To access the following ignition modes: The brake
pedal must not be depressed.Modes Active functions
Remote key not fully pressed into slot: info-
tainment system and cabin lighting.
Remote key fully pressed into slot: Instrument
panel/clock lighting, steering wheel lock off.
Remote key fully pressed into slot and a short
press on START/STOP ENGINE : moonroof*,
power windows, blower, ECC, wipers, 12-volt
sockets, navigation system*.
To exit modes 0/I and turn off the electrical system: Pull
the remote key out of the ignition slot.
KEYlESS DRIvE*
On keyless drive vehicles, it is only necessary to
have a remote key in your possession to operate the
central locking system and start the engine.
lOCKING AND ARMING THE AlARM
– Press the pressure-sensitive area on any of the out
-
side door handles or the rubber-covered button to
the right of the trunk opening button. The lock indica
-
tor light on the dashboard will start to flash. uNlOCKING AND DISARMING THE AlARM
–
Pull a door handle to unlock and open the door or
press lightly on the larger of the two rubberized but
-
tons on the trunk lid.
STARTING THE ENGINE
– With a remote key in the passenger’s compart
-
ment, depress the brake pedal.
– Press and release the
START/STOP ENGINE
button. The autostart function will operate the starter
motor until the engine starts.
SWITCHING OFF THE ENGINE
– Press briefly on the
START/STOP ENGINE button.
Park
the vehicle and press
the
START/STOP ENGINE
button to switch off the
engine.
Pull the remote key out of
the ignition slot.
1.
2.
If the BLIS indicator lights illuminate even when there
are no vehicles in the blind area, this may be due to
light reflected from a wet road surface, the vehicle’s
own shadow against a large, light, smooth surface,
or sunlight directly in the camera when the sun is low
on the horizon.
If there is a fault with the system,
Blind spot syst. Service required will be displayed.
SWITCHING OFF THE ENGINE AND RE-
MOvING THE REMOTE KEY BlIND SPOT INFORMATION
SYSTEM (BlIS)*
IGNITION MODES 0 AND I
1
The display shows two separate trip odome-
ters, T1 & T2.
2 Fuel gauge
The fuel filler door is on the right, as indica-
ted by the arrow.
3 Low fuel level indicator
When the symbol illuminates, refuel as soon
as possible.
4 Trip computer display. Select function with (8).
5 Clock: Adjust in the MY CAR menu system
or with control (6).
6 Multi-function control
Turn the control clockwise or counterclock-
wise to set the clock.
A short press toggles between T1 & T2.
A long press resets the displayed odometer.
Setting the clock: turn as far as possible and
continue turning until a click is audible.
ODOMETER AND TRIP COMPuTER
STEERING WHEEl ADjuSTMENT
BluETOOTH
W
ARNINGNever adjust the steering wheel while driving.
Make the cell phone discoverable/visible.
Press the TEl button on the center console
control panel briefly.
Select “Add phone” in the display.
Select the cell phone to be connected.
Enter the numbers shown in the audio system
display using the cell phone’s keypad.
A cell phone will be disconnected if the infotainment
system is switched off.
1.
2.
3.
4.
5.
7 Press to display or erase a message.
8 Turn to show trip computer information alternatives.
9 A short press resets the current function.
A long press resets all functions.
NOTE
The display text Miles to empty tank is an
approximation, based on recent average fuel
consumption.
1. Release lock. 2. Adjust.
