2013.5 Citroen C4 RHD change time

23
FAMILIARISATION

Stop & Start


Engine going into STOP mode
Engine going into START mode
Deactivation / Reactivation
In certain circumstances the STOP
mode may not be available; the "ECO"

warning lamp fl ashes for a few seconds
then goes off.

- with a manual gearbox;
at speeds
below 12 mph (20 km/h), when you
put the gear lever into neutral, and
you release the clutch pedal,

- with an electronic gearbox;
at
speeds below 5 mph (8 km/h), when
you press the brake pedal or you
put the gear lever in position N
.



163


- with a manual gearbox;
when you
fully
depress the clutch pedal,

- with an electronic gearbox;



●
with the gear lever in position A

or M
, when you release the brake
pedal,

●
or gear lever in position N
and
brake pedal released, when you
change to position A
or M
,

●
or engage reverse.

In certain circumstances, START mode
may engage automatically; the "ECO"

warning lamp fl ashes then goes off.



164
You can deactivate the system at any
time by pressing the "ECO OFF"
button;
the button's warning lamp comes on.



164

The "ECO"
warning lamp goes
off and the engine restarts au-
tomatically:
The "ECO"
warning lamp comes on
in the instrument panel and the engine
is put into standby automatically:
The system is reactivated auto-
matically every time you start the
engine with the key.

Before refuelling or doing any-
thing under the bonnet, you
must switch off the ignition with
the key.
DRIVING SAFELY

27

Switch off the headlamps and front
foglamps when the level of light does
not require their use.

Avoid running the engine before moving
off, particularly in winter; your vehicle
will warm up much faster while driving.

As a passenger, if you avoid connecting
your multimedia devices (fi lm, music,
video game...), you will contribute to-
wards limiting the consumption of elec-
trical energy, and so of fuel.
Disconnect your portable devices be-
fore leaving the vehicle.



Limit the causes of excess
consumption

Spread loads throughout the vehicle;
place the heaviest items in the bottom
of the boot, as close as possible to the
rear seats.
Limit the loads carried in the vehicle
and reduce wind resistance (roof bars,
roof rack, bicycle carrier, trailer...). Use
a roof box in preference.
Remove roof bars and roof racks after
use.

At the end of winter, remove snow
tyres and refi t your summer tyres.



Observe the recommendations
on maintenance

Check the tyre pressures regularly,
when cold, referring to the label in the
door aperture, driver's side.
Carry out this check in particular:


- before a long journey,

- at each change of season,

- after a long period out of use.
Don't forget the spare wheel and the
tyres on any trailer or caravan.

Have your vehicle serviced regularly
(engine oil, oil fi lter, air fi lter...) and ob-
serve the schedule of operations rec-
ommended by the manufacturer.



When refuelling, do not continue after
the third cut-off of the nozzle to avoid
any overfl ow.


At the wheel of your new vehicle, it is only
after the fi rst 1 800 miles (3 000 kilometres)
that you will see the fuel consumption set-
tle down to a consistent average.

1
MONITORING
46












Distance recorders

The total and trip distances are dis-
played for thirty seconds when the ig-
nition is switched off, when the driver's
door is opened and when the vehicle is
locked or unlocked.

Trip distance recorder
Total distance recorder
















Setting the time and the time
format in the instrument panel
without audio system

On the two-tone instrument panel with-
out audio system, to adjust the time,
use buttons A
and B
then carry out the
operations in the following order:



press buttons A
and B
simultane-
ously: the minutes fl ash,


press A
to increase the minutes or
B
to reduce the minutes,


press buttons A
and B
simultane-
ously: the hours fl ash,


press A
to increase the hours or B

to reduce the hours,


press buttons A
and B
simultane-
ously: 24 H or 12 H is displayed and
fl ashes,


press button A
or B
to change the
format,


press buttons A
and B
simultane-
ously to exit from time setting.


After approximately 30 seconds without any ac-
tion, the screen returns to the normal display.

Measures the total distance travelled
by the vehicle since its fi rst registration.

Measures the distance travelled since it
was last reset to zero by the driver.



With the ignition on, press and hold
this button until zeros appear.

On the two-tone instrument panel with-
out audio system, to change the display
units, use buttons A
and B
then carry
out the operations in the following order:



press buttons A
and B
simultane-
ously for three seconds: km/h or
mph fl ashes,


press button A
or B
to change the
units,


press buttons A
and B
simultane-
ously to exit from setting units.
After approximately 30 seconds without
any action, the screen returns to the
normal display



Setting units in the instrument
panel without audio system

Setting the time and units in the
multifunction screen
The other instrument panels are as-
sociated with an audio system and a
multifunction screen. Refer to the cor-
responding screens.

1
MONITORING
47
System allowing certain screens to be
switched off for night driving.
The instrument panel remains on with
the vehicle speed, electronic or auto-
matic gearbox gear selected, cruise
control or speed limiter information, if
in use, and the low fuel alerts as ap-
propriate.
If there is an alert or a change in a
function or to a setting, the black panel
mode is interrupted.






Black panel (black screen)


Activation



With the vehicle lighting on, press
this button again to activate the
black panel.


Press once more to illuminate on
the various screens again.



Permits manual adjustment of the bright-
ness of the instruments and controls in rela-
tion to the exterior brightness. Only operates
when the vehicle lighting is on in night mode.









Lighting dimmer


Activation



Press button A
to change the bright-
ness of the instruments and controls.


When the lighting reaches the mini-
mum setting, release the button,
then press again to increase it.
or



When the lighting reaches the maxi-
mum setting, release the button,
then press again to reduce it.


When the lighting reaches the level
of brightness required, release the
button.
Deactivation
When the vehicle lighting is off, or in
day mode (daytime running lamps
on), pressing the button or turning the
thumb wheel does not have any effect.
You can also modify the level of lighting
by turning the thumb wheel B
, located
on the left of the steering wheel:



upwards; to reduce the level,


downwards; to increase the level.
This indicator and the lighting
value appear in the middle of
the instrument panel during
adjustment to show the lighting
level compared to the 16 levels avail-
able.

1
MONITORING
48
In the instrument panel, you can change
the colour of its dials (button A
) indepen-
dently from that of the screens (button B
).
There are fi ve colour variants, from
white to blue.



press the appropriate button as
many times as needed to obtain the
desired colour.
This menu allows you to choose a fam-
ily of polyphonic sounds from the four
available. These sounds are grouped
together in a family and are adapted
to suit the situation and context (alert,
confi rmation, rejection, direction indica-
tors, lighting left on, key in ignition...).






Customising the instrument
panel colours





Customising the polyphonic
sounds

For the customisable colour
instrument panel with audio or
navigation system



Press the "MENU"
button for ac-
cess to the main menu.


Select the "Personalisation-confi -
guration" menu and confi rm.


Select the "Choice of sounds" line
and confi rm.


Select the desired family of sounds
and confi rm.


Save the modifi cations by confi rm-
ing "OK". For safety reasons, the driver
must only carry out these opera-
tion when stationary.

2
MULTIFUNCTION SCREENS
49































MONOCHROME SCREEN A

Displays in the screen

This displays the following information:


- time,

- date,

- ambient temperature (this fl ashes if
there is a risk of ice),

- current audio source,

- trip computer (refer to the end of the
section),

- alert messages,

- settings menus for the screen and
the vehicle equipment.
From the control panel of your audio
system, you can press:



the "MENU"
button for access to
the main menu
,


the " 
" or " 
" buttons to scroll
through the items on the screen,


the " 
" or " 
" buttons to change a
setting value,


button A
to change the permanent
application (trip computer, audio
source...),


the "OK"
button to confi rm,
or


the "Back"
button to abandon the
operation in progress.



Controls




Press the "MENU"
button for ac-
cess to the main menu
, then press
the " 
" or " 
" buttons to scroll
through the various menus:


- "RADIO",

- "MEDIA",

- "TRIP COMPUTER",

- "DATE AND TIME",

- "LANGUAGES",

- "VEHICLE PARAM",


Press the "OK"
button to select the
menu required.


Main menu


Radio / Media
With the audio system switched on,
once the "RADIO" or "MEDIA" menu
has been selected you can activate
or deactivate the functions associated
with use of the radio (RDS, Radio text)
or select the media play mode (normal,
random, repeat).
For more information on the "RADIO" or
"MEDIA" application, refer to the "Audio
and Telematics" section.

2
MULTIFUNCTION SCREENS
50
Once the "TRIP COMPUTER" menu
has been selected, you can start diag-
nostics of the status of the equipment
(active, not active, faulty).
Trip computer
Date and time
Once the "DATE AND TIME" menu has
been selected, you have access to the
following settings:


- year,

- month,

- day,

- hours,

- minutes,

- 12 or 24 hour mode.



Once you have selected a setting,
press the " 
" or " 
" buttons to
change its value.


Press the " 
" or " 
" buttons to
switch respectively to the previous
or next setting.


Press the "OK"
button to record
the change and return to the normal
display or press the "Back"
button
to cancel.


Languages
Once the "LANGUAGES" menu has
been selected, you can choose the lan-
guage used by the display, from a pre-
defi ned list.
For safety reasons, confi gura-
tion of the multifunction screen
by the driver must only be
done when stationary.
Vehicle parameters
Once the "VEHICLE PARAM" menu
has been selected, you can activate or
deactivate the following equipment:


- "PARK BRAKE" (Automatic electric
parking brake; refer to the "Driving"
section).

- "BEND LIGHTING" (Directional
lighting; refer to the "Visibility" sec-
tion),

- "AUTO HEADLAMPS" (Automatic
illumination of headlamps; refer to
the "Visibility" section),

- "REAR WIPE ACT" (Rear wiper
coupled with reverse gear; refer to
the "Visibility" section),

- "GUIDE LAMPS" (Guide-me-home
lighting; refer to the "Visibility" sec-
tion),

- "ELECTRIC BOOT" (Selective
unlocking of the boot; refer to the
"Access" section),

- "CABIN SELECT" (Selective un-
locking; refer to the "Access" sec-
tion),

- "DAY LAMPS" (Daytime running
lamps; refer to the "Visibility" sec-
tion).

2
MULTIFUNCTION SCREENS
51































MONOCHROME SCREEN C

Displays in the screen

This displays the following information:


- time,

- date,

- ambient temperature (this fl ashes if
there is a risk of ice),

- parking sensor information,

- parking space measurement,

- current audio source,

- telephone or Bluetooth system in-
formation,

- trip computer (refer to the end of the
section),

- alert messages,

- settings menus for the screen and
the vehicle equipment.
From the control panel of your audio
system, you can press:



button A
to chooses between the
display of audio information in full
screen or the shared display of au-
dio and trip computer information,


the "MENU"
button for access to
the main menu
,


the " 
" or " 
" buttons to scroll
through the items on the screen,


the " 
" or " 
" buttons to change a
setting value,


the "OK"
button to confi rm,
or



the "Back"
button to abandon the
operation in progress.



Controls




Press the "MENU"
button for ac-
cess to the main menu
:


- "Multimedia",

- "Telephone",

- "Trip computer",

- "Bluetooth connection",

- "Personalisation-confi guration",


Press the " 
" or " 
" button to se-
lect the menu required, then confi rm
by pressing the "OK"
button.



Main menu

"Multimedia" menu

With the audio system switched on,
this menu allows you to activate or de-
activate the functions associated with
use of the radio (RDS, DAB / FM auto
tracking, RadioText (TXT) display) or to
choose the media play mode (Normal,
Random, Random all, Repeat).
For more information on the
"Multimedia" application, refer to the
"Audio and Telematics" section.