2013.5 Citroen DS5 HYBRID4 RHD bulb

CHECKS
PR ACTICAL
INFORMATION TECHNICAL DATA
AUDIO and
TELEMATICS
212 Temporary puncture repair kit
218 Changing a wheel
226 Snow chains
227 Changing a bulb
235 Changing a fuse
238 12 V battery
241 Energy economy mode
242 Changing a wiper blade
243 Recovery on a fl at-bed
244 Towing a trailer
246 Fitting roof bars
247 Accessories
253 Opening the bonnet
254 Diesel engine
255 Running out of fuel (Diesel)
256 Checking levels
260 Checks
266 Electric motor
267 Diesel engine
268 Diesel weights
269 Dimensions
270 Identifi cation markings
2 74 Emergency or assistance
277 eMyWay
331 Audio system
0080090100 11

Manual adjustment
of halogen
headlamps Automatic adjustment of xenon headlamps
To avoid causing a nuisance to other road users, the height of the halogen headlamps should be adjusted according to the load in the vehicle. 0. 1 or 2 people in the front seats. -. Intermediate setting. 1. 5 people + maximum authorised load. -. Intermediate setting. 2. Driver + maximum authorised load. -. Intermediate setting. 3. 5 people + maximum load in the boot.
The initial setting is position "0" .
If a fault occurs, this warning lamp is displayed in the instrument panel, accompanied by an audible signal and a message in the instrument panel screen. The system then places your headlamps in the lowest position.
In order to avoid causing a nuisance to other road users, this system corrects the height of the xenon headlamps beam automatically and when stationary, in relation to the load in the vehicle.
If a fault occurs, do not touch the xenon bulbs. Contact a CITROËN dealer or a qualified workshop.

227Practical information
Changing a bulb
Front lamps
Model with xenon headlamps
1. Main beam headlamps (H1-35W).2. Directional dipped / directional
headlamps (D1S - 35 W ).3. Daytime running lamps / sidelamps (light emitting diodes - LEDs).4. Direction indicators (HY21-21W).5. Directional foglamps ( H11) .
Model with halogen headlamps
1. Main beam headlamps (H1-55W).2. Dipped beam headlamps (H7-55W).3. Daytime running lamps/sidelamps (Light emitting diodes - LEDs).4. Direction indicators (HY21-21W).5. Directional foglamps ( H11) .
For H7 type bulbs with lugs... take care to observe their correct installation so as to ensure the best lighting per formance.
In some weather conditions (e.g. low temperature or humidity), the presence of misting on the internal sur face of the glass of the headlamps and rear lamps is normal; it disappears after the lamps have been on for a few minutes.
Risk of electrocution
Xenon bulbs (D1S-35W) must be replaced by a CITROËN dealer or a qualified workshop.
Before doing any work on your vehicle, switch off the ignition ( Ready lamp off) to avoid any risk of injury resulting from automatic operation of the engine.

Main beam headlamps (xenon model)
 Remove the protective plastic cover by pulling on the tab.  Remove the connector with the bulb by pressing on the lug at the bottom.  Remove the bulb and change it. For reassembly, carry out these operations in reverse order.
The headlamps are fitted with polycarbonate glass with a protective coating:  do not clean them using a dr y or abrasive cloth, nor with a detergent or solvent product, use a sponge and soapy water or a pH neutral product,  when using a high pressure washer on persistent marks, do not keep the lance directed towards the lamps or their edges for too long, so as not to damage their protective coating and seals.
Dipped beam headlamps (xenon model)
D1S xenon bulbs must be changed by a CITROËN dealer or a qualified workshop, as there is a risk of electrocution. It is recommended that the D1S bulbs are changed at the same time when one of them fails.
Changing a bulb should only be done after the headlamp has been switched off for a few minutes (risk of serious burns).  Do not touch the bulb directly with your fingers, use a lint-free cloth. It is imperative to use only anti-ultraviolet (UV) type bulbs to avoid damaging the headlamp. Always replace a failed bulb with a new bulb with the same type and specification.

229Practical information
Dipped beam headlamps
(halogen model)
 Remove the protective plastic cover by pulling on the tab.
Main beam headlamps
(halogen model)
 Remove the protective plastic cover by pulling on the tab.  Remove the connector with the bulb by pressing on the lug at the bottom.  Remove the bulb and change it. For reassembly, carry out these operations in reverse order.
 Press on the top of the connector then pivot the assembly downwards.  Remove the connector with the bulb.  Remove the bulb and change it. For reassembly, carry out these operations in reverse order, but engaging the bottom of the bulb first.

Daytime running lamps / sidelamps
For the replacement of this type of LED lamp and lighting guides, contact a CITROËN dealer or a qualified workshop. A replacement kit for the LEDs is available from CITROËN dealers.
Direction indicators
Faster flashing of a direction indicator warning lamp (left or right) indicates a failed bulb on that side.
The direction indicator bulb is located below the front lamp.  Turn the bulb holder a quarter turn and pull it out.  Remove the bulb and change it.
For reassembly, carry out these operations in reverse order. You can also contact a CITROËN dealer or a qualified workshop for the replacement of these bulbs.

231Practical information
Front foglamps
 Remove the deflector under the body.  Disconnect the bulb connector.  Turn the bulb a quarter of a turn, withdraw and change it. To refit, carry out these operations in reverse o r d e r. To replace these bulbs you may also contact a CITROËN dealer or a qualified workshop.
Integrated direction indicator side repeaters
You should contact a CITROËN dealer or a qualified workshop for the replacement of these bulbs.
Door mirror spotlamps
You should contact a CITROËN dealer or a qualified workshop for the replacement of the light emitting diode - LED.

1. Sidelamps (light emitting diodes - LEDs).2. Direction indicators (PY21W amber).3. Reversing lamps (P21W).4. Brake lamps (P21W).5. Foglamps (P21W).
Rear lamps
Direction indicators and brake lamps (on the wings)
 Open the boot then remove the access cover.  Disconnect the lamp connector.  Remove the two lamp fixing nuts.
 Carefully remove the lamp unit from outside. The retaining clips unclip automatically.  Turn the bulb holder a quarter of a turn and change the bulb. For reassembly, carry out these operations in reverse order.
Light emitting diodes-LEDs
For replacement, contact a CITROËN dealer or qualified workshop.