2012 SSANGYONG KORANDO headlamp

03-478710-01
Coming home lighting control ▶
The low beam keeps on for 30 seconds when the ignition switch is turned to ON from OFF position
with the headlamp ON.
Coming home lighting OFF condition
This function can be activated or deactivated with the diagnostic device. (default setting: active) 1.
2.
3.3 minutes after all doors and tailgate are open and closed
(lighting goes off 30 seconds after without extension when the closed doors are open)
When receiving REKES and passenger door lock signals (close, open, close) twice during coming
home lighting operation
Lighting goes off during its operation when headlamp and AUTO light switch are turned to other
position than ON
Lighting goes off when ignition switch is turned to ON position -
-
-
-
13) Headlamp

03-638710-01
19) DRL (Daytime Running Light) Control
When receiving the DRL activation signal, the tail lamps are turned ON when turning the ignition
switch to ON position, and the headlamps are turned ON when the engine speed is 300 rpm or
higher.
When turning ON the tail lamp switch during engine running, the headlamps are turned OFF.
The headlamps do not come ON when the engine speed is above 300 rpm with the tail lamp switch
ON.
The auto light sensor is not available in the vehicle with DRL system.
If there is no DRL activation signal, the light system operates in normal conditions. 1.
2.
3.
4.
5.
20) Fog Lamp Control
When pressing the rear fog lamp switch with IGN2 ON (headlamp ON condition), the rear fog lamps
are turned ON. When pressing the rear fog lamp switch again during the operation, the rear fog lamps
are turned OFF.
The rear fog lamps do not come ON when the IGN2 switch is turned to OFF position or the light
switch is OFF.
The rear fog lamps should not automatically come on again if they have been turned OFF by any
other way other than the switch. 1.
2.
3.
(The rear fog lamps are applied to only EU region)

03-64
21) Auto Light Control (LIN)
The BCM communicates with the auto light sensor when turning the ignition switch to ON position, and
controls the tail lamps and the headlamps depending on the LIN data with the light switch AUTO. 1.

05-118010-01
Indicator
(green)
Headlamp high beam indicator ▶
Front fog lamp indicator ▶
Side light indicator ▶
Indicator
(blue)
Indicator
(green)
Indicator
(amber)
Glow indicator(DSL only) ▶
Indicator
(red)
Fuel filter indicator(DSL only) ▶This indicator comes on when the tail lamp is switched on.
This indicator comes on when the ignition switch is turned to the "ON"
position and will go off when the glow plugs are sufficiently heated.
This indicator comes on when the water level in the fuel filter exceeds a
certain level. This lamp comes on when the headlamp high beam is operated.
This indicator comes on when the fog lamp switch is operated after the tail
lamps comes on.
3) Details of Warning Lamps and Indicators

06-26
Lower main panel switch
3) Lower Main Panel Switch
Rear fog lamp switch(EU ONLY)
Steering wheel heating switchHLLD(Headlamp Leveling Device)4WD LOCK switch
ESP OFF switch

06-278510-00
4WD LOCK switch
This switch is of push lock type, which
enables to increase/decrease the
torque to the rear wheels in AWD
mode.
Steering wheel heating switch
This switch is of push return type,
which is used to activate or deactivate
the steering wheel heating function.
ESP OFF switch
The ESP OFF switch is of push return
type, which is used to stop or resume
the ESP function.
4WD LOCK switch
This switch is of push lock type, which
enables to increase/decrease the
torque to the rear wheels in AWD
mode.
HLLD
(Headlamp Leveling Device)
The headlamp aiming can be adjusted
by using this dial-type switch.
Rear fog lamp switch
(EU ONLY)
This switch is of push return type,
which sends ON/OFF signal to the
BCM so that the BCM can switch on
the lamps by activating the rear fog
lamp relay.

06-32
Light switch ▶
Headlamps ON
Headlamp, side-marker, tail,
license plate, fog, and
instrument cluster lamps come
on.
Tail lamp ON
Side-marker, tail, license plate,
fog, and instrument cluster
lamps come on.
Automatic light ON
Head- and tail lamps
automatically turn on or off based
upon the intensity of the sunlight
analyzed by the automatic light
sensor.Lights OFF
High beam ON
To turn on the headlamp high
beam, push the lever towards
the instrument cluster with the
headlamp low beam on.Right turn signal lamp blinks
Passing
Regardless of the position of the light
switch, when holding the lever toward
the steering wheel, the headlights are
on high beam during the hold.Front fog lamp switch
To turn on the fog lights, turn this
switch while the tail lamps or
headlamps are turned on. Left turn signal lamp blinks

07-2
1. LAMP SPECIFICATIONS
1) Exterior Lamps
Item Type Amount
Front lampHeadlamp (high beam/low beam) BULB: H4 2 EA
Turn signal lamp BULB: PY21W 2 EA
Position lamp BULB: W5W 2 EA
Fog lamp BULB: H27W/2 2 EA
Rear lamp
Stop lamp and tail lampBULB: 12V27/8W (Korea)
P21/5W (Other countries)2 EA
Turn signal lampBULB: 12V27W (Korea)
P21W (Other countries)2 EA
Backup lampBULB: 12V27W (Korea)
P21W (Other countries)2 EA
Stop lamp/Rear fog lamp
(Other countries)BULB: 12V27W (Korea)
P21W (Other countries)2 EA
High-mounted stop lamp LED
(Without spoiler)
(With spoiler)12 EA
24 EA
License plate lamp BULB: W5W 2 EA
Side lampSide repeater lamp LED 5 EA
Puddle lamp LED 2 EA
2) Interior Lamps
Item Type Amount
Front room lampBULB (10W-FESTOON) 2 EA
Center room lampBULB (10W-FESTOON) 1 EA
Luggage lampBULB (10W-FESTOON) 1 EA
Sun visor lampBULB (5W-FESTOON) 1 EA
Glove box lampBULB (5W-FESTOON) 1 EA
Door courtesy lampBULB (5W-WEDGGE) 1 EA
Item Type Amount
Front lampHeadlamp (high beam/low beam) BULB: H4 2 EA
Turn signal lamp BULB: PY21W 2 EA
Position lamp BULB: W5W 2 EA
Fog lamp FRT BULB: H27W/2 2 EA
RR BULB: H21W/2 2 EA