To access the following ignition modes: The brake
pedal must not be depressed.Modes Active functions
Remote key not fully pressed into slot: info-
tainment system and cabin lighting.
Remote key fully pressed into slot: Instrument
panel/clock lighting, steering wheel lock off.
Remote key fully pressed into slot and a short
press on START/STOP ENGINE : moonroof*,
power windows, blower, ECC, wipers, 12-volt
sockets, navigation system*.
To exit modes 0/I and turn off the electrical system: Pull
the remote key out of the ignition slot.
KEYlESS DRIvE*
On keyless drive vehicles, it is only necessary to
have a remote key in your possession to operate the
central locking system and start the engine.
lOCKING AND ARMING THE AlARM
– Press the pressure-sensitive area on any of the out
-
side door handles or the rubber-covered button to
the right of the trunk opening button. The lock indica
-
tor light on the dashboard will start to flash. uNlOCKING AND DISARMING THE AlARM
–
Pull a door handle to unlock and open the door or
press lightly on the larger of the two rubberized but
-
tons on the trunk lid.
STARTING THE ENGINE
– With a remote key in the passenger’s compart
-
ment, depress the brake pedal.
– Press and release the
START/STOP ENGINE
button. The autostart function will operate the starter
motor until the engine starts.
SWITCHING OFF THE ENGINE
– Press briefly on the
START/STOP ENGINE button.
Park
the vehicle and press
the
START/STOP ENGINE
button to switch off the
engine.
Pull the remote key out of
the ignition slot.
1.
2.
If the BLIS indicator lights illuminate even when there
are no vehicles in the blind area, this may be due to
light reflected from a wet road surface, the vehicle’s
own shadow against a large, light, smooth surface,
or sunlight directly in the camera when the sun is low
on the horizon.
If there is a fault with the system,
Blind spot syst. Service required will be displayed.
SWITCHING OFF THE ENGINE AND RE-
MOvING THE REMOTE KEY BlIND SPOT INFORMATION
SYSTEM (BlIS)*
IGNITION MODES 0 AND I
TP 13594 (USA & Canada). AT 1120. Printed in Sweden, Göteborg 2011. Copyright © 2000-2011 Volvo Car Corporation.
ElECTRIC PARKING BRAKE
1 Lumbar support.
2 Backrest tilt.
3 Raise/lower the seat.
4 Raise/lower the front edge of the seat cushion.
5 Forward/rearward.
6 Folding down the passenger’s seat back-
rest. See the Owner’s Manual for more
information.
Setting
– Press the button. The light flashes until the park-
ing brake is fully applied, then glows continu-ously.
Releasing
Ignition mode
0 or higher.
Press the brake pedal and
pull the button gently.
Release automatically
– Select a gear and begin driving. The parking
brake will release automatically (the driver’s seat
belt must be fastened).
1.
2.
ADjuSTING THE FRONT SEAT
WINDSHIElD WIPERS AND RAIN SENSOR*
1 Rain sensor On/Off with the lever in the 0 position.
2 Turn to adjust intermittent wiper speed or
rain sensor sensitivity where applicable.
ASingle wiper sweep.
0Off
BIntermittent wipers. Turn (2) to adjust.
CNormal wiper speed.
DHigh wiper speed.
EWindshield/headlight washers.
Displayed when the rain sensor is active.
