Page 125 of 358

03 Your driving environment
Parking brake
03
125
Releasing the electric parking brake
Parking brake control
Manual release1. Fasten the seat belt.
2. Insert the remote key in the ignition slot (or
press the START/STOP ENGINE button
on vehicles with the optional keyless drive).
3. Press firmly on the brake pedal.
4. Pull the parking brake control.
Automatic release1. Start the engine.
NOTE
•For safety reasons, the parking brake is
only released automatically if the engine
is running and the driver is wearing a seat
belt.
•The electric parking brake will be
released immediately when the acceler-
ator pedal is pressed and the gear selec-
tor is in position D or R.
2. Fasten the seat belt.
3.
Move the gear selector to position D or R
and press the accelerator pedal. The park-
ing brake will release when the vehicle
begins to move.
Heavy load uphillA heavy load, such as a trailer, can cause the
vehicle to roll backward when the parking
brake is released automatically on a steep
incline. To help avoid this:
1. Keep the electric parking brake lever
pushed in with the left hand while shifting
into Drive with the right.
2. While pressing the throttle pedal to pull
away, release the parking brake lever only
after the vehicle begins to move.
Symbols
SymbolSpecification
Read the message in the infor-
mation display
A flashing symbol indicates that
the parking brake is being
applied. If the symbol flashes in
any other situation then this
means that a fault has arisen.
Read the message on the infor-
mation display.
Messages
Park brake not fully released – A fault is pre-
venting the parking brake from being released.
Try to apply the parking brake and release it
several times. If the problem persists, contact
Page 205 of 358
05 Infotainment
Introduction
05
205
While the engine is being started, the infotain-
ment system will be temporarily interrupted
and will resume when the engine has started.
NOTE
To help avoid excessive battery drain,
remove the remote key from the ignition slot
if the infotainment system is used while the
engine is switched off.
Page 307 of 358

08 Maintenance and specifications
Replacing bulbs
08
307
CAUTION
Never touch the glass of bulbs with your fin-
gers. Grease and oils from your fingers
vaporize in the heat and will leave a deposit
on the reflector, which will damage it.
NOTE
•Always switch off the ignition before
starting to replace a bulb.
•The optional Active Bending Light bulbs
contain trace amounts of mercury.
These bulbs should always be disposed
of by a trained and qualified Volvo serv-
ice technician.
Removing the headlight housing1. Switch off the ignition by briefly pressing
the START/STOP ENGINE button.
2. Remove the remote key from the ignition
slot
1.
3. (Upper illustration under "Headlight hous-
ing")
Withdraw the headlight housing's lock-
ing pins.
Remove the headlight housing by alter-
natively pulling the front and rear edges
until it can be lifted out.
CAUTION
When disconnecting the connector, pull on
the connector itself and not on the wiring.
4. (Lower illustration under "Headlight hous-
ing")
Unplug the wiring connector by holding
down the clip with your thumb.
Pull out the connector with the other
hand.
5. Lift out the housing and place it on a soft
surface to avoid scratching the lens.
6. Replace the defective bulb(s).
Reinserting the headlight housing
1. Plug in the connector until it clicks into
place.
2. Reinstall the headlight housing and locking
pins. The short locking pin should be clos-
est to the grille. Check that they are cor-
rectly inserted. The headlight housing must
be properly inserted and secured in place
before the lighting is switched on or the
remote key is inserted into the ignition slot.
3. Check that the lights function properly.
1Does not apply to vehicles with the optional keyless drive.
Page 313 of 358

08 Maintenance and specifications
Wiper blades and washer fluid
08
313 Wiper blades
The windshield wiper blades are different
lengths. The blade on the driver’s side is longer
than the one on the passenger side.
Service position
Wiper blades in service position
The wiper blades must be in the vertical (serv-
ice) position for replacement, washing or to lift
them away from the windshield when e.g.,
removing ice or snow. To put them in this posi-
tion:
1. While sitting in the driver's seat, close the
driver's door.
2.
Insert the remote key in the ignition slot
1
3.
Put the ignition in mode II (see page 86).4.
With the remote key in the ignition slot
1, put
the ignition in mode 0.
5. Move the right steering wheel lever up and
hold it for at least 1 second. The wipers will
then move to the vertical (service) position
on the windshield.
The wipers can be returned to the normal posi-
tion by briefly switching on the ignition (or by
starting the engine).
Replacing the windshield wiper blades
With the wipers in the service position, fold
out the wiper arm from the windshield.
Press the button on the wiper blade attach-
ment and pull the wiper blade straight out,
parallel with the wiper arm.
Slide in the new wiper blade until it clicks
into place.
Check that the blade is securely in place.
1Not necessary on vehicles with the optional keyless drive.
Page 348 of 358

10 Index
10
348
1, 2, 3 ...
12-volt sockets........................................ 201
A
ABS (anti-lock brake system).................. 122
Accessory installation warning.................. 14
Active chassis system.............................152
Active yaw control................................... 149
Adaptive brake lights............................... 121
Adaptive cruise control.................... 155, 157
Airbags
disconnecting the front passenger’s
side.................................................29, 30
front...................................................... 25
inflatable curtain................................... 35
side impact........................................... 33
Air conditioning........................................ 144
Air distribution.......................................... 140
Air distribution table................................. 146
Air vents................................................... 141
All Wheel Drive......................................... 120
Anti-freeze.......................................252, 304Anti-lock brake system
warning light......................................... 80
Anti-lock Brake System (ABS)................. 122
Approach lighting..............................57, 100
Audio system
AUX/USB sockets............................... 226
Bluetooth Ÿ devices............................. 229
Bluetooth Ÿ hands-free system........... 232
Bluetooth streaming audio................. 229
general functions................................ 210
getting started.................................... 206
HD digital radio................................... 215
introduction......................................... 204
media player....................................... 222
menus................................................. 244
overview.............................................. 204
radio functions.................................... 213
Sirius satellite radio............................217
sound settings.................................... 211
steering wheel keypad........................ 209
voice control....................................... 240
Auto-dim rearview mirror......................... 107
Automatic locking retractor....................... 40
Automatic transmission
Geartronic................................... 118, 119
general description.....................118, 119oil........................................................ 341
shiftlock override................................ 119
Axle weight.............................................. 279
B
Battery
changing..................................... 316, 317
maintenance....................................... 316
remote key, replacing........................... 60
specifications...................................... 342
warning symbols................................. 315
Blind Spot Information System
(BLIS)....................................... 195, 196, 197
Bluetooth cell phone connection............. 232
Booster cushions....................................... 48
Brake lights.............................................. 121
Brake system
ABS..................................................... 122
Brake pad inspection.......................... 121
checking fluid level............................. 304
emergency brake assistance.............. 122
fluid..................................................... 341
general information............................. 121
warning light......................................... 82
Page:
< prev 1-8 9-16 17-24