2012 TOYOTA xB ignition

2
OVERVIEW
Instrument panel
Headlight and turn signal controls
Wiper and washer controls
Cruise control
Ignition switch
Steering wheel audio controls*
Rear window defogger button
Front passenger occupant classification indicator/
Front passenger seat belt reminder light
Air Conditioning controlsP
E
T
T
“
P
In
*
Steering wheel
2012-Scion-xB-QRG.qxd:4118_ 4/7/11 10:35 PM Page 2

* The ignition switch must be “ON” and the brake pedal depressed to \
shiftfrom Park.
Push shift lever to the left from “D” position. +: Upshift (push and release)-: Downshift (pull and release)
Downshifting increases power going uphill, or provides engine braking do\
wnhill.
For best fuel economy during normal driving conditions, always drive wit\
h the shift
lever in the “D” position.
8
FEATURES/OPERATIONS
Auto lock/unlock
Automatic door locks can be programmed to operate in four different mode\
s, or
turned OFF.
-Doors lock when shifting from Park.
1
-Doors lock when the vehicle speed goes above approximately 12 mph.2
-Doors unlock when ignition key is turned to “ACC” or “LOCK” \
position anddriver’s door is opened.2
-Doors unlock when shifting into Park.1
1
Automatic Transmission only2Default setting is off
Refer to the Owner’s Manual for more details.
Automatic Transmission (if equipped)
“S” (Sequential) mode
Parking brake
Pull(2) Push (1) Pull slightly
(3) Lower
Set Release
Se
Fron
Se
S
H
S
6H
3DUN*
Reverse
Neutral
Drive
P
R
N
D
N
S“S” mode“S”
“D”
+(“S” mode)
-(“S” mode)
2012-Scion-xB-QRG.qxd:4118_ 4/7/11 10:37 PM Page 8

16
SAFETY AND EMERGENCY FEATURES
If belt is fully extended, then retracted even slightly, it cannot be re-extended
beyond that point, unless fully retracted again. This feature is used to help hold
child restraint systems securely.
To find more information about seat belts, and how to install a child res\
traint
system, refer to the Owner’s Manual.
Keep as low on
hips as possible
Take up slack
Too high
Seat beltsSp
To o
Rem
(1) R
(2) R
(3) L
Refe
If tire pressure indicator is on, check/adjust each tire.
Tire Pressure Monitoring (warning)
System
After adjusting tire pressures, or after tires have been rotated or repl\
aced, turn
the ignition switch to “ON” and press and hold the “ SET” button until indicator
blinks three times. Let the vehicle sit for a few minutes to allow initi\
alization to
complete.
Refer to the load label on the door jamb or the Owner’s Manualfor tire inflation
specifications.
If the tire pressure indicator flashes for more than 60 seconds and then\
remains
on, take the vehicle to your local Toyota dealer.
NOTE: The warning light may come on due to temperature changes or changes in
tire pressure from natural air leakage. If the system has not been initi\
alized
recently, setting the tire pressures to factory specifications should turn off t\
he
light.
(1
2012-Scion-xB-QRG.qxd:4118_ 4/7/11 10:42 PM Page 16