Page 5 of 240

v
Table of contents
1 OPERATION OF INSTRUMENTS AND CONTROLSPage
1 Overview of instruments and controls
1 .......................
2 Keys and Doors11 ......................................
3 Seats, Seat belts, Steering wheel and Mirrors23 ...............
4 Lights and Wipers61 .....................................
5 Gauges, Meters and Service reminder indicators67 .............
6 Engine (ignition) switch, Transmission and Parking brake79 ......
7 Audio system83 .........................................
8 Air conditioning system91 .................................
9 Other equipment107 .....................................
2 INFORMATION BEFORE DRIVING YOUR TOYOTA 115........
3 STARTING AND DRIVING 131...............................
4 IN CASE OF AN EMERGENCY 149..........................
5 CORROSION PREVENTION AND APPEARANCE CARE 177...
6 MAINTENANCE REQUIREMENTS 183.......................
7DO−IT−YOURSELF MAINTENANCE
1 Introduction187 .........................................
2 Engine and Chassis195 ..................................
3 Electrical components207 .................................
8 SPECIFICATIONS 219......................................
9 INDEX 229................................................
Dyna100/150_EE
Page 7 of 240
OVERVIEW OF INSTRUMENTS AND CONTROLS1
Section 1−1
OPERATION OF INSTRUMENTS AND
CONTROLS
Overview of instruments and controls
DInstrument panel overview 2.............................
DInstrument cluster overview 6...........................
DIndicator symbols on the instrument panel 8..............
Dyna100/150_EE
Page 12 of 240
6OVERVIEW OF INSTRUMENTS AND CONTROLS
1. Service reminder indicators and
indicator lights
2. Speedometer
3. Trip meter reset knob4. Odometer and two trip meters
5. Fuel gauge
6. Engine coolant temperature gauge
Dyna100/150_EE
Instrument cluster overview
"Without tachometer
Page 13 of 240
OVERVIEW OF INSTRUMENTS AND CONTROLS7
1. Service reminder indicators and
indicator lights
2. Speedometer
3. Tachometer4. Trip meter reset knob
5. Odometer and two trip meters
6. Fuel gauge
7. Engine coolant temperature gauge
Dyna100/150_EE
"With tachometer
Page 14 of 240
8OVERVIEW OF INSTRUMENTS AND CONTROLS
Brake system warning light
Charging system warning light
Low engine oil pressure warning light
Low engine oil level warning light
Malfunction indicator lamp
Low fuel level warning light
Anti−lock brake system warning light
SRS warning light
DPF (Diesel Particulate Filter) system indicator
light
Timing belt replacement warning light
Fuel filter warning light
Engine oil change reminder light
Headlight high beam indicator light
Dyna100/150_EE
Indicator symbols on the instrument panel
Page 15 of 240
OVERVIEW OF INSTRUMENTS AND CONTROLS9
Turn signal indicator lights
Engine preheating indicator light
The indicators marked withare service reminder indicators. For
details, see “Service reminder indicators and warning buzzer” on
page 73 in Section 1−5.
Dyna100/150_EE
Page 41 of 240
SEATS, SEAT BELTS, STEERING WHEEL AND MIRRORS35
The driver ’s seat belt pretensioner is
designed to be activated in response to
a severe frontal impact.
When the airbag sensor detects the shock
of a severe frontal impact, the driver ’s
seat belt is quickly drawn back in by the
retractor so that the belt snugly restrains
the driver.
Collisionsoccurring at certain speeds and
angles may cause the seat belt preten-
sioner and SRS airbag not to operate all
together.This indicator comes on when the en-
gine switch is turned to the “ON” posi-
tion. It goes off after about 6 seconds.
This means the driver ’s seat belt pre-
tensioner is operating properly.
This warning light system monitors the
airbag sensor assembly, airbag sensor,
driver ’s seat belt pretensioner assembly,
inflator, interconnecting wiring and power
sources. (For details, see “Service remind-
er indicators and warning buzzer” on page
73 in Section 1−5.)
Dyna100/150_EE
—Driver’s seat belt
pretensioner
Page 43 of 240

SEATS, SEAT BELTS, STEERING WHEEL AND MIRRORS37
NOTICE
Do not perform any of the following
changes without consulting any autho-
rized Toyota dealer or repairer, or
another duly qualified and equipped
professional. Such changes can inter-
fere with proper operation of the
driver ’s seat belt pretensioner in
some cases.
zInstallation of electronic devices
such as an RF−transmitter, cassette
tape player or compact disc player
zRepairs on or near the driver ’s seat
belt retractor assembly
zModification of the suspension sys-
tem
zModification of the front end struc-
ture
zAttachment of a grille guard (bull
bar, kangaroo bar, etc.), snowplow,
winches or any other equipment to
the front end
zRepairsmadeonornearthefront
end structure or console
This driver ’s seat belt pretensionersystem
has a service reminder indicator to inform
the driver of operating problems. If any of
the following conditions occurs, this
indicates a malfunction of the airbag or
pretensioner. Contact any authorized
Toyota dealer or repairer, or another duly
qualified and equipped professional, as
soon as possible to service the vehicle.
DThe light does not come on when the
engine switch is turned to the “ON”
position or remains on for more than
6 seconds or flashes.
DThe light comes on or starts flashing
while driving.
DIf the driver ’s seat belt does not retract
or cannot be pulled out due to a mal-
function or activation of the relevant
driver ’s seat belt pretensioner.
Dyna100/150_EE