2012 YAMAHA TZR50 brake

EAU17244
Periodic inspection, adjustment, and
lubrication will keep your vehicle in
the safest and most efficient condi-
tion possible. Safety is an obligation
of the vehicle owner/operator. The
most important points of vehicle ins-
pection, adjustment, and lubrication
are explained on the following pages.
The intervals given in the periodic
maintenance charts should be simply
considered as a general guide under
normal riding conditions. However,
depending on the weather, terrain,
geographical location, and individual
use, the maintenance intervals may
need to be shortened.
EWA10321
Failure to properly maintain the
vehicle or performing maintenance
activities incorrectly may increase
your risk of injury or death during
service or while using the vehicle. If
you are not familiar with vehicle
service, have a Yamaha dealer per-
form service.
EWA15122
Turn off the engine when perfor-
ming maintenance unless otherwi-
se specified.
A running engine has moving
parts that can catch on body
parts or clothing and electrical
parts that can cause shocks or
fires.
Running the engine while servi-
cing can lead to eye injury,
burns, fire, or carbon monoxide
poisoning – possibly leading to
death. See page 1-1 for more
information about carbon
monoxide.
EWA15460
Brake discs, calipers, drums, and
linings can become very hot during
use. To avoid possible burns, let
brake components cool before tou-
ching them.
EAU17521
Owner’s tool kit
1. Owner’s tool kit
The owner’s tool kit is located inside
the storage compartment under the
seat. (See page 3-12).
The service information included in
this manual and the tools provided in
the owner’s tool kit are intended to
assist you in the performance of pre-
ventive maintenance and minor
repairs. However, additional tools
such as a torque wrench may be
necessary to perform certain mainte-
nance work correctly.
WARNING
WARNING
WARNING
PERIODIC MAINTENANCE AND ADJUSTMENT
6-1
6
1HD-F819D-E0 7/3/11 20:27 Página 38
2AS-F819D-E0.indd 3831/07/12 10:09

PERIODIC MAINTENANCE AND ADJUSTMENT
6-4
6
EAU17717
General maintenance and lubrication chart
ODOMETER READING
CHECK OR ANNUAL
NO. ITEM MAINTENANCE JOB
1000 km 6000 km 12000 km 18000 km 24000 km CHECK
(600 mi) (3500 mi) (7000 mi) (10500 mi) (14000 mi)
1*
Air filter element • Clean.
√√• Replace. √√
2 Clutch • Check operation.
• Adjust. √√ √ √ √
• Check operation, fluid level and
3* Front brake vehicle for fluid leakage. √√ √ √ √ √
• Replace brake pads.
Whenever worn to the limit
• Check operation, fluid level and
4* Rear brake vehicle for fluid leakage. √√ √ √ √ √
• Replace brake pads.
Whenever worn to the limit
• Check for cracks or damage.
5* Brake hose • Check for correct routing and
√ √√ √ √
clamping.
• Replace. Every 4 years
6*Wheels • Check runout and for damage. √ √√ √
• Check tread depth and for damage.
7* Tires • Replace if necessary. √ √√ √ √
• Check air pressure.
• Correct if necessary.
8* Wheel bearings • Check bearing for looseness or
damage. √ √√ √
1HD-F819D-E0 7/3/11 20:27 Página 41
2AS-F819D-E0.indd 4131/07/12 10:09

PERIODIC MAINTENANCE AND ADJUSTMENT
6-5
6
ODOMETER READING
CHECK OR ANNUAL
NO. ITEM MAINTENANCE JOB
1000 km 6000 km 12000 km 18000 km 24000 km CHECK
(600 mi) (3500 mi) (7000 mi) (10500 mi) (14000 mi)
• Check operation and for
9* Swingarm excessive play. √ √√ √
• Lubricate with lithium-soap-
based grease. Every 24000 km (14000 mi)
• Check chain slack, alignment and condition. Every 500 km (300 mi) and after washing
10 Drive chain • Adjust and lubricate chain with
the motorcycle, riding in the rain or riding in wet areas
a special O-ring chain lubricant
thoroughly.
• Check bearing play and steering
11 * Steering bearings for roughness. √√ √ √ √
• Lubricate with lithium-soap-
based grease. Every 50000 km (30000 mi)
12 * Chassis fasteners • Make sure that all nuts, bolts and
screws are properly tightened. √ √√ √ √
13 Brake lever pivot
shaft • Lubricate with silicone grease.
√ √√ √ √
14 Brake pedal pivot
• Lubricate with lithium-soap-
shaft based grease. √ √√ √ √
15 Clutch lever pivot
• Lubricate with lithium-soap-
shaft based grease. √ √√ √ √
16 Shift pedal pivot
• Lubricate with lithium-soap-
shaft based grease. √ √√ √ √
• Check operation.
17 Sidestand • Lubricate with lithium-soap- √ √√ √ √
based grease.
18 * Sidestand switch • Check operation. √√ √ √ √ √
1HD-F819D-E0 7/3/11 20:27 Página 42
2AS-F819D-E0.indd 4231/07/12 10:09

PERIODIC MAINTENANCE AND ADJUSTMENT
6-6
6
ODOMETER READING
CHECK OR ANNUAL
NO. ITEM MAINTENANCE JOB
1000 km 6000 km 12000 km 18000 km 24000 km CHECK
(600 mi) (3500 mi) (7000 mi) (10500 mi) (14000 mi)
19 * Front fork • Check operation and for oil
leakage. √ √√ √
Rear suspension
• Check operation.
√ √√ √
20 * relay arm and
• Lubricate with lithium-soap-
connecting arm
pivoting points based grease.
√√
21 * Autolube pump • Check operation.
• Bleed if necessary. √
√ √√
22Transmission oil • Check oil level.
√√ √ √ √ √• Change.√√ √
23 * Front and rear brake
switches • Check operation.
√√ √ √ √ √
24 Moving parts and
cables • Lubricate.
√ √√ √ √
• Check operation.
25 * Throttle grip • Check throttle grip free play, and
√ √√ √ √
adjust if necessary.
• Lubricate cable and grip housing.
26 * Lights, signals and
• Check operation.
switches • Adjust headlight beam. √√ √ √ √ √
1HD-F819D-E0 7/3/11 20:27 Página 43
2AS-F819D-E0.indd 4331/07/12 10:09

PERIODIC MAINTENANCE AND ADJUSTMENT
6-7
6
EAU18670
TIP
The air filter needs more frequent service if you are riding in unusually wet or dusty areas.
Hydraulic brake service
• Regularly check and, if necessary, correct the brake fluid level.
• Every two years replace the internal components of the brake master cylinders and calipers, and change the bra- ke fluid.
• Replace the brake hoses every four years and if cracked or damaged.
1HD-F819D-E0 7/3/11 20:27 Página 44
2AS-F819D-E0.indd 4431/07/12 10:09

Tire inspection
1. Tire tread depth
2. Tire sidewall
The tires must be checked before
each ride. If the center tread depth
reaches the specified limit, if the tire
has a nail or glass fragments in it, or if
the sidewall is cracked, have a Yama-
ha dealer replace the tire immediately.
TIP
The tire tread depth limits may differ
from country to country. Always
comply with the local regulations.
Tire information
This motorcycle is equipped with
tubeless tires, tire air valves and cast
wheels.
EWA10461
The front and rear tires should be of
the same make and design, other-
wise the handling characteristics of
the vehicle may be different, which
could lead to an accident.
After extensive tests, only the tires lis-
ted below have been approved for
this model by Yamaha Motor Co., Ltd.
EWA10471
Have a Yamaha dealer replace
excessively worn tires. Besides
being illegal, operating the
vehicle with excessively worn
tires decreases riding stability
and can lead to loss of control.
The replacement of all wheel
and brake-related parts, inclu-
ding the tires, should be left to
a Yamaha dealer, who has the
necessary professional know-
ledge and experience to do so.
Ride at moderate speeds after
changing a tire since the tire
surface must first be “broken
in” for it to develop its optimal
characteristics.
WARNING
Front tire:Size: 100/80 17 (52H)
Manufacturer/model: Pirelli / Sport Demon
Continental/Conti-Twist SM
Rear tire: Size: 130/70 17 (62H)
Manufacturer/model: Pirelli / Sport Demon
Continental/Conti-Twist SM
WARNING
Minimum tire tread depth (front
and rear):1.6 mm (0.06 in)
1
2
ZAUM0054
PERIODIC MAINTENANCE AND ADJUSTMENT
6-20
6
1HD-F819D-E0 7/3/11 20:27 Página 57
2AS-F819D-E0.indd 5731/07/12 10:09

EAUT1221
Checking the front brake
lever free play
1. Front brake lever free play
The brake lever free play should mea-
sure 2.0-5.0 mm (0.08-0.20 in) as
shown. Periodically check the brake
lever free play and, if necessary, have
a Yamaha dealer check the brake sys-
tem.
EWA10641
An incorrect brake lever free play
indicates a hazardous condition in
the brake system. Do not operate
the vehicle until the brake system
has been checked or repaired by a
Yamaha dealer.
EAUM1353
Adjusting the brake pedal
free play
1. Brake pedal free play
The brake pedal free play should
measure 5.0-10.0 mm (0.20-0.39 in)
as shown. Periodically check the bra-
ke pedal free play and, if necessary,
have a Yamaha dealer adjust it.
EWAM1030
An incorrect brake pedal free play
indicates a hazardous condition in
the brake system. Do not operate
the motorcycle until the brake sys-
tem has been checked or repaired
by a Yamaha dealer.
EAUB1100
Adjusting the shift pedal
position
1. Distance between shift pedal and footrest
The top of the shift pedal should be
positioned approximately 65 mm
(2.56 in)below the top of the footrest
as shown. Periodically check the shift
pedal position and, if necessary, have
a Yamaha dealer adjust it.
WARNINGWARNING
PERIODIC MAINTENANCE AND ADJUSTMENT
6-22
6
1HD-F819D-E0 7/3/11 20:27 Página 59
2AS-F819D-E0.indd 5931/07/12 10:09

EAU22273
Brake light switches
1. Rear brake light switch adjusting nut
2. Brake light switch
The brake light, which is activated by
the brake pedal and brake lever,
should come on just before braking
takes effect. If necessary, adjust the
rear brake light switch as follows, but
the front brake light switch should be
adjusted by a Yamaha dealer.
Turn the rear brake light switch adjus-
ting nut while holding the rear brake
light switch in place. To make the bra-
ke light come on earlier, turn the
adjusting nut in direction (a). To make
the brake light come on later, turn the
adjusting nut in direction (b).
EAU22392
Checking the front and rear
brake pads
The front and rear brake pads must
be checked for wear at the intervals
specified in the periodic maintenance
and lubrication chart.
EAU22430
Front brake pads
1. Brake pad wear indicator groove
Each front brake pad is provided with
wear indicator grooves, which allow
you to check the brake pad wear wit-
hout having to disassemble the brake.
To check the brake pad wear, check
the wear indicator grooves. If a brake
pad has worn to the point that the
wear indicator grooves have almostdisappeared, have a Yamaha dealer
replace the brake pads as a set.
EAU22480
Rear brake pads
Each rear brake pad is provided with
a wear indicator groove, which allows
you to check the brake pad wear wit-
hout having to disassemble the brake.
Check the brake pad wear as follows.
1. Remove the brake caliper bolt, and then tilt the caliper forward to
inspect the wear indicator groo-
ve. If a brake pad has worn to the
point that the wear indicator gro-
ove has almost disappeared,
have a Yamaha dealer replace
the brake pads as a set.
1. Brake caliper bolt
PERIODIC MAINTENANCE AND ADJUSTMENT
6-23
6
1HD-F819D-E0 7/3/11 20:27 Página 60
2AS-F819D-E0.indd 6031/07/12 10:09