Page 582 of 692
582 5-2. Steps to take in an emergency
L/C200_EE (OM60G38E)
(Diesel engine)Indicates a malfunction in the fuel system
(Diesel engine)Indicates a malfunction in the Diesel Particu-
late Filter system
(If equipped)Indicates a malfunction in the VGRS
A buzzer also sounds.
Warning messageDetails
Page 586 of 692
586 5-2. Steps to take in an emergency
L/C200_EE (OM60G38E)
Indicates that engine
oil level is low
A buzzer also sounds.Check the level of
engine oil, and add if
necessary.
This message may
appear if the vehicle is
stopped on a slope.
Move the vehicle to a
level surface and
check to see if the
message disappears.
(Diesel engine)Indicates that the
amount of accumu-
lated water in the fuel
filter has reached the
specified levelDrain the water from the
fuel filter. (P. 517)
Indicates that the
washer fluid level is
lowAdd washer fluid
Warning messageDetailsCorrection procedure
Page 587 of 692

5
587 5-2. Steps to take in an emergency
When trouble arises
L/C200_EE (OM60G38E)
(Diesel engine)Indicates that the
engine oil is sched-
uled to be changed
Comes on approxi-
mately 27000 km
(17000 miles) after the
engine oil is changed.
(The indicator will not
work properly unless
the oil maintenance
data has been reset.)Check the engine oil
and change if neces-
sary. After changing the
engine oil, the oil
change system should
be reset. (P. 507)
(Diesel engine)Indicates that the
engine oil and oil fil-
ter should be changed
Comes on approxi-
mately 30000 km
(19000 miles) after the
engine oil is changed
(and the oil mainte-
nance data has been
reset)Have the engine oil and
oil filter checked and/or
changed by any autho-
rized Toyota dealer or
repairer, or another duly
qualified and equipped
professional. After
changing the engine oil,
the oil change system
should be reset.
(P. 507)
Indicates that remain-
ing fuel is about 15.0 L
(4.0 gal., 3.3 Imp.gal.)
or less Refuel the vehicle.
Warning messageDetailsCorrection procedure
Page 595 of 692
5
595 5-2. Steps to take in an emergency
When trouble arises
L/C200_EE (OM60G38E)
After changing the engine oil (Diesel engine)
Make sure to reset the oil maintenance data. (P. 507)
NOTICE
While the engine oil level warning is displayed
Continued engine operation with low engine oil will damage the engine.
Engine oil maintenance message (Diesel engine only)
The warning message is based on the projected driving range after engine
oil maintenance message is reset.
The system does not monitor the purity of the engine oil.
If the “DRAIN WATER FROM FUEL FILTER” warning message is dis-
played
Never drive the vehicle if the warning message is displayed. Continued driv-
ing with water accumulated in the fuel filter will damage the fuel injection
pump.
Page 623 of 692

5
623
5-2. Steps to take in an emergency
When trouble arises
L/C200_EE (OM60G38E)
If the engine will not start
If the engine still does not start after following the correct starting
procedure (P. 190) or releasing the steering lock (P. 192), confirm
the following points.
The engine will not start even when the starter motor oper-
ates normally
One of the following may be the cause of the problem.
There may not be sufficient fuel in the vehicle’s tank.
Gasoline engine: Refuel the vehicle.
Diesel engine: (P. 637)
The engine may be flooded. (gasoline engine)
Try to restart the engine once more following correct starting
procedures. (P. 190)
There may be a malfunction in the engine immobilizer system.
(P. 120)
The starter motor turns over slowly, the interior lights and
headlights are dim, or the horn does not sound or sounds at
a low volume
One of the following may be the cause of the problem.
The battery may be discharged. (P. 630)
The battery terminal connections may be loose or corroded.
The starter motor does not turn over
The engine starting system may be malfunctioning due to an
electrical problem such as an open circuit or a blown fuse. How-
ever, an interim measure is available to start the engine.
(P. 624)
Page 637 of 692
5
637
5-2. Steps to take in an emergency
When trouble arises
L/C200_EE (OM60G38E)
If you run out of fuel and the engine stalls (diesel engine only)
NOTICE
When restarting the engine
Do not crank the engine before refueling and operating the priming pump.
This may damage the engine and fuel system.
If you run out of fuel and the engine dies:
Refuel your vehicle.
Operate the priming pump
until you feel more resistance
to bleed the fuel system.
Start the engine. (
P. 190)
If the engine does not start after the above steps have been per-
formed, wait for 10 seconds and try step 2 and 3 again. If the
engine still does not start, contact any authorized Toyota dealer or
repairer, or another duly qualified and equipped professional.
After starting the engine, depress the accelerator pedal lightly until
the engine runs smoothly.
STEP1
STEP2
STEP3
Page 643 of 692
6Vehicle specifications
643
L/C200_EE (OM60G38E)
6-1. Specifications
Maintenance data
(fuel, oil level, etc.).......... 644
Fuel information ................ 662
6-2. Customization
Customizable features ...... 665
6-3. Initialization
Items to initialize ............... 674
Page 644 of 692
644
L/C200_EE (OM60G38E)
6-1. Specifications
Maintenance data (fuel, oil level, etc.)
Dimensions and weights
*1: Unladen vehicles
*2: Vehicles with 4-Wheel AHC
*3: Vehicles without 4-Wheel AHC
Overall length 4950 mm (194.9 in.)
Overall width 1970 mm (77.6 in.)
Overall height*11865 mm (73.4 in.)*2
1910 mm (75.2 in.)*3
Wheelbase 2850 mm (112.2 in.)
TreadFront 1640 mm (64.6 in.)
Rear 1635 mm (64.4 in.)
Gross vehicle mass 3350 kg (7385 lb.)
Maximum
permissible axle
capacityFront 1630 kg (3593 lb.)
Rear 1950 kg (4299 lb.)
Drawbar load 140 kg (309 lb.)
Towing capacity
With
brake3500 kg (7716 lb.)
Without
brake750 kg (1653.5 lb.)