Page 438 of 828
02-24
▶Ignition Key Reminder
The system outputs "UNLOCK" signal for 5 seconds after the driver's door is opened and
the door lock switch is changed to "LOCK" (while the ignition key is in ignition switch).
The system outputs "UNLOCK" signal for 5 seconds when the door lock switch is changed
to "LOCK" from "UNLOCK" and the driver's door is closed within 0.5 seconds (while the
ignition key is in the ignition switch).
If the "UNLOCK" conditions are met, the system outputs "UNLOCK" signal unconditionally.
However, if the ignition key is removed after the door lock switch is changed from
"UNLOCK" to "LOCK", the system does not output "UNLOCK" signal. -
-
-
Page 439 of 828
02-258710-01
▶All Door Lock Prevention Function when a Door is Open
All doors, except the tailgate and hood, output "UNLOCK" signal for 5 seconds when the
"LOCK" signal is inputted (while the ignition key is removed and one of any doors is open).
When the door is closed during the UNLOCK output for approx. 5 seconds, the UNLOC
K
output stops immediately.
When the ignition key is inserted during the 5 seconds output, the output continues for
approx. 5 seconds.
If the ignition switch is in the "ON" position or the ignition switch is removed, the above
steps are performed. If the key is in the key cylinder, the ignition key reminder function is
activated.
This function does not work if the vehicle speed is over 10 km/h. -
-
-
-
-
Page 440 of 828
02-26
▶Tail Lamp Left On Warning
The chime buzzer sounds with the interval of 0.8 second when opening the driver's door
while the tail lamp is turned on and the ignition key is removed.
The c/buzzer output stops when turning off the tail lamp and closing the driver's door.
The system outputs "UNLOCK" signal for 5 seconds when the driver's and passenger's door
lock switch is locked (while the tail lamp is turned on and the driver's door is open).
This function does not work when the IGN1 switch is in "ON" position. -
-
-
-
Page 444 of 828

02-30
▶Center Room Lamp Control
The overhead console lamp (front room lamp) and the center room lamp come on at 100%
when opening the door (driver's/passenger's/rear) while the center room lamp switch is at the
door coupled/tailgate coupled operating position and the key reminder switch is "OFF".
When the door (driver's/passenger's/rear) is opened, the front and center room lamps
come on at 100% and automatically go off after 30 seconds.
The room lamp stays on for 2 seconds and then dims through 3 seconds when closing the
doors within 30 seconds.
The dimming operation must have greater than 32 steps per one second.
The room lamp output should stop immediately after turning on the ignition key during the
dimming operation.
The front room lamp and the center room lamp come on for 30 seconds when receiving
the unlock signal from the remote control key while the doors are closed.
The front room lamp and the center room lamp output period is extended by 30 seconds
when receiving the unlock signal from the remote control key again during output under
step (5). (The lamp stays on when unlocked by the remote control key.)
When a door is opened during its extended period, the lamp stays on. If closed, operates
as in step (2).
The room lamp output stops immediately after receiving the lock signal from door lock
switches while all doors are closed or entering into the anti-theft mode by pushing LOC
K
button on the remote control key. 1.
2.
3.
4.
5.
6.
7.
8.
Page 446 of 828
02-32
▶Ignition Key Hole Illumination
The ignition key hole illumination comes on when opening the driver's door or passenger's
door while the ignition key is removed.
The ignition key hole illumination stays on for 10 seconds when closing the door after step
(1).
The output stops when the ignition key is turned to the "ON" position.
The output stops when receiving the lock signal from the remote control key and entering
armed mode. 1.
2.
3.
4.
▶Key cylinder with key hole illumination
With diesel and gasoline engine With diesel engine With gasoline engine
Without immobilizer
(rechargeable)
→With key hole
illumination With immobilizer
(rechargeable)
→With key hole
illumination With immobilizer
→Without key hole
illumination and
rechargeable function
Page 453 of 828
02-398710-01
▶Door Lock/Unlock Control by Door Lock Switch
The door lock system outputs "LOCK" signal for 0.5 seconds when positioning the driver's
or passenger's door lock knob to the lock from unlock position.
The door lock system outputs "UNLOCK" signal for 0.5 seconds when positioning the
driver's or passenger's door lock knob to the unlock from lock position.
"LOCK" or "UNLOCK" by the door lock switch is ignored when outputting the "LOCK" or
"UNLOCK" signal by other functions.
All door lock signals are "UNLOCK" for 0.5 seconds just for once when receiving the
"LOCK" signal within 0.5 seconds after closing the driver's or passenger's door while the
ignition key is removed. 1.
2.
3.
4.
Page 454 of 828
02-40
▶Door Lock/Unlock Control by Central Door Lock Switch
When the central door lock switch is activated, LOCK/UNLOCK output is performed.
(However, if the driver's/passenger's lock switch is previously locked, UNLOCK output is
performed and if the driver's/passenger's lock switch is unlocked, LOCK output is
performed.)
The input of the central door lock switch is overridden in armed mode. 1.
2.
Page 455 of 828
02-418710-01
▶Door Lock/Unlock Control by Remote Control Key
The door lock relay output is "ON" for 0.5 seconds when receiving the lock signal from the
remote control key.
The door unlock relay output is "ON" for 0.5 seconds when receiving the unlock signal
from the remote control key. 1.
2.