2012 RENAULT ESPACE overheating

JauneNoirNoir texte
1.51
ENG_UD20347_1
Tableau de bord : afficheurs et indicateurs (X81 - J81 - Renault)
ENG_NU_932-3_X81ph3_Renault_1
InsTrUMenT P aneL: displays and indicators (continued)
coolant temperature
indicator 6
Under normal use, the level must be
below zone 6a . Under severe condi -
tions the needle may approach this
zone. This is not serious unless the
û warning light comes on, accom-
panied by the “engine overheating”
message on the instrument panel, a
beep, and the 6a warning light.
fuel gauge 7
The number of lit squares shows the re-
maining fuel level.
When it is at minimum, the bottom
square lights up and flashes. Then a
beep will be heard: refill as soon as
possible.
Information display 8
Depending on the vehicle, it includes:
– the time;
– the exterior temperature;
– radio information;
– navigation aid information.
86a
67

1.61
ENG_UD24102_1
Ordinateur de bord : messages d’alerte (X81 - J81 - Renault)
ENG_NU_932-3_X81ph3_Renault_1
TrIP cOMPUTer: warning messages (1/2)
These appear with the û warning light and require you to stop immediately, for your own safety, as soon as traffic
conditions allow. stop your engine and do not restart it. contact an approved dealer.
Examples of warning messages are given in the following pages. note: the messages appear on the display either individually
or alternately (when there are several messages to be displayed), and \
may be accompanied by a warning light and/or a beep.
Messages Interpretation of messages
« InJecTIOn faULT » Indicates that the vehicle has a serious engine fault.
« PUncTUre cHanGe TYre »Indicates a puncture in the tyre shown on the tyre pressure monitor disp\
lay.
« enGIne OVerHea TInG »Indicates that the engine is overheating.
« cHecK sTeerInG » Indicates a fault in the vehicle’s power-assisted steering.

1.72
ENG_UD20355_1
Essuie-vitre/lave-vitre avant (X81 - J81 - Renault)
ENG_NU_932-3_X81ph3_Renault_1
WIndscreen W asH/WIPe (2/2)
Windscreen washer,
headlight washers
With the ignition on, pull stalk 1 towards
you.
– Headlights off
The windscreen washer will be acti-
vated.
– Headlights on
The headlight washers will be acti -
vated at the same time.
1
a
Before washing the vehicle,
bring the stalk to position A
(park) to avoid the risk of
damage to the blades when
automatic wiping is activated.Before any action involving
the windscreen (washing
the vehicle, de-icing, clean -
ing the windscreen, etc.)
return stalk 1 to position a (park).
Risk of injury and/or damage.
When working in the engine
compartment, ensure that
the windscreen wiper stalk
is in the park position.
Risk of injury.
In frosty weather, make sure that
the wiper blades are not stuck by ice
(risk of motor overheating).
If the wipers do not work, contact an
approved dealer.
Keep an eye on the condition of the
blades. Replace the wiper blades as
soon as they begin to lose efficiency
(approximately once a year).

wipers ................................................... (up to the end of the DU)
windscreen washer ............................... (up to the end of the DU)
1.73
ENG_UD20356_1
Essuie-vitre/lave-vitre arrière (X81 - J81 - Renault)
ENG_NU_932-3_X81ph3_Renault_1
rear screen W asH/WIPe
Yrear screen wiper with
timer
With the ignition on, turn the end of
stalk 1 to align mark 2 with the symbol.
prear screen wash/wipe
With the ignition on, turn the
end of stalk 1 to align mark 2 with the
symbol.
When the stalk is released, it returns to
the rear screen wiper position.
special note
If the windscreen wipers are opera -
tional when you select reverse gear, the
rear screen is wiped intermittently.
1
2
1
Check the condition of the wiper
blades. You are responsible for their
service life:
– they must remain clean: clean
the blades, windscreen and
rear screen regularly with soapy
water;
– do not use them when the wind-
screen or rear screen are dry;
– free them from the windscreen or
rear screen when they have not
been used for a long time.
In all cases, replace them as soon
as they begin to lose efficiency: ap-
proximately once a year.
Before using the rear wiper, check
that no object obstructs the travel of
the blade.
Do not use the wiper arm to open or
close the tailgate.
In frosty weather, make sure that
the wiper blades are not stuck by ice
(risk of motor overheating).

2.40
ENG_UD24090_2
Boîte automatique (X81 - J81 - Renault)
ENG_NU_932-3_X81ph3_Renault_2
AUTOMATIc GEARBOX (continued)
When setting off, if the lever is locked
in position P even though you are de -
pressing the brake pedal and pressing
unlocking button 2, the lever can be re-
leased manually.
To do this, unclip the upper section of
the gaiter 3.Push unlocking button 2 and button 4
under the gaiter at the same time to
move the lever from position P.
4
2
3
Operating faults
– When driving , if the message
“ Check auto gearbox ” appears on
the instrument panel, this indicates
there is a fault.
Contact your approved Dealer as
soon as possible.
– When driving, if the message “Auto
gearbox overheating” appears on the
instrument panel, stop the vehicle to
allow the gearbox to cool down.
Contact your approved Dealer as
soon as possible.
– If a vehicle with an automatic
gearbox breaks down, refer to the
information on “Towing” in Section 5.

wiper blades .......................................................... (current page)
practical advice ...................................................... (current page)
wipers blades .............................................................. (current page)
5.32
ENG_UD20430_1
Balais d’essuie-vitre (X81 - J81 - Renault)
ENG_NU_932-3_X81ph3_Renault_5
Wipers (replacing blades)
WInDScreen WIPer BLADeS
replacing windscreen wiper
blades 1
– Lift wiper arm 2;
– move blade 1 into a horizontal posi-
tion;
– slide blade 1 until catch 3 on the
wiper arm is released.
refitting
To refit the wiper blade, proceed in the
reverse order to removal. Make sure
that the blade is correctly locked in po-
sition.
Windscreen washer jets
These can be adjusted using a tool
such as a flat-blade screwdriver.
rear screen wiper blade 4
– Lift wiper arm 5 as far as it will go;
– pivot blade 4 until it is removed from
its hinge.
refitting
To refit the wiper blade, clip the blade
onto its hinge. Make sure that the blade
is correctly locked in position.
– In frosty weather, make
sure that the wiper blades
are not stuck by ice (risk of
motor overheating).
– Check the condition of the wiper
blades. Replace the wiper blades
as soon as they begin to lose ef-
ficiency (approximately once a
year).
1
23
4
5

5.40
ENG_UD22228_7
Anomalies de fonctionnement (J81 - X84 - B84 - C84 - L84 - K84 - J84 - \
R84 - X91 - B91 - K91 - Renault)
ENG_NU_932-3_X81ph3_Renault_5
Jaune NoirNoir texte
OPerA tInG FAuL tS (4/5)
On the road POSSIBLe cAuSeSWHAt tO DO
Steering becomes heavy. Assistance overheating.Consult an approved dealer.
The engine overheats. The coolant
temperature indicator is in the warn -
ing zone and the
® warning light
comes on. Engine cooling fan not working.
Stop the vehicle, switch off the engine and
contact an approved dealer.
Coolant leaks. Check the coolant reservoir: it should con-
tain fluid. If there is no coolant, consult an
approved dealer as soon as possible.
radiator: If there is a significant lack of coolant, remember that it must never be topped up using cold coolant while
the engine is very warm. After any procedure on the vehicle which has involved even partial draining of the cooling
system, it must be refilled with a new mixture prepared in the correct proportions. Reminder: only products approved
by our Technical Department may be used for this purpose.