2012 TOYOTA HILUX steering wheel

401 3-3. Using the “touch screen”
3
Interior features
HILUX_EE (OM0K132E)
Receiving a call
When a call is received, the following screen is displayed together
with a sound.
To answer the phone:
• Press on the steering
wheel.
•Touch .
To refuse a call
Press on the steering wheel or touch .
To adjust the incoming call volume
Touch “-” or “+”. You can also adjust the volume using the steering
switches or volume knob.
International calls
Received international calls may not be displayed correctly depending on
the cellular phone in use.

404 3-3. Using the “touch screen”
HILUX_EE (OM0K132E)To transfer a call
Touch “Handset Mode” to change from Hands-free call to cellular
phone call.
Touch “Handsfree Mode” to change from cellular phone call to
Hands-free call.
To hang up
Press on the steering wheel or touch .
Call waiting
When a call is interrupted by a third party while talking, the incom-
ing call message will be displayed.
To talk with the other party:
• Press on the steering
wheel.
•Touch .
To refuse the call:
• Press on the steering
wheel.
•Touch .
Every time you press on the steering wheel or touch
during call waiting, you will be switched to the other party.

528 4-3. Do-it-yourself maintenance
HILUX_EE (OM0K132E)Front fog lights (if equipped)
To allow enough working space,
turn the steering wheel to the
opposite side of the bulb to be
replaced.
Remove the bolts and clip.
Removing the clip
Installing the clip
STEP1

530 4-3. Do-it-yourself maintenance
HILUX_EE (OM0K132E)Front position lights
To allow enough working space,
turn the steering wheel to the
opposite side of the bulb to be
replaced.
Remove the bolts and clip.
Removing the clip
Installing the clip
STEP1

532 4-3. Do-it-yourself maintenance
HILUX_EE (OM0K132E)Front turn signal lights
To allow enough working space,
turn the steering wheel to the
opposite side of the bulb to be
replaced.
Remove the bolts and clip.
Removing the clip
Installing the clip
STEP1

542 5-1. Essential information
HILUX_EE (OM0K132E)
Emergency towing
If a tow truck is not available in
an emergency, your vehicle may
be temporarily towed using a
cable or chain secured to the
emergency towing eyelet(s).
This should only be attempted
on hard surfaced roads for short
distances at low speeds.
A driver must be in the vehicle to
steer and operate the brakes.
The vehicle’s wheels, drive train,
axles, steering and brakes must
be in good condition.

546 5-1. Essential information
HILUX_EE (OM0K132E)
NOTICE
To prevent causing serious damage to the transmission and transfer
(4WD models) when towing using a wheel-lift type truck (vehicles with
automatic transmission)
Pre Runner: Never tow this vehicle from the front with the rear wheels on the
ground.
4WD models: Never tow this vehicle with any of the wheels in contact with
the ground.
To prevent damage to the vehicle when towing using a wheel-lift type
truck (vehicles with manual transmission)
Do not tow the vehicle from the rear when the engine switch is in the
“LOCK” position or the key is removed. The steering lock mechanism is
not strong enough to hold the front wheels straight.
When raising the vehicle, ensure adequate ground clearance for towing at
the opposite end of the raised vehicle. Without adequate clearance, the
vehicle could be damaged while being towed.
To prevent body damage when towing with a sling-type truck
Do not tow with a sling-type truck, either from the front or rear.

5
591 5-2. Steps to take in an emergency
When trouble arises
HILUX_EE (OM0K132E)
CAUTION
If the engine has to be turned off while driving
Power assist for the brakes and steering wheel will be lost, making the
brake pedal harder to depress and the steering wheel heavier to turn.
Decelerate as much as possible before turning off the engine.
Never attempt to remove the key, as doing so will lock the steering wheel.