2012 TOYOTA MATRIX door lock

OVERVIEW
FEATURES/OPERATIONS
SAFETY AND EMERGENCYFEATURES
1
INDEX
OVERVIEW
FEATURES/OPERATIONS
SAFETY AND
EMERGENCY FEATURES
Engine maintenance 7Fuel tank door release and cap6Hood release 7Indicator symbols4-5Instrument cluster 4Instrument panel2-3
Keyless entry16
Air Conditioning/Heating16Audio 14-15Auto lock/unlock28Automatic Transmission 8Auxiliary storage17Bottle holders19Clock10Cruise control17Cup holders18Door-Back 13Door locks-Power 13Light control-Instrument panel16Lights & turn signals11Moonroof13Parking brake10Power outlet-12V DC 19Power outlet-115V AC19Seat adjustments-Front9Seat adjustments-Rear9Seats-Head restraints 9Telephone controls (Bluetooth®)18Tilt and telescopic steering wheel10Windows-Power 12
Windshield wipers & washers 12
Doors-Child safety locks 20Floor mat installation23Seat belts21Seat belts-Shoulder belt anchor20Spare tire & tools21Star Safety SystemTM22-23
Tire Pressure Monitoring (warning) System 20
1Visit your Toyota dealer for information on customizing this feature.2 Programmable by customer. Refer to the Owner’s Manual for instructions and more
information.
125432_resize Matrix-QRG.qxd 11/23/11 9:32 PM Page 1

OVERVIEW
FEATURES/OPERATIONS
SAFETY AND EMERGENCYFEATURES
5
Anti-lock Brake System warning1
Headlight low/high beam indicator
Turn signal indicator
Slip indicator
1
Cruise control indicator
Low Tire Pressure Warning1
Open door warning
SRS Airbag warning1
Low fuel level warning
Fog light indicator
Active torque control 4WD system warning1
Low engine oil pressure warning1
Maintenance/Service required indicator1
Engine immobilizer system indicator
Traction control OFF indicator
1
Vehicle Stability Control OFF indicator1
Cruise control SET indicator
125432_resize Matrix-QRG.qxd 11/23/11 9:32 PM Page 5

6
OVERVIEW
Keyless entry
PushPush ONCE: Driver door
TWICE: All doors
Locking operationUnlocking operation
Panic button
Push and hold
NOTE:If a door is not opened within 60
seconds of unlocking, all doors will relock
for safety.
Ho
Fuel tank door release and cap
NOTE: Tighten until one click is
heard. If the cap is not tightened
enough, Check Engine “ ”
indicator may illuminate.
PullTurn to open
Store
E
E
E
W
NOT
En
4 cy
125432_resize Matrix-QRG.qxd 11/23/11 9:32 PM Page 6

8
FEATURES/OPERATIONS
Automatic Transmission (if equipped)
* The ignition switch must be “ON” and the brake pedal depressed to shi\
ft from Park.
Shift the shift lever to “S” position from “D” position.
+: Upshift (push and release)
-: Downshift (pull and release)
Downshifting increases power going uphill, or provides engine braking downhill.
For best fuel economy during normal driving conditions, always drive with t\
he shift
lever in the “D” position.
“S” (Sequential) mode
3
2L
Standard typeMulti-mode type
Park*
Reverse
Neutral
Drive
“S” mode
Park*
Reverse
Neutral
Drive
Third gear
Second gear
First gear
3
2
L
“S”“D”
Automatic door locks can be programmed to operate in three different modes, or
turned OFF.
-Doors lock when shifting from Park.
-Doors unlock when shifting into Park.
-Doors unlock when the driver’s door is opened within 10 seconds after setting the ignition switch to “ACC” or “LOCK” position.
Refer to the Owner’s Manual for more details.
Se
Se
S
H
S
Se
Fron
Auto lock/unlock (if equipped)
125432_resize Matrix-QRG.qxd 11/23/11 9:32 PM Page 8

OVERVIEW
FEATURES/OPERATIONS
SAFETY AND EMERGENCYFEATURES
13
tch
ns
Door-Back
Lock
Unlock
Open
Moonroof (if equipped)
Sliding operationTilting operation
OpenTilt
Close Close
Recommended open position to
minimize wind noise.
Door locks-Power (if equipped)
Lock
Unlock
r
Push once to open partway; again to
open completely.
125432_resize Matrix-QRG.qxd 11/23/11 9:32 PM Page 13

20
Moving the lever to “LOCK” will allow the door to be opened only from th\
e
outside.
Rear door
Doors-Child safety locks
System reset initialization
1. Push and hold “SET” button
until the indicator blinks
three times.
2. Wait a few minutes to allow initialization to complete.
Push up, or squeeze
lock release to lower
Seat belts-Shoulder belt anchor
SAFETY AND EMERGENCY FEATURES
If be
beyo
child
To fi
syste
Se
Sp
To o
Rem
(1) T
(2) L
Refe
(1)
Tire Pressure Monitoring (warning)
System
After adjusting tire pressures, or after tires have been rotated or replaced,\
turn
the ignition switch to “ON” and press and hold the “ SET” button until indicator
blinks three times. Let the vehicle sit for a few minutes to allow initializat\
ion to
complete.
Refer to the load label on the door jamb or the Owner’s Manualfor tire inflation
specifications.
If the tire pressure indicator flashes for more than 60 seconds and then r\
emains
on, take the vehicle to your local Toyota dealer.
NOTE : The warning light may come on due to temperature changes or changes in
tire pressure from natural air leakage. If the system has not been initializ\
ed
recently, setting the tire pressures to factory specifications should turn off th\
e
light.
125432_resize Matrix-QRG.qxd 11/23/11 9:32 PM Page 20