7-9
CHASSIS
SUSPENSION SETTING (FRONT FORK)
• If any of the following symptoms is experienced with the standard position as the base, make resetting by reference to 
the adjustment procedure given in the same chart.
• Before any change, set the rear shock absorber sunken length to the standard figure 90–100 mm (3.5–3.9 in).
SymptomSection
Check Adjust
JumpLarge 
gapMedi-
um 
gapSmall 
gap
Stiff over entire 
range○○○Compression  damping Turn adjuster counterclockwise (about 2 clicks) to 
decrease damping.
Oil  amount Decrease oil amount by about 5–10 cm
3 (0.2–0.4 
Imp oz, 0.2–0.3 US oz).
Spring Replace with soft spring.
Unsmooth move-
ment over entire 
range○○○○Outer tube Check for any bends, dents, and other noticeable 
scars, etc. If any, replace affected parts.
Inner tube
Slide metal Replace with a new one for extended use.
Piston metal Replace with a new one for extended use.
Under bracket tighten-
ing torqueRetighten to specified torque.
Poor initial move-
ment○Rebound  damping Turn adjuster counterclockwise (about 2 clicks) to 
decrease damping.
Oil seal Apply grease in oil seal wall.
Soft over entire 
range, bottoming 
out○○Compression damping Turn adjuster clockwise (about 2 clicks) to in-
crease damping.
Oil amount Increase oil amount by about 5–10 cm
3 (0.2–0.4 
Imp oz, 0.2–0.3 US oz).
Spring Replace with stiff spring.
Stiff toward stroke 
end○Oil amountDecrease oil amount by about 5 cm
3 (0.2 Imp 
oz,0.2 US oz).
Soft toward stroke 
end, bottoming out○Oil amountIncrease oil amount by about 5 cm
3 (0.2 Imp 
oz,0.2 US oz).
Stiff initial move-
ment○○○○Compression dampingTurn adjuster counterclockwise (about 2 clicks) to 
decrease damping.
Low front, tending to 
lower front posture○○Compression damping Turn adjuster clockwise (about 2 clicks) to in-
crease damping.
Rebound  damping Turn adjuster counterclockwise (about 2 clicks) to 
decrease damping.
Balance with rear end Set sunken length for 95–100 mm (3.7–3.9 in) 
when one passenger is astride seat (lower rear 
posture).
Oil amount Increase oil amount by about 5 cm
3 (0.2 Imp oz, 
0.2 US oz).
"Obtrusive" front, 
tending to upper 
front posture○○Compression  damping Turn adjuster counterclockwise (about 2 clicks) to 
decrease damping.
Balance with rear end Set sunken length for 90–95 mm (3.5–3.7 in) 
when one passenger is astride seat (upper rear 
posture).
Spring Replace with soft spring.
Oil  amount Decrease oil amount by about 5–10 cm
3 (0.2–0.4 
Imp oz, 0.2–0.3 US oz). 
7-10
CHASSIS
SUSPENSION SETTING (REAR SHOCK ABSORBER)
• If any of the following symptoms is experienced with the standard position as the base, make resetting by reference to 
the adjustment procedure given in the same chart.
• Adjust the rebound damping in 2-click increments or decrements.
• Adjust the low compression damping in 1-click increments or decrements.
• Adjust the high compression damping in 1/6 turn increments or decrements.
SymptomSection
Check Adjust
JumpLarge 
gapMedi-
um 
gapSmall 
gap
Stiff, tending to sink○○Rebound  damping Turn adjuster counterclockwise (about 2 clicks) to 
decrease damping.
Spring set length Set sunken length for 90–100 mm (3.5–3.9 in) 
when one passenger is astride seat.
Spongy and unsta-
ble○○Rebound damping Turn adjuster clockwise (about 2 clicks) to in-
crease damping.
Low compression 
dampingTurn adjuster clockwise (about 1 click) to increase 
damping.
Spring Replace with stiff spring.
Heavy and dragging○○Rebound  damping Turn adjuster counterclockwise (about 2 clicks) to 
decrease damping.
Spring Replace with soft spring.
Poor road gripping○Rebound  damping Turn adjuster counterclockwise (about 2 clicks) to 
decrease damping.
Low compression 
dampingTurn adjuster clockwise (about 1 clicks) to in-
crease damping.
High compression 
dampingTurn adjuster clockwise (about 1/6 turn) to in-
crease damping.
Spring set length Set sunken length for 90–100 mm (3.5–3.9 in) 
when one passenger is astride seat.
Spring Replace with soft spring.
Bottoming out○○High compression 
dampingTurn adjuster clockwise (about 1/6 turn) to in-
crease damping.
Spring set length Set sunken length for 90–100 mm (3.5–3.9 in) 
when one passenger is astride seat.
Spring Replace with stiff spring.
Bouncing○○Rebound damping Turn adjuster clockwise (about 2 clicks) to in-
crease damping.
Spring Replace with soft spring.
Stiff travel○○High compression 
dampingTurn adjuster counterclockwise (about 1/6 turn) to 
decrease damping.
Spring set length Set sunken length for 90–100 mm (3.5–3.9 in) 
when one passenger is astride seat.
Spring Replace with soft spring.