2013.5 PEUGEOT 2008 instrument panel

1
21
Monitoring
LCD instrument panel
1. Engine coolant temperature gauge. 2. Rev counter (x 1 000 rpm or tr/min), graduation according to engine (petrol or Diesel). 3. Engine oil level indicator * . 4. Gear shift indicator for a manual gearbox or gear lever position and gear for an electronic or automatic gearbox. 5. Digital speedometer (mph or km/h) This can be switched off with a long press on B .
A. General lighting dimmer. B. Recalling the service information. Resetting the function selected (service indicator or trip distance recorder). Setting the time. Switching the digital speedometer on and off.
6. Cruise control or speed limiter settings. 7. Service indicator, then total distance recorder (miles or km). These functions are displayed successively on switching on the ignition. 8. Trip distance recorder (miles or km). 9. Analogue speedometer (mph or km/h). 10. Fuel gauge.
Dials and screens Control buttons
* Depending on version.

22
Monitoring
Active matrix instrument panel
Dials and screens Control buttons
1. Engine coolant temperature gauge. 2. Rev counter (x 1 000 rpm or tr/min), graduation according to engine (petrol or Diesel). 3. Cruise control or speed limiter settings. 4. Gear shift indicator for a manual gearbox or gear lever position and gear for an electronic or automatic gearbox. 5. Speedometer (mph or km/h).
A. Main lighting dimmer. B. Instrument panel mood lighting. C. Recall of the service information. Reset the selected function (service indicator or trip distance recorder).
6. Service indicator, then total distance recorder (miles or km). These functions are displayed successively on switching on the ignition. 7. Trip distance recorder (miles or km). 8. Analogue speedometer (mph or km/h). 9. Fuel gauge.

1
23
Monitoring
Indicator and warning lamps
Certain warning lamps may come on in one of two modes. Only by relating the type of lighting to the operating status of the vehicle can it be ascertained
whether the situation is normal or whether a fault has occurred.
When the ignition is switched on
Certain warning lamps come on for a few seconds in the instrument panel and/or instrument panel screen when the vehicle's ignition is switched on. When the engine is started, these same warning lamps should go off. If they remain on, before moving off, refer to the information on the warning lamp concerned.
Associated warnings
The switching on of certain warning lamps may be accompanied by an audible signal and a message in the instrument panel or multifunction screen. The warning lamps may come on continuously (fixed) or flash.
Visual indicators informing the driver that a system is switched on (indicator or deactivation lamp) or has a fault (warning lamp).

24
Monitoring
Operation indicator lamps
If one of the following indicator lamps comes on in the instrument panel and/or instrument panel screen, this confirms that the corresponding system has come into operation.
Warning / indicator lampStateCauseAction / Observations
Left-hand direction indicatorr r flashing with buzzer. The lighting stalk is pushed down.
Right-hand
direction indicatordirection indicator direction indicator
flashing with buzzer. The lighting stalk is pushed up.
Sidelamps fixed. The lighting stalk is in the "Sidelamps" position.
Dipped beam headlamps fixed. The lighting stalk is in the "Dipped beam headlamps" position.
Main beam headlamps fixed. The lighting stalk is pulled towards you. Pull the stalk to return to dipped beam headlamps.
Front foglamps fixed. The front foglamps are switched on. Turn the ring on the stalk rear wards twice to switch off the front foglamps.
Rear foglamp fixed. The rear foglamp is switched on. Turn the ring on the stalk rear wards to switch off the rear foglamp.
For more information on the lighting controls, refer to the corresponding section.

26
Monitoring
Warning / indicator lampStateCauseAction / Observations
Foot on the clutch * fixed. In the STOP mode of Stop & Start, changing to START mode is refused because the clutch pedal is not fully down.
You must declutch fully to allow the change to engine START mode.
Stop & Star t fixed. When the vehicle stops (red lights, traffic jams, ...) the Stop & Start system has put the engine into STOP mode.
The warning lamp goes off and the engine restarts automatically in START mode, as soon as you want to move off.
flashes for a few seconds, then goes of f.
STOP mode is temporarily unavailable. or START mode is invoked automatically.
For more information on special cases with STOP mode and START mode, refer to the "Stop & Start" section.
Automatic wiping fixed. The wiper control is pushed downwards. Automatic front wiping is activated. To deactivate automatic wiping, operate the control stalk downwards or put the stalk into another position.
* Except for the active matrix instrument panel.

34
Monitoring
Lighting dimmer control
System for the manual adjustment of the brightness of the instrument panel and the touch screen to suit the ambient light level.
Two buttons
With the headlamps on, press button B to increase the brightness of the instruments and controls and the interior mood lighting or button A to reduce it. As soon as the lighting reaches the required level of brightness, release the button.
One button
Activation press the button to adjust the brightness of the instruments and controls,  release the button when the desired level is attained.
Touch screen
 Press MENU to display the "MAIN MENU"then select "Preferences" .  Select "System Configuration" then "Brightness" .  Press "Turn off screen" . The screen goes off completely. Press the screen again (anywhere on the sur face) to activate it. Switching off When the vehicle lighting is off or in day mode (daytime running lamps on), pressing the button has no effect.

1
37
Monitoring
Engine oil level indicator *
Oil level incorrect
This is indicated by the flashing of " OIL " or OIL " or OILby the display of a dedicated message in the instrument panel. If the low oil level is confirmed by a check using the dipstick, the level must be topped up to
avoid damage to the engine.
Oil level indicator fault
This is indicated by the flashing of " OIL _ _" or
by the display of a dedicated message in the instrument panel. Contact a PEUGEOT dealer or a qualified workshop.
Dipstick
Refer to the "Checks" section to locate the dipstick and the oil filler cap on your engine.
There are 2 marks on the dipstick:
The total mileage is displayed in zone A of the screen and the trip mileage in zone B .
With the trip mileage displayed, press the button for a few seconds.
Mileage recorder
Trip recorder zero reset
System which informs the driver whether the engine oil level is correct or not. This information is indicated for a few seconds when the ignition is switched on, after the service information.
The level read will only be correct if the vehicle is on level ground and the engine has been off for more than 30 minutes.
- A = max; never exceed this level, - B = min; top up the level via
the oil filler cap, using the grade of oil suited to your engine.
Oil level correct
* Depending on version.

38
Monitoring
System that gives you information on the journey in progress (range, fuel consumption…).
Trip computer
Instrument panel screen
Information display
 Press the button on the end of the wiper control stalk to display the various tabs in succession.
- The current information tab with: ● t h e r a n g e , ● the current fuel consumption, ● the Stop & Start time counter.
- Trip "1" with: ● the average speed. ● the average fuel consumption, ● the distance travelled, for the first trip.
- Trip "2" with: ● the average speed, ● the average fuel consumption, ● the distance travelled, for the second trip.