2012 Seat Toledo seats

115
Seats and storage
Rear shelf
Fig. 80 Removing the
shelf
Fig. 81 Removing the
shelf
The shelf can be removed if a large load is to be transported.
Removing the shelf
– Remove the straps from the shelf 1
⇒ Fig. 80.
– Remove the shelf from its housing 2
by knocking it gently from
underneath between the supports. Fitting the shelf
–
Place the shelf on the side supports on the trim.
– Adjust the shelf supports 3
⇒ Fig. 81 to fit the supports 2 in
the trim.
– Fit into place by knocking the top of the shelf gently between
the supports.
– Attach the straps 1
to the tray.
WARNING
Do not place objects on the rear shelf that could endanger the vehicle oc-
cupants in case of a sudden braking manoeuvre or an accident.
CAUTION
● The rear shelf supports a maximum load of 1 kg.
● If handled incorrectly, the tray could bend on closing the rear lid and be-
come damaged or damage the trim. Follow the instructions below.
–The shelf supports 3
⇒ Fig. 81 must be securely in place in the trim
supports 2.
– The size of the load must not exceed the height of the shelf.
– When open, the shelf must not be bent against the shelf seal.
– There must be no objects in the space between the open shelf and
the backrest of the rear seat.
Note
The shelf will lift when the rear lid is opened. 
Safety FirstOperating instructionsPractical TipsTechnical specifications

116Seats and storage
Roof carrier*
Introduction
WARNING
● The load on the roof carrier must be properly secured. Risk of acci-
dent!
● Always secure the load using retaining straps in good condition.
● Distribute the load evenly.
● When transporting heavy or large objects on the roof, any change in
the normal vehicle behaviour due to a change in the centre of gravity or
an increased wind resistance must be taken into account. Risk of acci-
dent! For this reason, a suitable speed and driving style must be used.
● Avoid sudden manoeuvres and braking.
● Adjust your driving style to suit visibility, the weather and road and
traffic conditions.
● Never exceed the allowed axle loads or allowed maximum weight.
Risk of accident!
CAUTION
● Only use SEAT-authorised roof carriers.
● Where roof carriers from other systems are used or where they are not
fitted properly, any damage caused to the vehicle will not be covered by the
warranty. Therefore, carefully follow the Instruction Manual for installation
of the roof carrier.
● On vehicles fitted with a sliding sunroof, make sure it does not hit the
load on the roof when opened
● Remember that the rear lid must not hit the roof load.
● The total height of the vehicle increases according to the roof load. Com-
pare the height of the vehicle with the heights of bridges or, for example,
the size of the garage door. ●
Do not forget to remove the roof carrier before entering an automatic
carwash.
● Take into account that the load must not damage the aerial located on
the roof.
For the sake of the environment
The increased air resistance means that the vehicle uses more fuel. 
Attachment points
Fig. 82 Basic roof carrier attachment points
Location of the basic roof carrier attachment points ⇒ Fig. 82.
rear attachment points
front attachment points
Install and remove following the instructions given.
CAUTION
Follow the instructions given in the manual. 
A
B

117
Seats and storage
Roof load
The maximum permissible roof load (including the support system) of 75 kg
and the total authorised weight of the vehicle must not be exceeded.
It will not be possible to carry the full maximum load if the roof carrier you
are using is rated for a load which is less than this figure. In this case, you
can only load the roof carrier to the maximum load permitted in your instal-
lation manual. 
Drink holder
Introduction
WARNING
● Do not put hot drinks in the drink holders. They could spill while the
vehicle is moving. Risk of scalding!
● Do not use cups or glasses made of fragile materials (e.g. glass or chi-
na). These could cause injury in the event of an accident.
CAUTION
Avoid putting open drinks containers in the drink holder while the vehicle is
moving. They could spill (e.g. on braking) and cause damage to the electri-
cal equipment or the seat covers. Drink holder in centre console
Fig. 83 Centre console: drink holder
Front drink holder in the centre console
Rear drink holder in the centre console 
Drink holder in the rear armrest
Fig. 84 Rear seats arm-
rest: drink holder
Two drinks can be placed in the drink holder. 
A
B
Safety FirstOperating instructionsPractical TipsTechnical specifications

118Seats and storage
Use the detachable parts A
and B ⇒ Fig. 84 to change the size of
the holes.
– Remove part A
or B in the direction indicated by the arrow
and replace in the required position in the drink holder. 
Ashtrays
Fig. 85 Centre console: front ashtray/rear ashtray
Removing the ashtray
– Pull the ashtray ⇒ Fig. 85 upwards to remove.
Inserting the ashtray
– Push the ashtray down.
WARNING
Never put flammable materials in the ashtray. Risk of fire!
CAUTION
Never hold onto the ashtray by the lid when removing it. Risk of breaking
the lid. 
Cigarette lighter, 12V power socket Cigarette lighter
Fig. 86 Centre console:
cigarette lighter
The cigarette lighter is located at the front of the centre console
⇒ Fig. 86.
Using the cigarette lighter
– Press the cigarette lighter knob ⇒ Fig. 86.
– Wait for the lighter to spring out.
– Pull out the cigarette lighter and light the cigarette on the glow-
ing coil immediately.
– Put the cigarette lighter back in its socket. 

119
Seats and storage
WARNING
● Take care when using the cigarette lighter! Carelessness or negli-
gence when using the cigarette lighter can cause burns and serious inju-
ries.
● The cigarette lighter also works when the ignition is off and when the
ignition key is removed. Therefore, never leave children unsupervised in
the vehicle.
Note
● The 12 volt power socket of the cigarette lighter can also be used as a
power source for electrical appliances ⇒ page 119, 12 V power socket.
● Additional information ⇒ page 195, Accessories, modifications and
spare parts. 
12 V power socket
Fig. 87 Centre console:
12V power socket
The 12 V power socket is located at the front of the centre console
⇒ Fig. 87. Using the power socket
–
Open the cover or remove the cigarette lighter concealing the
socket.
– Insert the plug of the electrical appliance into the socket.
Additional information ⇒ page 195, Accessories, modifications and spare
parts.
WARNING
● Improper use of the sockets or electrical appliances can cause a fire
and lead to burns and other serious injuries.
● Never leave children unsupervised in the vehicle. The 12 volt power
socket is also operate when the is ignition switched off and the key re-
moved.
● Should the connected appliance overheat, immediately switch it off
and disconnect it from the socket.
CAUTION
● The 12V power socket can only be used to power appliances with a pow-
er rating of up to 120 Watt.
● Never exceed the maximum permitted power, as this could cause dam-
age to the vehicle electrical installation.
● When the engine is switched off, however, the vehicle battery will be
drained. Risk of flat battery!
● Only use suitable plugs so as not to damage the power socket.
● Only use appliances that have been tested for electromagnetic compati-
bility in compliance with current regulations.
● Before switching the ignition on or off, unplug the appliances from the
power socket to protect them from any damage caused by fluctuations in
voltage.
● Follow the instructions for use of connected appliances! 
Safety FirstOperating instructionsPractical TipsTechnical specifications

120Seats and storage
Storage compartment
Summary
The following storage areas are available in the vehicle:
Passenger side glove compartment⇒ page 120Compartment for reflective vest⇒ page 121Storage compartments in front seats⇒ page 121Net pockets on back of front backrests⇒ page 122Storage compartment for (sun)glasses⇒ page 122Storage compartments in centre console⇒ page 123Multimedia compartment⇒ page 123Storage compartments in doors⇒ page 123Storage compartment in luggage compartment⇒ page 124
WARNING
● Never place any objects on the instrument panel. These objects could
be flown around the interior while the vehicle is moving (on accelerating
or turning) and distract you. Risk of accident!
● Make sure objects remain in the centre console or other compart-
ments while the vehicle is moving. Otherwise, this would prevent you
from braking, changing gear or accelerating. Risk of accident!
 Passenger side glove compartment
Fig. 88 Instrument pan-
el: passenger side glove
compartment
Fig. 89 Storage: cooling
control
Opening and closing passenger side glove compartment
– Pull the catch on the lid in the direction indicated by the arrow
⇒ 
Fig. 88 and open the lid.
– Close the lid and push it until it engages.
Storage compartment lighting
– The light will come on automatically when the glove compart-
ment is opened. 

121
Seats and storage
– The light will go out when the glove compartment is closed.
Glove compartment cooling*
Open or close the air outlet by turning the thumbwheel ⇒ Fig. 89.
If the air outlet is open and the air conditioning is on, the cooled air will be
released into the glove compartment.
If the air outlet is open and the air conditioning is off, outdoor air (not con-
ditioned) will be released into the glove compartment.
The air outlet should be closed if the air conditioning is being used in heat-
ing mode or where glove compartment cooling is not in use.
WARNING
For safety reasons, all storage compartments must be closed while the
vehicle is moving.
Note
A maximum 1 litre bottle can be stored in the glove compartment. Compartment for reflective vest
Fig. 90 Driver seat: stor-
age
There is a compartment below the driver seat ⇒ Fig. 90 to store the reflec-
tive vests.
WARNING
The compartment is solely designed to store the reflective vest and no
other objects. Objects falling out of the storage compartment could limit
or prevent use of the pedals.
CAUTION
The compartment is solely designed to store the reflective vest and no other
objects. Risk of damage to the storage compartment. 
Storage compartments in front seats
There is a storage pocket on the rear part of the backrest of the front seats.
These pockets are designed to hold maps, magazines, etc. 
Safety FirstOperating instructionsPractical TipsTechnical specifications

122Seats and storage
WARNING
Do not place heavy objects in the pockets. Risk of injury!
CAUTION
Do not place overly large objects in the pockets (e.g. bottles) or objects with
sharp edges. Risk of damage to the pockets and the upholstery. 
Net pockets on back of front backrests
Fig. 91 Front seats
backrests: net pockets
There are net pockets on the inside part of the front seats backrests
⇒ Fig. 91.
These pockets are designed to hold lightweight objects such as a mobile
phone or an mp3 player.
WARNING
● Do not exceed the maximum load that the net pockets can support.
Heavy objects cannot be safely secured. Risk of injuries!
CAUTION
● The net pockets support a maximum load of 150 g.
● Do not place overly large objects in the pockets (e.g. bottles) or objects
with sharp edges. Risk of damage to the pockets. 
Storage compartment for (sun)glasses
Fig. 92 Close-up of roof
panel: storage compart-
ment for (sun)glasses
– Press the compartment lid and it will drop down ⇒ Fig. 92.
WARNING
This compartment must only remain open when removing or replacing
(sun)glasses.
CAUTION
● Do not place heat-sensitive objects in the compartment as they could be
damaged.
● The side compartment supports a maximum load of 0.25 kg. 