Page 270 of 492
7-55
Hills
Choose carefully which hills you attempt to climb
or descend. Avoid hills with slippery surfaces or
those where you will not be able to see far enough
ahead of you. Use common sense and remember
that some hills are too steep for you to climb or de-
scend. Use proper driving techniques to avoid
rearward, forward, or sideways rollovers on hills
and slopes.
Drive straight up and down inclines, not across
them. If crossing a hill is unavoidable, drive slowly.
Turn downhill immediately if you feel the vehicle
may tip.
If you think or feel the Rhino may tip or roll:
Brace yourself by pressing your feet firmly on
the floorboards and keep a firm grip on the
steering wheel or handholds.
Do not put your hands or feet outside of the ve-
hicle for any reason.
1RB60-EE.book Page 55 Thursday, April 7, 2011 10:43 AM
Page 299 of 492

8-8
EVU01650
General maintenance and lubrication chart
ITEM ROUTINEWhichever
comes firstINITIAL EVERY
month136612
km
(mi)320
(200)1200
(750)2400
(1500)2400
(1500)4800
(3000)
hours 20 75 150 150 300
Cooling system*Check coolant leakage.
Repair if necessary.
Replace coolant every 24 months.
Air filter elementClean.
Replace if necessary.Every 20–40 hours
(More often in wet or dusty areas.)
Engine oilReplace (warm engine before draining).Engine oil filter cartridgeReplace.Final gear oil
Check oil level/oil leakage.
Replace.Differential gear oil
Front brake*Check operation/brake pad wear/fluid leakage/see page 8-9.
Correct if necessary. Replace pads if worn to the limit.Rear brake*Check operation/brake pad wear/fluid leakage/see page 8-9.
Correct if necessary. Replace pads if worn to the limit.Parking brake*Check operation and free play/brake pad wear.
Correct if necessary. Replace pads if worn to the limit.Accelerator pedal*Check operation and free play.V-belt*Check operation.
Check for wear, cracks, or damage.Wheels*Check balance/damage/runout.
Repair if necessary.Wheel bearings*Check bearing assemblies for looseness/damage.
Replace if damaged.Front and rear
suspension*Check operation and for leakage.
Correct if necessary.Steering system*Check operation and for looseness/Replace if damaged.
Check toe-in/Adjust if necessary.Rear upper and lower
knuckle pivots*Lubricate with lithium-soap-based grease.
1RB60-EE.book Page 8 Thursday, April 7, 2011 10:43 AM
Page 406 of 492
8-115
1. Wheel nut (× 4)
1.Écrou de roue (× 4)
1. Tuerca de rueda (× 4)
1
1
EVU00920
Steering shaft lubrication
Lubricate the pivot points.
EVU00930
Wheel removal
1. Loosen the wheel nuts.
2. Elevate the vehicle and place a suitable
stand under the frame.
3. Remove the nuts from the wheel.
4. Remove the wheel.Recommended lubricant:
Lithium-soap-based grease
1RB60-EE.book Page 115 Thursday, April 7, 2011 10:43 AM
Page 466 of 492

10-1
1 -SPECIFICATIONS
Dimensions:Overall length:
2885 mm (113.6 in)
Overall width:
1385 mm (54.5 in)
Overall height:
YXR700FAB 1853 mm (73.0 in)
YXR7FSPB 1901 mm (74.8 in)
YXR7FB 1853 mm (73.0 in)
Seat height:
818 mm (32.2 in)
Wheelbase:
1910 mm (75.2 in)
Ground clearance:
280 mm (11.0 in)
Minimum turning radius:
3900 mm (154 in)Weight:With oil and fuel:
YXR700FAB 540.0 kg (1190 lb)
YXR7FSPB 548.0 kg (1208 lb)
YXR7FB 540.0 kg (1190 lb)
Noise and vibration level:
Noise level (77/311/EEC):
YXR7FSPB 80.2 dB(A)
YXR7FB 80.2 dB(A)
Vibration on seat (EN1032, ISO5008):
YXR7FSPB Will not exceed 0.5 m/s²
YXR7FB Will not exceed 0.5 m/s²Vibration on steering wheel (EN1032, ISO5008):
YXR7FSPB Will not exceed 2.5 m/s²
YXR7FB Will not exceed 2.5 m/s²
Engine:Engine type:
Liquid cooled 4-stroke, SOHC
Cylinder arrangement:
Forward-inclined single cylinder
Displacement:
686 cm³
Bore × stroke:
102.0 × 84.0 mm (4.02 × 3.31 in)
Compression ratio:
9.20 : 1
Starting system:
Electric starter
Lubrication system:
Wet sumpEngine oil:Recommended brand:
YAMALUBE
1RB60-EE.book Page 1 Thursday, April 7, 2011 10:43 AM
Page:
< prev 1-8 9-16 17-24