2012 YAMAHA GRIZZLY 550 set clock

4-5
4
EBU30490Multi-function display The multi-function display is equipped with the fol-
lowing:
a speedometer
an odometer
two tripmeters (which show the distance trav-
eled since they were last set to zero)
a clock

an hour meter (which shows the total time the
engine has been running)
a fuel meter
a self-diagnosis device
Odometer and tripmeter modes
Pushing the “ SELECT” button switches the display
between the odometer mode “ ODO” and the trip-
meter modes “ TRIP A” and “ TRIP B ” in the follow-
ing order:
ODO → TRIP A → TRIP B → ODO
To reset a tripmeter, select it by pushing the “SE-
LECT ” button, and then push the “ RESET” button
for at least three seconds. The tripmeters can be
used to estimate the distance that can be traveled
with a full tank of fuel. This information will enable
you to plan future fuel stops.TIPPushing and holding in the “SELECT ” button, and
turning the key to “” (on) while the button is
pushed, switches the display between “mph” and
“ km/h ”.
1. “CLOCK ” button
2. “RESET ” button
3. “SELECT ” button
4. Speedometer
5. Fuel meter
6. Clock/Hour meter
7. Odometer/Tripmeter A/Tripmeter BU1HS60E0.book Page 5 Tuesday, April 26, 2011 7:53 PM

4-6
4
Clock mode
Pushing the “
CLOCK” button switches the display
between the clock mode “CLOCK ” and the hour
meter mode “HOUR ” in the following order:
CLOCK → HOUR → CLOCK
To set the clock
1. Set the display to the clock mode.
2. Push the “SELECT ” button and “RESET ” but-
ton together for at least three seconds.
3. When the hour digits start flashing, push the “RESET ” button to set the hours.
4. Push the “ SELECT” button, and the minute
digits will start flashing.
5. Push the “RESET ” button to set the minutes.
6. Push the “SELECT ” button and then release it
to start the clock.
Fuel meter
The fuel meter indicates the amount of fuel in the
fuel tank. The display segments of the fuel meter
disappear from “ F” (full) towards “E ” (empty) as the
fuel level decreases. When the “E ” segment disap-
pears and the fuel level warning indicator flashes,
refuel as soon as possible.
TIPThis fuel meter is equipped with a self-diagnosis
system. If the electrical circuit is not working cor-
rectly, all the display segments and fuel level warn-
ing indicator will start flashing. If this occurs, have
a Yamaha dealer check the electrical circuit.1. Fuel level warning indicator
2. Fuel meter
3. “E” segment
U1HS60E0.book Page 6 Tuesday, April 26, 2011 7:53 PM

8-23
8
TIPIf the engine was started before checking the oil
level, be sure to warm up the engine sufficiently,
and then wait at least 10 minutes until the oil settles
for an accurate reading.3. Remove the access cover by turning it coun-terclockwise.
4. Remove the engine oil dipstick, and then wipe it off with a clean rag. 5. Insert the dipstick completely into the oil filler
hole, and then remove it again to check the oil
level.
TIPThe engine oil should be between the minimum
and maximum level marks.
1. Access cover
1. Engine oil dipstick
U1HS60E0.book Page 23 Tuesday, April 26, 2011 7:53 PM