2012 TOYOTA xD light

10
FEATURES/OPERATIONS
Windshield wipers & washers
Front
Rear
Wash and wipe
WipeWash and wipe
Lights & turn signals
Turn signals
Headlights
Headlights
Parking lights
Right turn
Lane change
Lane change Left turn
Low beam
High beam flasher
High beam
Wi
Auto
Push
midw
Wind
oper
Driv
Cr
1The2 The
Syst
Fun
Type A Type B
Headlights
Parking lights
Type A
Interval wipe
Slow
Fast
Pull to wash and wipe
Single wipe
Interval wipe Slow
Fast
Pull to wash and wipe
Single wipeType B
Type A Type B
Wash and wipe
Wipe
Wash and wipe
resize-2012Scion xD.qxd:2012-Scion-xD-QRG 9/7/11 10:36 PM Page 10

OVERVIEW
FEATURES/OPERATIONS
SAFETY AND EMERGENCY FEATURES
11
Windows
Automatic down operation (driver side only)
Push the switch completely down and release to fully open. To stop window
midway, lightly pull the switch up.
Window lock switchDeactivates all passenger windows. Driver’s window remains
operable.
Up
Down
Driver side
Window lock switch
Cruise control
1The set speed may also be cancelled by depressing the brake pedal.2 The set speed may be resumed once vehicle speed reaches 25 mph.
System ON/OFF
Functions
System ON/OFF
Resume
2/Increase speed
Set/Decrease speed
Cancel1
wipe
e
wipe
resize-2012Scion xD.qxd:2012-Scion-xD-QRG 9/7/11 10:36 PM Page 11

16
SAFETY AND EMERGENCY FEATURES
Doors-Child safety locks
Moving the lever to “LOCK” will allow the door to be opened only from the outside.
Seat belts-Shoulder belt anchor
Push up, or pull lock
release to lower
Rear door
Door locks
If belt is fully extended, then retracted even slightly, it cannot be re-extended
beyond that point, unless fully retracted again. This feature is used to help hold
child restraint systems securely.
To find more information about seat belts, and how to install a child restraint
system, refer to the Owner’s Manual.
Keep as low on
hips as possible
Take up slack
Too high
Seat belts
Sp
Too
Rem
Refe
Tir
Sy
Afte
ignit
blink
com
Refe
spec
If th
take
NOT
tire
rece
UnlockLock
Spar
Jack
Unlock
Lock
resize-2012Scion xD.qxd:2012-Scion-xD-QRG 9/7/11 10:47 PM Page 16

OVERVIEW
FEATURES/OPERATIONS
SAFETY AND EMERGENCY FEATURES
17
tside.
dld
Spare tire & tools
Tool and spare tire location
Removing the spare tire
Refer to the Owner’s Manual for jack positioning and tire changing procedures.
Tire Pressure Monitoring (warning)
System
System reset initialization
1.Push and hold “ SET” button
until the indicator blinks three times.
2. Wait several minutes to allow
initialization to complete.
After adjusting tire pressures, or after tires have been rotated or replaced, turn the
ignition switch to “ON” and press and hold the “ SET” button until indicator
blinks three times. Let the vehicle sit for a few minutes to allow initialization to
complete.
Refer to the load label on the door jamb or the Owner’s Manualfor tire inflation
specifications.
If the tire pressure indicator flashes for more than 60 seconds and then remains on,
take the vehicle to your local Scion dealer.
NOTE : The warning light may come on due to temperature changes or changes in
tire pressure from natural air leakage. If the system has not been initialized
recently, setting the tire pressures to factory specifications should turn off the light.
Loosen
Remove Tool bag
Tire tie-down belt
Spare tire
Jack handle
Jack
resize-2012Scion xD.qxd:2012-Scion-xD-QRG 9/7/11 10:47 PM Page 17