Page 46 of 100

PERIODIC MAINTENANCE AND ADJUSTMENT
7-4
1
2
3
4
\f
6
7
8
\b
10
NO. ITEM CHECK OR MAINTENAN\4CE JOB
ODOMETER READING
1000 km 10000 km 20000 km 30000 km 40000 km(600 mi) (6000 mi) (12000 mi) (18000 mi) (24000 mi)
ANNUAL
CHECK
√ √ √ √
√ √ √ √ √ √ √
√√
√
√ √ √ √ √
√ √ √ √ √ √ √ √ √ √
√ √ √ √
√ √ √ √
√ √
√ √ √ √ √ √
13
14
✻
1\f✻
16✻
18
Check operation and for e\fcessive pla\b.
Lubricate with lithium-\fsoap-based grease.
Check chain slack, alignment and condition.
Adjust and lubricate chain with a\f special
O-ring chain lubricant thoroughl\b.
Check bearing pla\b and steering
for roughness.
Lubricate with lithium-\fsoap-based grease.
Make sure that all nuts, bolts and screws
are properl\b tightened.
Check operation.
Lubricate.
Check operation.
Check operation and for oil leakage.
Check operation and shock absorber
for oil leakage.
Check operation.
Lubricate with lithium-\fsoap-based grease.
Change.
Check oil level and vehicle for oil leakage.
Swingarm
Drive chain
Steering bearings
Chassis fasteners
Sidestand
Sidestand switch
Front fork
Shock absorber
assembly
Rear suspension
relay arm and
connecting arm
pivoting points
Engine oil
Ever\b 50000 km (30000 mi)
Ever\b 50000 km (30000 mi)
Ever\b 500 km (300 mi) and after washing the motorc\bcle or riding in the rain
\b✻
11✻
17✻
12✻
10
XT660Z 05-07 ING-AUS:MY03 04-06 ING 11-05-2009 10:09 Pagina 7-4
Page 51 of 100

1
2
3
4
5
6
7
8
9
10
PERIODIC M\fINTEN\fNCE \fND \fDJ\bSTMENT
7-9
EAUB1560
Engine oil and oil filter
element
The engine oi\f \feve\f shou\f\b be checke\b
before each ri\be. In a\b\bition, the oi\f must
be change\b an\b the oi\f fi\fter e\fement re-
p\face\b at the interva\fs specifie\b in the
perio\bic maintenance an\b \fubrication
chart.
To check the engine oil level1. P\face the vehic\fe on a \feve\f surface an\b ho\f\b it in an upright position.
TIP
Make sure that the vehic\fe is posi-
tione\b straight up when checking the
oi\f \feve\f. A s\fight ti\ft to the si\be can re-
su\ft in a fa\fse rea\bing.
2. Start the engine, warm it up for 10-15 minutes an\b then turn it off.
3. Remove the oi\f fi\f\fer cap, wipe the \bipstick c\fean, insert it back into
the oi\f fi\f\fer ho\fe (without screwing
it in), an\b then remove it again to
check the oi\f \feve\f.
1. Engine oi\f fi\f\fer cap
2. Maximum \feve\f mark
3. Minimum \feve\f mark
TIP
●The engine oi\f tank is \focate\b in-
si\be of the frame.
●The engine oi\f shou\f\b be between
the minimum an\b maximum \feve\f
marks.
Tightening torque:Spark p\fug:12.5 Nm (1.25 m·kg\of, 9.0 ft·\fbf)
TIP
If a torque wrench is not avai\fab\fe
when insta\f\fing a spark p\fug, a goo\b
estimate of the correct torque is 1/4-
1/2 turn past finger tight. However, the
spark p\fug shou\f\b be tightene\b to the
specifie\b torque as s\ooon as possib\fe.
4. Insta\f\f the spark p\fug cap.
XT660Z 05-07 ING-AUS:MY03 04-06 ING 11-05-2009 10:09 Pagina 7-9
Page 52 of 100

PERIODIC MAINTENANCE AND ADJUSTMENT
7-10
1
2
3
4
\f
6
7
8
\b
10
To change the engine oil
(with or without oil filter element
replacement)
1. Mounting screw
2. \fngine guard
1. Start t\be engine, warm it up for sev- eral minutes, and t\ben turn it off.
2. To reac\b t\be drain bolt of t\be crankcase and t\be drain bolt of
t\be oil tank, remove t\be engine
guard by removing t\be screws.
3. Place an oil pan under t\be engine to collect t\be used\2 oil.
4. Remove t\be engine oil filler cap and t\be drain bolt to drain t\be oil
from t\be crankcase.
5. Remove t\be drain bolt to drain t\be oil from t\be oil ta\2nk.
1. \fngine oil crankcase drain bolt
1. \fngine oil tank drain bolt
6. Remove t\be oil filter elementdrain bolt to drain t\be oil from t\be
oil filter element\2.
1
\fCA10010
NOTICE
Do not operate the vehicle until you
know that the engine oil level is suf-
ficient.
\fWA10360
WARNING0
Never remove the engine oil tank
cap after high-speed operation,
otherwise hot engine oil could
spout out and cause damage or in-
jury. Always let the engine oil cool
down sufficiently before removing
the oil tank cap.
4. If t\be engine oil is below t\be mini- mum level mark, add sufficient oil
of t\be recommended type to raise
it to t\be correct l\2evel.
5. Install t\be oil fil\2ler cap.
XT660Z 05-07 ING-AUS:MY03 04-06 ING 11-05-2009 10:09 Pagina 7-10
Page 54 of 100

ECAM1060CAUTION:
The engine oil tank \fust be \billed in
2 steps. First, \bill the engine oil tank
with 1.90 L (2.0 US qt) (1.67 I\fp.qt)
o\b the reco\f\fended engine oil.
Then, start the engine, race it 5 or 6
ti\fes, turn it o\b\b, and then add the
re\fainder o\b the eng\kine oil.
NOTE:
Be sure to wipe off spi\f\fed oi\f on an\b
parts after the engine and exhaust
s\bstem have coo\fed d\fown.
ECA11620CAUTION: In order to prevent clutch slip-
page (since the engine oil also
lubricates the clutch), do not
\fix any che\fical additives. Do
not use oils with a diesel speci-
\bication o\b “CD” or oils o\b a
higher quality than speci\bied. In
addition, do not use oils la-
beled “ENERGY CONSERVING
II” or higher.
Make sure that no \boreign \fa-
terial enters the c\krankcase.
14. Start the engine, and then \fet it id\fe for severa\f minutes whi\fe
checking it for oi\f \feakage. If oi\f is
\feaking, immediate\f\b turn the en-
gine off and check for the \fcause.
15. Turn the engine off, and then check the oi\f \feve\f and correct it if
necessar\b.
16. Insta\f\f the engine guard b\b in- sta\f\fing the screws.\f
EAU20070
Coolant
The coo\fant \feve\f sho\fu\fd be checked
before each ride. In addition, the
coo\fant must be changed at the inter-
va\fs specified in the periodic mainte-
nance and \fubrication \fchart.
EAU20253
To check the coolant level1. P\face the vehic\fe on a \feve\f sur- face and ho\fd it in an upright posi-
tion.
NOTE:
The coo\fant \feve\f must be
checked on a co\fd engine since
the \feve\f varies with engine tem-
perature.
Make sure that the vehic\fe is posi-
tioned straight up when checking
the coo\fant \feve\f. A s\fight ti\ft to the
side can resu\ft in a \ffa\fse reading.
2. Check the coo\fant \feve\f in the coo\fant reservoir.
Reco\f\fended engine \koil:See page 8-1.
Oil quantity: Without oi\f fi\fter e\f\fement
rep\facement:2.50 L (2.64 US qt) (2.19 I\fmp.qt)
With oi\f fi\fter e\fem\fent rep\facement: 2.60 L (2.73 US qt) (2.26 Im\fp.qt)
PERIODIC MAINTENANCE AND ADJUSTMENT
7-12
7
03 ingles -austral\:ia 3/5/10 06:00 \:\fágina 54