid could damage or
cause rapid deterioration of some
system components.
119) Certain commercial additives for windscreen washer fluids are
inflammable. The engine
compartment contains hot
components which may set it on
fire. 120) Brake fluid is poisonous and
highly corrosive. In the event of
accidental contact, immediately
wash the affected parts with
water and mild soap. Then rinse
thoroughly. Call a doctor
immediately if swallowed.
121) The
symbol on the container
indicates a synthetic brake fluid,
which is different from a mineral
fluid. Using a mineral fluid will
damage the special rubber seals
of the braking system beyond
repair.IMPORTANT
3) Used engine oil and oil filters contain substances which are
harmful to the environment. You
are advised to go to a dedicated
Alfa Romeo Dealership to have
the oil and filters changed.
144
SERVICING AND MAINTENANCE
24-9-2013 11:50 Pagina 144

IMPORTANT Never use alcohol. Make
sure that the cleaning products used
contain no alcohol or alcohol
derivatives, even in small quantities.
PLASTIC AND COATED
PARTS
Clean interior plastic parts with a damp
cloth (if possible made from microfibre),
and a solution of water and neutral,
non-abrasive detergent. To clean oily or
persistent stains, use specific products
free from solvents and designed to
maintain the original appearance and
colour of the components.
Remove any dust using a microfibre
cloth, if necessary moistened with
water. The use of paper tissues is not
recommended as these may leave
residues.
IMPORTANT Do not use alcohol,
petrols or derivatives to clean
the instrument panel display.LEATHER PARTS
(for versions/markets, where provided)
Use only water and neutral soap to
clean these parts. Never use alcohol or
alcohol-based products. Before using
a specific product for cleaning interiors,
make sure that it does not contain
alcohol and/or alcohol based
substances.
WARNING
132) Never use flammable products,
such as petroleum ether or
modified petrol, to clean the
inside of the car. The electrostatic
charges which are generated by
rubbing during the cleaning
operation may cause a fire.
133) Do not keep aerosol cans in the car: they might explode. Aerosol
cans must not be exposed to
temperatures above 50°C.
Temperatures may greatly exceed
this value inside a car exposed
to direct sunlight. 134) There should be no obstacles
on the floor underneath the
pedals; make sure that mats are
always flat and do not interfere
with the pedals.
152
SERVICING AND MAINTENANCE
24-9-2013 11:50 Pagina 152

FLUIDS AND LUBRICANTSYour car is equipped with an engine oil that has been thoroughly developed and tested in order to meet the requirements of the
Scheduled Servicing Plan. Constant use of the prescribed lubricants guarantees the fuel consumption and emission
specifications. Lubricant quality is crucial for engine operation and duration.
PRODUCT SPECIFICATIONS
UseFluid and lubricant specifications for a correct
use of the car Genuine fluids and
lubricants Replacement interval
Lubricant for
petrol engines
29)
SAE 5W-40 ACEA C3 grade totally synthetic
lubricant.
FIAT 9.55535-GH2 classification. SELENIA SPORT
POWER
Contractual Technical
Reference No. F052.H12According to
Scheduled Servicing
Plan
In case of emergency, if lubricants with the prescribed specifications are not available, products with the minimum indicated
ACEA performance can be used for topping up; in this case optimal performance of the engine is not guaranteed.
IMPORTANT
29) The use of products with specifications other than those indicated above could cause damage to the engine not covered by the warranty.
171
24-9-2013 11:50 Pagina 171

Engine codes ................................ 156
Engine compartment – checking levels .......................... 139
– washing .................................... 150
Engine coolant indicator ................. 62
Engine – engine cooling system fluid level........................................... 141
– identification codes ................... 156
– marking ..................................... 155
– technical data............................ 157
Engine oil – consumption ............................. 141
– level check ................................ 141
EOBD system ................................ 48
ESC (Electronic Stability Control) system ......................................... 41
Exterior lights ................................. 26
Extinguisher ................................... 35Filling the tank ............................... 56
Fitting "Universal" child restraint system ......................................... 94
Fix&Go automatic kit ...................... 115
Flashing ......................................... 27
Fluids and lubricants (specifications) ............................. 171"Follow Me Home" device ............. 28Front airbags................................. 97
Fuel consumption .......................... 174
Fuel cut-off system......................... 32 Fuel level gauge ............................. 62
Fuel supply..................................... 158
Fuses (replacement) ....................... 126
Gear Shift Indicator ....................... 62Handbrake.................................... 103
Hazard warning lights..................... 32
HBA system ................................... 43
Headlights...................................... 40 – Adjusting the headlights abroad ...................................... 40
– bulb replacement ...................... 122
– Light beam direction.................. 40
Heating and ventilation ................... 21
Hill Holder system .......................... 43Identification data – bodywork paint plate ................. 154
– chassis marking ........................ 154
– engine marking.......................... 155
Identification data – identification data plate.............. 154
Ignition switch ................................ 14 – Steering lock ............................. 15
Installing electrical/electronic devices ........................................ 49
Instrument panel ............................ 60
Interior fittings ................................ 33
Interiors (cleaning) .......................... 151Light clusters – front light clusters (changing a
bulb).......................................... 122
– rear light clusters (changing a bulb).......................................... 123
Lubricants (specifications) .............. 171
Luggage compartment / Bonnet .... 38
Luggage compartment – Opening .................................... 38
Luggage compartment roof light – bulb replacement ...................... 125
M
ain beam headlights .................. 27
– bulb replacement ...................... 122
Maintenance and care – heavy-duty use of the car .......... 138
– periodic checks ......................... 138
– scheduled servicing ................... 134
– scheduled servicing plan ........... 135
Manual climate control ................... 24
Menu options ................................. 64
Number plate lights
– bulb replacement ...................... 124O
ddments pocket......................... 34
On-board instruments – display....................................... 60
– engine coolant temperature indicator .................................... 62
– fuel level gauge ......................... 62
– On-board instruments ............... 60
– rev counter ................................ 62