2012 SKODA SUPERB fog light

No. Power consumer
F40 Lambda probe F41 AKF valve
F42 Lambda probe
F43 Ignition
F44-46 Not assigned F47 Front left main headlight, left tail light
F48 Pump for ABS F49 Power supply for terminal 15 (ignition on)
F50-51 Not assigned F52 Power supply relay - terminal X a)
F53 Accessories
F54 Not assigned a)
In order not to drain the battery unnecessarily when starting the engine, the electrical components
of this terminal are automatically switched off.
Fuse assignment in the engine compartment - version B No. Power consumer
F1 Not assigned
F2 Control unit for automatic gearbox DSG
F3 Measuring circuit
F4 Valves for ABS F5 Control unit for automatic gearbox DSG
F6 Not assigned F7 Power supply for terminal 15 (ignition on)
F8 Radio F9 Not assigned
F10 Engine control unit, Main relay F11 Auxiliary heating and ventilation control unit
F12 Data bus control unit
F13 Engine control unit
F14 Ignition F15 Lambda probe (petrol engine), glow plug system relay and fuel pump (diesel engine) No. Power consumer
F16 Front right main headlight, right tail light F17 Horn
F18 Audio amplifier (sound system) F19 Windscreen wipers
F20 Valve for fuel dosing Coolant pump
F21 Lambda probe
F22 Clutch pedal switch
F23 Relay, valves, high pressure pump
F24 Radiator fan F25 Pump for ABS
F26 Left main headlight F27 Control unit for glow plug system
F28 Windscreen heater F29 Accessories
F30 Power supply relay - terminal X a) a)
In order not to drain the battery unnecessarily when starting the engine, the electrical components
of this terminal are automatically switched off. Ð Bulbs
ä
Introduction
This chapter contains information on the following subjects:
Headlights 211
Fog lights and daylight driving lights 212
Tail lamp assembly 213
Tail light (Combi) 214
Licence plate light 214
Licence plate light (Combi) 215
Some manual skills are required to change a bulb. For this reason, if uncertain, we
recommend that bulbs are replaced by a ŠKODA specialist garage or other expert
help is sought. £
210 Do-it-yourself

Changing the bulb for the main beam
›
Open the bonnet.
› Remove the rubber cover 1
» Fig. 186
.
› Push the circlips B
together and unhook to the side.
› Remove the holder C
.
› Remove the faulty bulb from the holder and insert a new one.
› Insert the rubber cover.
Installation is carried out in the reverse order.
Changing the bulb for the low beam
› Open the bonnet.
› Remove the rubber cover 2
.
› Turn the connector with the bulb in an
anti-clockwise direction up to the stop
and remove » Fig. 187.
› Replace the lamp, insert the connector with the new bulb and turn
in a clock-
wise direction to the the stop.
› Insert the rubber cover. ÐFog lights and daylight driving lights
Fig. 188
Front bumper: Cover/fog lights with daylight driving lights
First read and observe the introductory information and safety warn-
ings on page 210.
Replacing bulbs
›
Grasp the cover in the areas marked by the arrows
» Fig. 188 -  and remove it.
› Insert your hand into the opening left by the cover and press the lug 3
» Fig. 188
-  .
› Remove the front fog lamp.
ä ›
Turn the connector 1
(daylight driving light) or 2
(fog light) with the bulb in
an anti-clockwise direction up to the stop and remove.
› Replace the lamp, insert the connector with the new bulb and turn
in a clock-
wise direction to the the stop.
› To re-install the fog light, first of all place the fog light with the lug on the side
opposite the license plate.
› Press in the fog lamp on the side closest to the license plate. The lug must en-
gage firmly.
› To reinstall the cover, first of all insert part of the cover starting on the side fac-
ing the fog light. Then press the cover on the side closest to the license plate.
The cover must engage firmly. Ð
212 Do-it-yourself

Tail lamp assembly
Fig. 189
Outer part of the tail light/Removing the internal part of the tail
light Fig. 190
Outer part of the tail light: Bulbs/Inner part of the tail light: Bulbs
First read and observe the introductory information and safety warn-
ings on page 210.
Overview of the location of the bulbs
» Fig. 190. 1
- Turn signal lights
2
- Parking lights/Brake light
3
- parking lights
4
- Reversing light
5
- Rear fog light
ä Removing and installing the outer part of the tail light
› Open the boot lid.
› Remove the plug
» Fig. 189 -  and unscrew the tail light with a torx
wrench » page 196, Vehicle tool kit .
› Carefully remove the light. Do not pull the grommet with the cables out of the
bodywork.
› To re-install the tail light, first of all guide it with the support A
°» Fig. 190 to-
wards the front onto a bolt on the bodywork.
› Carefully press the tail light onto the bodywork.
› Screw the tail light into place and push in the plugs
» Fig. 189 - .
Changing bulbs in the outer part of the tail light
› To replace the bulb, turn the bulb holder
anti-clockwise up to the stop and re-
move it from the housing.
› Replace the bulb, insert the holder with the bulb into the housing and turn
in a
clockwise direction to the the stop.
Removing and installing the inner part of the tail light
› Open the boot lid.
› Remove the tail light cover on the inner side of the boot lid
» Fig. 189 -  .
› Press the lug
» Fig. 189 -  and remove the lamp holder from the tail light
housing.
› To re-install, insert the lamp holder into the tail light housing.
› Press the lug until it clicks into place.
› Insert the tail light cover on the inner side of the boot lid.
Changing bulbs in the inner part of the tail light
› Remove the faulty bulb 4
» Fig. 190
from the holder and insert a new bulb.
› Turn the bulb 5
in an anti-clockwise direction
up to the stop and remove. In-
sert a new bulb into the holder and turn in a clockwise direction to the the
stop. Ð
213
Fuses and light bulbs

Tail light (Combi)
Fig. 191
Installing a tail light (Combi)
First read and observe the introductory information and safety warn-
ings on page 210.
Overview of the location of the bulbs
» Fig. 191.1
- Parking light/rear fog light
2
- Reversing light
3
- Turn signal lights
4
- Parking lights/Brake light
5
- parking lights
Removing and installing the tail light
› Open the boot lid.
› Remove the plug
» Fig. 191 and unscrew the tail light with a torx
wrench » page 196, Vehicle tool kit .
› Carefully remove the light. Do not pull the grommet with the cables out of the
bodywork.
› To re-install the tail light, first of all guide it with the openings A
°
» Fig. 191 on
to the bolts on the bodywork.
› Carefully press the tail light onto the bodywork until it clicks into place.
› Screw the tail light into place and push in the plugs.
Changing bulbs 1
, 3
and 5
›
Turn the bulb holder
anti-clockwise up to the stop and remove it from the
housing.
› Remove the faulty bulb from the holder and insert a new bulb.
ä
›
Insert the holder with the new bulb into the housing and turn
in a clockwise
direction to the the stop.
Changing bulbs 2
and 4
›
Turn the bulb holder
anti-clockwise up to the stop and remove it from the
housing.
› Push in the bulb, turn
in an anti-clockwise direction up to the stop and remove.
› Insert a new bulb into the holder, push in and turn
in a clockwise direction to
the the stop.
› Insert the holder with the new bulb into the housing and turn
in a clockwise
direction
to the the stop. Ð Licence plate light
Fig. 192
Rear bumper: Licence plate light
First read and observe the introductory information and safety warn-
ings on page 210.
›
Unscrew the glass cover of the light
» Fig. 192.
› Remove the faulty bulb from the holder and insert a new one.
› Replace the glass cover and push in until the stop. Make sure that you install
the glass cover in the correct position.
› Screw the glass cover of the light into place. Ð
ä
214 Do-it-yourself

Engine
Running in 158
Starting and stopping the engine 103
Engine compartment Brake fluid 181
Coolant 179
Overview 178
Vehicle battery 182
Engine oil Changing 179
Checking 178
Replenishing 179
Engine Oil Specification 219
Engine revolutions counter 9
Environment 159
Environmental compatibility 161
Environmentally friendly driving 159
ESC Function 110
Indicator light 22
F
Fire extinguisher 195
First-aid-box 195
Footmats 112
Front airbag 149
Front seats 66
Fuel 174
Diesel 176
Fuel gauge 9
gauge 9
refer to Fuel 174
Refuelling 174
Unleaded petrol 175
Fuel consumption 159
Fuses Assignment 207
Replacing 207 G
Gear Recommended gear 11
General view Cockpit 7
Glow plug system Warning light 24
GSM 128, 131
H
Handbrake 109
Head airbag 152
Headlight cleaning system Headlight cleaning system 62
Headlights Driving abroad 162
Headlight cleaning system 62
Head restraint 70
Heating Exterior mirror 64
Seats 69
Windscreen and rear window 58
Horn 7
I
Ignition 105
Ignition lock 105
Immobiliser 104
Indicator lights 18
Information display see MAXI DOT 15
Instrument Cluster 8
See Instrument Cluster 8
Instrument lighting 53
Interior monitor 34
Internet connection 134
ISOFIX 156 J
Jacking points Raise vehicle 199
Jump-starting 202
K
KESSY see Kessy system 32
Starting 105
KESSY system Starting 105
Unlocking the vehicle 32
Knee airbag 150
L
Lever Main beam 54
Turn signal 54
Windscreen wipers 60
Light Adaptive headlights (AHL) 51
Automatic driving lamp control 49
Cockpit 54
COMING HOME/LEAVING HOME function 50
Daylight driving light 49
Fog lights 52
Fog lights with the function CORNER 52
Hazard warning light system 53
Headlight beam adjustment 53
Headlight flasher 54
Low beam 49
Main beam 54
Parking light 49, 50
Rear fog lights 52
Replacing bulbs 210
Tourist light 51
Turn signal 54
227
Index