To access the following ignition modes: The brake
pedal must not be depressed.Modes Active functions
Remote key not fully pressed into slot: info-
tainment system and cabin lighting.
Remote key fully pressed into slot: Instrument
panel/clock lighting, steering wheel lock off.
Remote key fully pressed into slot and a short
press on START/STOP ENGINE : moonroof*,
power windows, blower, ECC, wipers, 12-volt
sockets, navigation system*.
To exit modes 0/I and turn off the electrical system: Pull
the remote key out of the ignition slot.
KEYlESS DRIvE*
On keyless drive vehicles, it is only necessary to
have a remote key in your possession to operate the
central locking system and start the engine.
lOCKING AND ARMING THE AlARM
– Press the button on any of the outside door
handles or the rubber-covered button to the right of
the tailgate opening button. The lock indicator light
on the dashboard will start to flash. uNlOCKING AND DISARMING THE AlARM
–
Pull a door handle to unlock and open the door or
press lightly on the larger of the two rubberized but
-
tons on the tailgate.
STARTING THE ENGINE
– With a remote key in the passenger’s compart
-
ment, depress the brake pedal.
– Press and release the
START/STOP ENGINE
button. The autostart function will operate the starter
motor until the engine starts.
SWITCHING OFF THE ENGINE
– Press briefly on the
START/STOP ENGINE button.
Park
the vehicle and press
the
START/STOP ENGINE
button to switch off the
engine.
Pull the remote key out of
the ignition slot.
1.
2.
If the BLIS indicator lights illuminate even when there
are no vehicles in the blind area, this may be due to
light reflected from a wet road surface, the vehicle’s
own shadow against a large, light, smooth surface,
or sunlight directly in the camera when the sun is low
on the horizon.
If there is a fault with the system,
Blind spot syst. Service required will be displayed.
SWITCHING OFF THE ENGINE AND RE-
MOvING THE REMOTE KEY BlIND SPOT INFORMATION
SYSTEM (BlIS)*
IGNITION MODES 0 AND I
