Page 2 of 8
key blade
Used to lock/unlock the glove compartment or the driver’s door if the vehicle has no electrical current.
remote key & key blade
locks the doors and liftgate, and arms the alarm.
Unlocks the doors and liftgatea and disarms the alarm.
Unlocks (but does not open) the liftgate.
approach lighting illuminates lights in door mirrors, cabin, footwells, license plates. Turn signals and parking lights illuminate.
“Panic” alarm. – Press and hold to sound the alarm. Turn off alarm with unlock button.a. automatic relock occurs if no door/liftgate is opened within 2 minutes after unlock.
aUTosTarT
depress the clutch and/or brake pedal. Turn
the key/keyless drive start control to posi-tion III and release it. The engine will start automatically.
note
after cold starts, your engine will idle at a higher speed for a short time.
settIng the clock
turn sIgnals
A lane-change sequence, three flashes. B Full turn sequence. warnIng
Never adjust the steering wheel while driving.
steerIng wheel adjustment
Press the MeNU button on the center console control panel.
select
Clock adjust.
Press eNTer
Use the left/right arrow keys on the navigation control to highlight a number in the clock.
set the time by using the number keys or with the up/down arrow keys.
Press eNTer to save the change and exit the menu.
1.
2.
3.
4.
5.
6.
Page 6 of 8
blInd spot InFormatIon sys-
tem (blIs)*
if the blis indicator lights illuminate occasion
-ally even when there are no other vehicles in the blind area, this may be caused by light re-flected from a wet road surface, the vehicle’s own shadow against a large, light, smooth surface, or sunlight directly in the camera when the sun is low on the horizon.
in the event of a fault,
blInd spot syst.
serv Ice requ Ired will be displayed. see
the owner’s Manual for other blis-related
messages.
car care
Hand washing is gentler on the paint than an
automatic car wash. since the paint on a new
vehicle may take several months to harden completely, we recommend washing the vehicle by hand during this period. Use clean water, a suitable car washing detergent and
a sponge. keep in mind that dirt or grit on the
sponge can scratch the paint.
1 low fuel level indicator When the symbol illuminates, refuel as soon as possible.
2 Fuel gauge The fuel filler door is on the right, as indi-cated by the arrow.
3 Information display (trip computer in-formation, messages, clock and ambient temperature).
4 t he trip odometer display shows two separate trip odometers, t1 & t 2.
5 a short press toggles between t1 & t 2.
a long press resets the displayed odom-eter.
trIp computer and odometer
6
p ress to display or erase a message.
7 t urn to show trip computer information alternatives
8 a short press resets current function.
a long press resets all functions.
note
The display text m Iles to empty tank is an approximation, based on recent average fuel consumption.
Page 7 of 8
soFt cargo area cover*
rIgId cargo area cover*
iNsTalliNg
Pull all four locking buttons back as far as pos-sible. Carefully lift in the cover, place the front
section on the two supports behind (a) on both
sides.holders For Floor hatch
attach the hooks near the floor (a).
Press together the spring-loaded rails and
insert them in the attachments (b) on both
sides.
insert the attachments in (C) in the same
way.
Place the hooks in (d).
remove the attachments at (d) and (C) if
necessary on both sides when loading the cargo area.
remove (d), (C), (b), and (a) and roll up the
cover when it is not in use.
1.
2.
3.
4. open floor hatch with/without cargo area
cover.
Place one rear lock at (b) and press the lock
button forward. lock the other buttons in the
same way.
reMoviNg
Pull the lock buttons rearward as far as possible
at (a) first, then at (b). lift out the cover.
FoldIng down the rear seat
backrests
Pull up the catches and fold the backrests forward.
Page 8 of 8
TP 11879 (Usa & Canada) aT 1020. Printed in sweden, göteborg 2010, Copyright © 2000 -2010 volvo Car Corporation
enterIng the rear seat
MaNUal seaT
m oving the seat forward
remove the seat belt from the guide (a).
Pull up the handle (b) and fold the backrest
forward until it locks in position.
Move the seat forward (C).
m oving the seat rearward
Move the seat rearward until it reaches the
desired position (d).
Pull up the handle (e) and return the back
-rest to the upright position.
Put the seat belt back into the guide (F).
PoWer seaT*
m oving the seat forward
remove the seat belt from the guide (a).
Pull up the handle (b) and fold the backrest
forward until it locks in position.
Press and hold in the front section of the
button (g).
m oving the seat rearward
Press and hold in the rear section of the
button (g).
Pull up the handle (e) and return the back
-rest to the upright position.
Put the seat belt back into the guide (F).
note
When putting on the seat belt, it is easiest to reach for the lower section of the belt, near the guide, instead of reaching over your shoulder.
1.
2.
3.
1.
2.
3.
1.
2.
3.
1.
2.
3.
adjustIng the Front seat
1
l umbar support.
2 h ead restraint height adjustment.
3 a ccess to rear seat.
4 b ackrest tilt.
5 r aise/lower the seat.
6 r aise/lower the front edge of the seat cushion.
Forward/rearward.
reFuelIng
1. Press this button to open the fuel filler door. 2. Hang the fuel filler cap on the hook while refueling.
