2012 SSANGYONG KORANDO tailgate

03-36
Remote door lock ▶
When briefly pressing (below 0.5 sec) the LOCK button on the transmitter, the doors are locked.
The BCM sends the door lock signal immediately after receiving the door lock message from the
transmitter. When door close, hood close and door lock status is detected, it outputs the turn signal
lamp signal.
Only when door close, hood close and door lock conditions are satisfied after door lock is performed,
the turn signal lamp signal is outputted.
The REKES operation is not available when the ignition key is in the key switch. Also, it is not
possible to use the switches on the remote control key for 1 second after removing the ignition key
from the ignition switch to avoid unintended operation.
If any of doors could not be locked when pressing the LOCK switch, the system performs the unlock
operation. 1.
2.
3.
4.
5.
Door lock ▶
Locking door and tailgate (briefly press)
If you press this button, all doors and the tailgate are locked and the theft deterrent mode is
activated.
When the theft deterrent mode is activated, the hazard warning flasher blinks twice. However, when
pressing this button once again within 4 seconds, the hazard warning flasher blinks twice and buzzer
sounds once. 1.
-
-

03-38
After 30 seconds delay auto door lock ▶
If a door or tailgate is not opened within 30 seconds after unlocking the doors with remote control key
in theft deterrent mode, all doors will be automatically locked again (change to theft deterrent mode).
If any door is not opened or the key is not detected within 30 seconds after receiving the unlock
signal, the lock signal is outputted and theft deterrent mode is activated.
When entering into the theft deterrent mode, the turn signal lamps blink twice and the exterior buzzer
sounds once for SKM the lamps blink twice and burglar alarm horn sounds once for REKES. 1.
2.

03-438710-01
Auto door lock control ▶
Door lock output is activated when the vehicle speed is maintained above 30 km/h with IGN1 ON.
However, if all the doors are locked or fail, lock output is not activated.
If any of doors is not locked after Step (1), BCM activates the door lock output up to 5 times.
If the door is still unlocked, BCM considers the door as Fail.
If the failed door is changed from UNLOCK to LOCK, the fail record the side fascia panel.
If there is any failed door, the auto door lock function is not available.
(Even though the vehicle speed is increased over 30 km/h again after decreased below 30 km/h, BCM
does not send the auto door lock signal.)
When receiving the unlock signal for another door during Step (2), BCM sends the lock
signal for the door up to 5 times.
The unlock output is activated automatically when door lock output conditions are met by this function
or the IGN1 switch is turned to OFF from ON position (even though the lock output is not activated if
the vehicle speed is maintained above 30 km/h under lock condition). (If the LOCK condition is
established with the ignition switch ON, the system outputs UNLOCK signal unconditionally when
turning the ignition switch to OFF position.)
However, whether the door lock output condition is met or not is initialized when the IGN1 switch is
turned to OFF position.
When turning the ignition off, the fail record for a door will be initialized.
If any of door lock switches is in LOCK position when turning the ignition off, all doors are unlocked. 1.
2.
3.
4.
5.
6.
7.
8.
9.
(*1) Lock: All doors including tailgate are locked.
Unlock: All doors including tailgate are unlocked.

03-478710-01
Coming home lighting control ▶
The low beam keeps on for 30 seconds when the ignition switch is turned to ON from OFF position
with the headlamp ON.
Coming home lighting OFF condition
This function can be activated or deactivated with the diagnostic device. (default setting: active) 1.
2.
3.3 minutes after all doors and tailgate are open and closed
(lighting goes off 30 seconds after without extension when the closed doors are open)
When receiving REKES and passenger door lock signals (close, open, close) twice during coming
home lighting operation
Lighting goes off during its operation when headlamp and AUTO light switch are turned to other
position than ON
Lighting goes off when ignition switch is turned to ON position -
-
-
-
13) Headlamp

03-48
14) Tailgate
Tailgate control in BCM without SKM ▶
When pressing the tailgate switch for more than 0.1 second with driver door unlocked and vehicle
<009a0097008c008c008b00470089008c00930096009e0047005a0047004f00b700570055005800500047009200940056008f00530047009b008f008c0047009b008800900093008e0088009b008c004700960097008c009500470099008c0093008800a000
470090009a0047009b009c00990095008c008b004700760075> for about 1 second, with
power OFF, ACC ON or IGN ON. However, it is turned ON when the vehicle speed is below 3
(±0.1) km/h, with IGN ON.
The tailgate open relay is turned OFF immediately after the driver door is locked or the vehicle speed
goes over 3 km/h with IGN ON during its operation. However, the BCM does not operate if the
tailgate open switch is pressed when the vehicle speed is above 3 km/h. 1.
2.
<007b008800900093008e0088009b008c004700960097008c0095006100470079006c0072006c007a0047009c009500930096008a00920047004f008b0090009a008800990094008c008b0047008b008c009b008c00990099008c0095009b00470094009600
8b008c0050004702e70047007b008800900093008e0088009b>e open signal → Tailgate
open -
Tailgate control in BCM with SKM ▶
When pressing the tailgate switch for more than 0.1 second with driver door unlocked and vehicle
<009a0097008c008c008b00470089008c00930096009e0047005a0047004f00b700570055005800500047009200940056008f00530047009b008f008c0047009b008800900093008e0088009b008c004700960097008c009500470099008c0093008800a000
470090009a0047009b009c00990095008c008b004700760075> for about 1 second.
The tailgate open relay is turned OFF immediately after the driver door is locked or the vehicle speed
goes over 3 km/h during its operation.
When the tailgate switch on smart key is pressed in theft deterrent mode or with the smart key
detected by the exterior antenna, the SKM verifies the smart key and disarms the tailgate only. When
the tailgate is open and closed, the system enters into the theft deterrent mode again. If the tailgate
switch is not operated for 30 seconds, the system also does so.
The BCM checks that the verified smart key is in the luggage room 1 second after when the closed
tailgate is detected by the tailgate open switch with power OFF.
If there is a verified smart key in the luggage room when the tailgate is open and closed in theft
deterrent mode, the external buzzer sounds for 5 seconds.
When the driver press the tailgate open switch in order to look for the smart key, the BCM deactivates
lock so that the tailgate can be opened even though the driver door is locked. (maintains standby for
opening without verification) 1.
2.
3.
4.

03-498710-01
15) Theft Deterrent Alarm
Theft deterrent alarm control in BCM without SKM ▶
Entering into theft deterrent mode by REKES remote control 1.
When receiving the door lock signal with the key removed, all doors including tailgate and engine
hood closed, all doors are locked and the theft deterrent mode is activated. At this moment, the
turn signal lamps blink twice.
When pressing the lock switch on remote control key again in 4 seconds, the turn signal lamps
blink twice and the horn sounds once in the theft deterrent mode. In other words, when pressing
the door lock button once, all the doors are locked and the turn signal lamps only blink twice, and
another press in 4 seconds makes the turn signal lamps blink twice and alarm horn sound once.
When receiving the door lock signal with any door (except tailgate and engine hood) open, the
doors are unlocked immediately after locking them first.
When receiving the door lock signal with the tailgate or engine hood open, the doors are closed if
they are open, but the theft deterrent mode is not activated. However, when closing the opened
tailgate or engine hood, the theft deterrent mode is activated with two blinks of turn signal lamps.
If a door or tailgate is not opened within 30 seconds after unlocking the doors with remote control
key in theft deterrent mode, all doors will be automatically locked again (re-lock operation). When
entering into the theft deterrent mode, the turn signal lamps blink twice and the horn sounds once.
The theft deterrent mode can be activated only when the above conditions are satisfied.
Ex) The theft deterrent mode cannot be activated when locking the doors with key hole on door. -
-
-
-
-
-

03-50
Disarming by REKES remote control 2.
When unlocking the doors or turning the ignition switch to ON position.
When receiving the door unlock signal in theft deterrent mode, all doors are unlocked and the turn
signal lamps blink once (the horn does not sound).
When receiving the door unlock signal with the theft deterrent mode disarmed, the turn signal
lamps blink once (the horn does not sound). -
-
-
In theft deterrent mode
BCM observes the conditions below continuously: 3.
Battery connection (B+)
Front/rear door open
Tailgate open
4 doors lock/unlock
Engine hood open -
-
-
-
-
Activation of theft deterrent alarm 4.
When any of doors, tailgate or engine hood is open in theft deterrent mode
When unlocking the door lock switch in theft deterrent mode
When opening a door after completion of theft deterrent alarm (for 30 seconds)
Horn and the turn signal lamps operate for 30 seconds with the interval of 0.5s ON/0.5s OFF. -
-
-
-
Disarming conditions of theft deterrent mode 5.
When pressing any switch (lock, unlock, panic) on the remote control key during the theft deterrent
alarm, the alarm stops its operation.
When turning the ignition switch to ON position during the theft deterrent alarm, the alarm stops its
operation.
(For vehicle with immobilizer system, the alarm stops after completion of authorization. For vehicle
without immobilizer system, the alarm stays ON for 30 seconds)
When turning the ignition switch to ON position during the theft deterrent alarm, the alarm stops
and the theft deterrent mode is deactivated after 30 seconds (remaining time).
If there is not any disarming commend, the alarm stays ON for 30 seconds and the theft deterrent
mode continues. -
-
-
-
Operation when disarming 6.
The horn and the turn signal lamps stop their operation. -

03-52
Theft deterrent alarm control in BCM with SKM ▶
Entering into theft deterrent mode by smart key remote control 1.
When receiving the door lock signal from the smart key remote control with power OFF or ACC ON
and tailgate and engine hood closed, the doors are locked and the theft deterrent mode is
activated. At this time, the turn signal lamps blink twice and the exterior buzzer sounds once at
interval with 50 ms ON/50 ms OFF. (SKM turns off the vehicle and sends the signal, when ACC
ON)
The BCM unlock the doors immediately after locking them first without operating turn signal lamp
and exterior buzzer and the system does not enter into theft deterrent mode, if the door lock signal
is received from the smart key remote control when the driver door is unlocked and any of doors is
open.
The BCM locks all the doors and system does not enter into theft deterrent mode if all the doors are
closed when the door lock signal is received from the smart key remote control with the tailgate and
engine hood open. However, if the tailgate and engine hood is closed, the turn signal lamps blink
twice, exterior buzzer sounds once and theft deterrent mode is entered.
If all the doors, tailgate or engine hood is open or the ignition switch is not turned to ON position
within 30 seconds after receiving the door unlock signal from the smart key remote control, the
doors are locked, turn signal lamps blink twice, exterior buzzer sounds once and theft deterrent
mode is re-activated.
The theft deterrent mode can be activated only when the above conditions are satisfied, excepting
manual lock.
Ex) The theft deterrent mode cannot be activated when locking the doors with key hole on door. -
-
-
-
-